Lathes Page: 60
The following text was automatically extracted from the image on this page using optical character recognition software:
36-37 AIR CORPS
c. When drilling in the lathe, the correct speed usually seems too
fast, due to the fact that the chuck, being so much larger than the
drill, influences the operator's judgment. It is therefore advisable to
refer to a suitable table to obtain the proper speed at which various
materials may be drilled.
d. It is absolutely necessary to have the head and tailstock in
proper alinement during all drilling and reaming operations to pro-
duce a true hole and prevent drill or reamer breakage.
FIGURE 54.-Drilling work held on pad center.
37. Reaming.-a. Reamers are used to finish a number of holes
quickly and accurately to the same diameter. Machine reamers are
frequently used in the lathe and may be held in the same manner as
drills. A typical application of the machine reamers is illustrated in
(1) Machine reamer speeds are approximately one-half that used
(2) When a hole is to be machine reamed, it is drilled or bored
to within 0.005 inch or 0.010 inch of the finished size so that it will
only be necessary for the reamer to remove the tool marks.
Here’s what’s next.
This book can be searched. Note: Results may vary based on the legibility of text within the document.
Tools / Downloads
Get a copy of this page or view the extracted text.
Citing and Sharing
Basic information for referencing this web page. We also provide extended guidance on usage rights, references, copying or embedding.
Reference the current page of this Book.
United States. Army. Air Corps. Lathes, book, November 29, 1940; Washington, D.C.. (digital.library.unt.edu/ark:/67531/metadc96655/m1/62/: accessed October 16, 2017), University of North Texas Libraries, Digital Library, digital.library.unt.edu; crediting UNT Libraries Government Documents Department.