Lathes Page: 10
The following text was automatically extracted from the image on this page using optical character recognition software:
b. The cutting-o;ff tool holder (fig. 5) is made either offset or straight
It is shaped to hold flat, thin-sectioned tool bits and is used to separate
pieces in the lathe.
c. The boring tool holders (fig. 6) are standardized commercial
types. Boring tool holders can be locally manufactured by slotting the
ends of rods and brazing high speed tool bits in these slots. Another
FIUiRE 6.- Boring tool holders.
Here’s what’s next.
This book can be searched. Note: Results may vary based on the legibility of text within the document.
Citing and Sharing
Basic information for referencing this web page. We also provide extended guidance on usage rights, references, copying or embedding.
Reference the current page of this Book.
United States. Army. Air Corps. Lathes, book, November 29, 1940; Washington, D.C.. (digital.library.unt.edu/ark:/67531/metadc96655/m1/12/: accessed February 21, 2017), University of North Texas Libraries, Digital Library, digital.library.unt.edu; crediting UNT Libraries Government Documents Department.