Search Results

Air-consumption parameters for automatic mixture control of aircraft engines
From Introduction: "The purpose of this analysis was to investigate the use of function of intake-manifold temperature and pressure, exhaust back pressure, and engine speed in place of a ventri as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."
Air-Consumption Parameters for Automatic Mixture Control of Aircraft Engines
From Introduction: "The purpose of this analysis was to investigate the use of a function of intake-manifold pressure, exhaust back pressure, intake manifold temperature, and engine speed in place of a venturi as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."
Altitude-wind-tunnel investigation of thrust augmentation of a turbojet engine IV: performance with tail-pipe burning and water injection
From Introduction: "Thrust augmentation of an axial-flow-type turbojet engine by burning fuel in the tail pipe is discussed in references 1 to 3. Thrust augmentation of the same turbojet engine by water injection at the compressor inlet is reported in reference 4."
Altitude-wind-tunnel tests of power-plant installation in jet-propelled fighter
From Introduction: "The research program included clean-up tests (unpublished data) and stability and control tests (reference 1) made in the NACA Langley full-scale tunnel. An investigation of the aerodynamic characteristics of the power-plant installation in the Cleveland altitude wind tunnel is discussed in this report."
Analysis of cooling limitations and effect of engine-cooling improvements on level-flight cruising performance of four-engine heavy bomber
From Introduction: "The difficulties experienced in cooling the exhaust-valve seats of the rear-row cylinders have been overcome to a considerable extent by improving the mixture distribution through application of the injection impeller (reference 1) and by augmenting the flow of cooling air to the critical baffles (reference 2). Flight tests of this airplane (reference 3) indicated that the temperatures of exhaust-valve seats on rear-row cylinders were markedly lowered by these modifications and that airplane range, altitude, and gross weight previously limited by these temperatures could be greatly increased."
Analysis of variation of piston temperature with piston dimensions and undercrown cooling
From Summary: "A theoretical analysis is presented that permits estimation of the changes in piston-temperature distribution induced by variations in the crown thickness, the ring-groove-pad thickness, and the undercrown surface heat-transfer coefficient. The analysis consists of the calculation of operating temperatures at various points in the piston body on the basis of the experimentally determined surface heat-transfer coefficients and boundary-region temperatures, as well as arbitrarily selected surface coefficients."
Analytical Comparison of a Standard Turbojet Engine, a Turbojet Engine with a Tail-Pipe Burner, and a Ram-Jet Engine
From Introduction: "Experimental investigations (reference 1) have shown that in some cases the thrust can be more than doubled by means of tail-pipe burning. A comparison is made of a standard turbojet engine, whose thrust is augmented by tail-pipe burning, and a ram-jet engine. The performance characteristics for the ram-jet engine were computed entirely from theoretical considerations and on the assumption that the burner-inlet velocity was constant."
Antiknock Effectiveness of Xylidines in Small-Scale Engines
"The data presented in this report are part of a general program to determine the effects of xylidines on the knock-limited performance of currently used aviation fuels" (p. 2).
Apparent Effect of Inlet Temperature on Adiabatic Efficiency of Centrifugal Compressors
From Introduction: "The results of varying only Reynolds number for several equivalent tip speeds are presented and probable reasons for the apparent variation of adiabatic efficiency with inlet temperature are discussed."
The appearance of a boric oxide exhaust cloud from a turbojet engine operating on trimethylborate fuel
From Summary: "Data are included on the amount of fallout from the cloud and the concentration of boric oxide in the cloud."
Back to Top of Screen