National Advisory Committee for Aeronautics (NACA) - 11 Matching Results

Search Results

Results: 1 - 11
open access

The Airspeed "Oxford" Training Airplane (British): A Two-Engine Cantilever Monoplane

Description: Circular describing the Airspeed A.S. 10 "Oxford", which is a twin-engine trainer with a variety of equipment, including propellers, landing gear, and other components.Details of the wings, fuselage, the inside, characteristics, performance, drawings, and photographs are provided.
Date: September 1937
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Column Strength of Tubes Elastically Restrained Against Rotation at the Ends

Description: Report presents the results of a study made of the effects of known end restraint on commercially available round and streamline tubing of chromium-molybdenum steel, duralumin, stainless steel, and heat-treated chromium-molybdenum steel; and a more accurate method than any previously available, but still a practical method, was developed for designing compression members in riveted or welded structures, particularly aircraft. Two hundred specimens were tested as short, medium-length, and long c… more
Date: September 9, 1937
Creator: Osgood, William R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effect of Curvature on the Transition From Laminar to Turbulent Boundary Layer

Description: Note presenting a discrepancy between the predicted and actual point of transition from laminar to turbulent boundary layer that had been found. This effect may be due to the comparatively small radius of curvature of the upper surface of the wing.
Date: September 1937
Creator: Clauser, Milton & Clauser, Francis
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effect of Curvature on the Transition From Laminar to Turbulent Boundary Layer

Description: "In the flow over the upper surface of a wing, a discrepancy between the predicted and actual point of transition from laminar to turbulent boundary layer was found. This effect may be due to the comparatively small radius of curvature of the upper surface of the wing. Tests were undertaken to investigate this effect. As far as the authors know, the present investigation is the first to show that curvature has a pronounced effect on the transition of the boundary layer from the laminar to the t… more
Date: September 1937
Creator: Clauser, Milton & Clauser, Francis
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Fuselage-drag tests in the variable-density wind tunnel: streamline bodies of revolution, fineness ratio of 5

Description: From Summary: "Results are presented of the drag tests of six bodies of revolution with systematically varying shapes and with a fineness ratio of 5. The forms were derived from source-sink distributions, and formulas are presented for the calculation of the pressure distribution of the forms. The tests were made in the N.A.C.A. variable-density tunnel over a range of values of Reynolds number from about 1,500,000 to 25,000,000. The results show that the bodies with the sharper noses and tails … more
Date: September 1937
Creator: Abbott, Ira H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Interrelation of Exhaust-Gas Constituents

Description: This report presents the results of an investigation conducted to determine the interrelation of the constituents of the exhaust gases of internal-combustion engines and the effect of engine performance on these relations. Six single-cylinder, liquid-cooled tests engines and one 9-cylinder radial air-cooled engine were tested. Various types of combustion chambers were used and the engines were operated at compression ratios from 5.1 to 7.0 using spark ignition and from 13.5 to 15.6 using compre… more
Date: September 7, 1937
Creator: Gerrish, Harold C. & Voss, Fred
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Motion of the Two-Control Airplane in Rectilinear Flight After Initial Disturbances With Introduction of Controls Following an Exponential Law

Description: "An airplane in steady rectilinear flight was assumed to experience an initial disturbance in rolling or yawing velocity. The equations of motion were solved to see if it was possible to hasten recovery of a stable airplane or to secure recovery of an unstable airplane by the application of a single lateral control following an exponential law. The sample computations indicate that, for initial disturbances complex in character, it would be difficult to secure correlation with any type of expon… more
Date: September 1937
Creator: Klemin, Alexander
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Spinning Characteristics of Wings 3: A Rectangular and Tapered Clark Y Monoplane Wing with Rounded Tips

Description: An investigation was made to determine the spinning characteristics of Clark Y monoplane wings with different plan forms. A rectangular wing and a wing tapered 5:2, both with rounded tips, were tested on the N.A.C.A. spinning balance in the 5-foot vertical wind tunnel. The aerodynamic characteristics of the models and a prediction of the angles of sideslip for steady spins are given. Also included is an estimate of the yawning moment that must be furnished by the parts of the airplane to balanc… more
Date: September 1937
Creator: Bamber, M. J. & House, R. O.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Stability of Castering Wheels for Aircraft Landing Gears, Special Report

Description: In many installations of castering rubber-tired wheels there is a tendency for the wheel to oscillate violently about the spindle axis. This phenomenon, popularly called 'shimmy,' has occurred in some airplane tail wheels and has been corrected in two ways: first by the application of friction in the spindles of the tail wheels; and, second, by locking the wheels while taxiing at high speeds. Shimmy is common with the large wheels used as nose wheels in tricycle landing gears and, since it is i… more
Date: September 1937
Creator: Kantrowitz, Arthur
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Strength of Shell Bodies: Theory and Practice

Description: "The monocoque form of airplane construction has introduced a number of new problems to the stress calculator and the designer. The problems for the stress calculator fall into two groups: the determination of the stress condition (shell statics) and the determination of the failing strength (shell strength). The present report summarizes the most important theoretical and experimental results on this subject" (p. 1).
Date: September 1937
Creator: Ebner, H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen