Lathes Page: 56
The following text was automatically extracted from the image on this page using optical character recognition software:
35-36 AIR CORPS
held in the lathe headstock. In fastening the wire, one chuck jaw is
loosened and the wire placed between the chuck jaw and the man-
drel. It is good practice to support the outer end of the mandrel
with the tailstock center to prevent distortion. The wire is placed
in a lathe boring tool holder, together with a piece of brass, having
a notch filed in it and tightened just enough to prevent slippage.
Tension or compression springs of different pitches may be wound
in this manner by selectively gearing the longitudinal carriage feed.
(See fig. 51.)
FICutE 1.--Spring winding on lathe.
DRILLING, REAMING, AND BORING
Drilling- --- 36
Renaming ..______ __ __ _ _ 37
Boring ._ ..- -.- --.. . . . 38
36. Drilling.-a. Drilling is ordinarily done in the lathe by hold-
ing and revolving the work in the lathe chuck, with the drill suit-
ably held in the tailstock and fed by means of the tailstock hand
Here’s what’s next.
This book can be searched. Note: Results may vary based on the legibility of text within the document.
Citing and Sharing
Basic information for referencing this web page. We also provide extended guidance on usage rights, references, copying or embedding.
Reference the current page of this Book.
United States. Army. Air Corps. Lathes, book, November 29, 1940; Washington, D.C.. (digital.library.unt.edu/ark:/67531/metadc96655/m1/58/: accessed April 25, 2017), University of North Texas Libraries, Digital Library, digital.library.unt.edu; crediting UNT Libraries Government Documents Department.