Lathes Page: 47
The following text was automatically extracted from the image on this page using optical character recognition software:
(4) Engage cross slide power feed and allow it to carry tool away
FIGURE 43.-Protecting work from lathe dog and set screw.
FIGUREn 44.-Shoulder turning in lathe.
29. Taper turning.-a. Tapers may be turned on the lathe either
by feeding at an angle with the compound rest, by setting over the
tailstock center, or by means of the taper attachment. When turn-
ing tapers, the tool bit must be set at the height of the center at all
Here’s what’s next.
This book can be searched. Note: Results may vary based on the legibility of text within the document.
Citing and Sharing
Basic information for referencing this web page. We also provide extended guidance on usage rights, references, copying or embedding.
Reference the current page of this Book.
United States. Army. Air Corps. Lathes, book, November 29, 1940; Washington, D.C.. (digital.library.unt.edu/ark:/67531/metadc96655/m1/49/: accessed May 27, 2017), University of North Texas Libraries, Digital Library, digital.library.unt.edu; crediting UNT Libraries Government Documents Department.