National Advisory Committee for Aeronautics (NACA) - 12 Matching Results

Search Results

Shear Lag in a Plywood Sheet-Stringer Combination Used for the Chord Member of a Box Beam

Description: Theoretical and experimental investigations were made of the distribution of strains in a plywood sheet-stringer combination used as the chord member of a box beam acted upon by bending loads. The theoretical solution was obtained with the help of the principle of minimum potential energy and certain simplifying assumptions. Strain measurements were made on a build-up box beam by means of electrical-resistance strain gages connected with strain indicators. A very satisfactory agreement between the theoretical and experimental strains was obtained.
Date: March 1, 1948
Creator: Borsari, Palamede & Yu, Ai-Ting
Partner: UNT Libraries Government Documents Department

Ditching Tests of Two Models of the Army B-36 Airplane

Description: The ditching characteristics of the Army B-36 airplane were determined by testing 1/20- and 1/30-scale dynamic models in calm water in Langley tank no. 2 and at the outdoor catapult. The scope of the tests consisted of ditching the models at various conditions of simulated damage, landing attitudes, and speeds, with various flap settings using several degrees of restraint of the flap hinges. The ditching behavior was evaluated from recordings of deceleration, length of run, and motions of the models. The results showed that the airplane should be ditched at an attitude of about 9 deg with flaps full down. The probable ditching behavior will be a smooth run with a maximum longitudinal deceleration of 3g to 4g and a landing run of 4 to 5 fuselage lengths. Structural failure of the underside of the fuselage will not seriously affect the behavior of the airplane.
Date: March 1, 1948
Creator: Fisher, Lloyd J. & Cederborg, Gibson A.
Partner: UNT Libraries Government Documents Department

Venturi Tube with Varying Mass Flow

Description: Measurements on three tubes with flow regulated by suction at the trainling edge of the tube are described. It was possible to vary the mass of air flowing through the tube over a large range. Such tubes could be used for shrouded propellers.
Date: March 1, 1948
Creator: Regenscheit, B.
Partner: UNT Libraries Government Documents Department