UNT Libraries Government Documents Department - 122 Matching Results

Search Results

open access

A Flight Comparison of Conventional Ailerons on a Rectangular Wing and of Conventional and Floating Wing-Tip Ailerons on a Tapered Wing

Description: Report presents the results of flight tests comparing the relative effectiveness of conventional ailerons of the same size on wings of rectangular and tapered plan forms made with a Fairchild 22 airplane. Information is included comparing conventional and floating wing-tip ailerons on a tapered wing. The results showed that the conventional ailerons were somewhat more effective on the tapered than on the rectangular wing. The difference, however, was so small as to be imperceptible to the pilot… more
Date: October 27, 1937
Creator: Soulé, H. A. & Gracey, W.
open access

Flight tests of an airplane showing dependence of the maximum lift coefficient on the test conditions

Description: "Data are presented to show the extent to which the maximum lift coefficient and consequently the minimum speed of an airplane, determined by flight tests, may vary with test conditions. The data show that cl-max may vary as much as 14 percent, depending on the altitude and wing loading at which the tests were made, the position or motion of the propeller, and the rate at which the angle of attack is changing when the maximum lift coefficient is obtained. The variation of the maximum lift coeff… more
Date: November 1937
Creator: Soulé, H. A. & Hootman, James A.
open access

Free spinning wind-tunnel tests of a low-wing monoplane with systematic wings and tails 2: Mass distributed along the fuselage

Description: Report presenting a study of eight wings and three tails covering a wide range of aerodynamic characteristics in 24 wing-tail combinations. Observations were made of the steady spin for four control settings and of recoveries for five control manipulations. The effect of wing shape, tail arrangement, control settings, relationships between spin characteristics, and comparison with results for basic loading are provided.
Date: December 1937
Creator: Seidman, Oscar & Neihouse, A. I.
open access

Free-spinning wind-tunnel tests of a low-wing monoplane with systemic changes in wings and tails 1: Basic loading condition

Description: A series of tests was made at the National Advisory Committee for Aeronautics (NACA) free-spinning tunnel to determine the effect of systematic changes in wing and tail arrangement upon steady-spinning and recovery characteristics of a conventional low-wing monoplane model for a basic loading condition. Eight wings and three tails, covering a wide range of aerodynamic characteristics, were independently ballasted so as to be interchangeable with no change in mass distribution. For each of the 2… more
Date: August 1937
Creator: Seidman, Oscar & Neihouse, A. I.
open access

Full scale span load distribution on a tapered wing with split flaps of various spans

Description: Pressure-distribution tests were conducted in the full-scale wind tunnel on a 2:1 tapered U.S.A. 45 airfoil equipped with 20 percent chord split trailing-edge flaps of various spans. A special installation was employed in the tests utilizing a half-span airfoil mounted vertically above a reflection plane. The airfoil has a constant chord center section and rounded tips and is tapered in thickness from 18 percent c at the root to 9 percent c at the tip. The aerodynamic characteristics, given by … more
Date: February 1937
Creator: Parsons, John F. & Silverstein, Abe
open access

Full-Scale Tests of a New Type NACA Nose-Slot Cowling

Description: "An extended experimental study has been made in regard to the various refinements in the design of engine cowlings as related to the propeller-nacelle unit as a whole, under conditions corresponding to take-off, climb, and normal flight. The tests were all conducted at full scale in the 20-foot wind tunnel. This report presents the results of a novel type of engine cowling, characterized by the fact that the exit opening discharging the cooling air is not, as usual, located behind the engine b… more
Date: 1937
Creator: Theodorsen, Theodore; Brevoort, M. J.; Stickle, George W. & Gough, M. N.
open access

Full-scale wind-tunnel and flight test of a Fairchild 22 airplane equipped with a Zap flap and Zap ailerons

Description: "A wing equipped with a Zap flap and Zap ailerons was tested on a Fairchild 22 airplane in the full-scale wind tunnel and in flight to determine the effect of the flaps and ailerons on the performance and the control characteristics of the airplane. The flaps were 0.30 of the wing chord and 0.83 of the wing span. Two sets of ailerons having equal areas but different proportions were tested, one set being 0.56 of the semispan and 0.18 of the chord and the other set being 0.46 of the semispan and… more
Date: March 1937
Creator: Dearborn, C. H. & Soulé, H. A.
open access

Full-Scale Wind-Tunnel and Flight Tests of a Fairchild 22 Airplane Equipped With External-Airfoil Flaps

Description: "Wind-tunnel and flight tests have been made of a Fairchild 22 airplane equipped with a wing having external-airfoil flaps that also perform the function of ailerons. Lift, drag, and pitching-moment coefficients of the airplane with several flap settings, and the rolling- and yawing-moment coefficients with the flaps deflected as ailerons were measured in the full-scale tunnel with the horizontal tail surfaces and propeller removed. The effect of the flaps on the low speed and on the take-off a… more
Date: July 1937
Creator: Reed, Warren D. & Clay, William C.
open access

Fuselage-drag tests in the variable-density wind tunnel: streamline bodies of revolution, fineness ratio of 5

Description: From Summary: "Results are presented of the drag tests of six bodies of revolution with systematically varying shapes and with a fineness ratio of 5. The forms were derived from source-sink distributions, and formulas are presented for the calculation of the pressure distribution of the forms. The tests were made in the N.A.C.A. variable-density tunnel over a range of values of Reynolds number from about 1,500,000 to 25,000,000. The results show that the bodies with the sharper noses and tails … more
Date: September 1937
Creator: Abbott, Ira H.
open access

General Airplane Performance

Description: "Equations have been developed for the analysis of the performance of the ideal airplane, leading to an approximate physical interpretation of the performance problem. The basic sea-level airplane parameters have been generalized to altitude parameters and a new parameter has been introduced and physically interpreted. The performance analysis for actual airplanes has been obtained in terms of the equivalent ideal airplane in order that the charts developed for use in practical calculations wil… more
Date: June 1, 1937
Creator: Rockfeller, W. C.
open access

The Ground Effect on Lifting Propellers

Description: In what follows an estimate will be made of the magnitude of the ground effect. For the two cases where the distance a of the propeller from the ground is very small, and very large, respectively, in comparison with the propeller radius r(sub o) the relations may be simply expressed. We consider first the effect of the ground, assuming that the thrust is held constant, as may be done by a suitable change in the propeller speed.
Date: August 1937
Creator: Betz, A.
open access

Ground Effect - Theory and Practice

Description: The conclusion of a previous article by Pistolesi is that the increment of lift due to ground effect is largely attributable to the effect of induction of the free vortices, and is practically equivalent to a virtual increase in aspect ratio. The ground clearance was of the order of magnitude comparable to the wing chord. New reports by Le Seur and Datwyler treat the case of minimum distance from the ground and is confined to the plane problem only. The author briefly reviews these reports and … more
Date: June 1937
Creator: Pistolesi, E.
open access

The Gyroplane: Its Principles and Its Possibilities

Description: This report begins by indicating several simple principles concerning the velocity distribution over the blades of a lifting propeller of diameter D, revolving at n revolutions per second, and animated by a horizontal movement of translation at speed V. The calculation, compared with the test data, has shown that the aerodynamic action of the air on the blades depends almost only on the velocity components in a plane at right angles to the blade span. A history of gyroplane and gyrocopter devel… more
Date: January 1937
Creator: Breguet, Louis
open access

Heat transfer from cylinders having closely spaced fins

Description: The heat-transfer coefficients have been determined for five steel cylinders having fins 1.22 inches wide and the spacing between the fins ranging from 0.022 to 0.131 inch. The cylinders were tested with and without baffles in a wind tunnel; they were also tested enclosed in jackets with the cooling air supplied by a blower. A maximum heat transfer was reached at a fin space of about 0.45 inch for the cylinders tested with each of the three methods of cooling investigated. The rise in temperatu… more
Date: May 1937
Creator: Biermann, Arnold E.
open access

Helicopter Problems

Description: The present report deals with a number of the main problems requiring solution in the development of helicopters and concerning the lift, flying performance, stability, and drive. A complete solution is given for the stability of the helicopter with rigid blades and control surfaces. With a view to making a direct-lift propeller sufficient without the addition of auxiliary propellers, the "flapping drive" is assessed and its efficiency calculated.
Date: May 1937
Creator: Küssner, H. G.
open access

Hydrodynamic tests in the N.A.C.A. tank of a model of the hull of the Short Calcutta flying boat

Description: "The hydrodynamic characteristics of a model of the hull of the Short Calcutta (N.A.C.A. Model 47) are presented in non-dimensional form. This model represents one of a series of hulls of successful foreign and domestic flying boats the characteristics of which are being obtained under similar test conditions in the N.A.C.A. tank. The take-off distance and time for a flying boat having the hull of the Calcutta are compared at two values of the gross load with the corresponding distances and tim… more
Date: January 1937
Creator: Ward, Kenneth E.
open access

Increasing the Strength of Aluminum-Alloy Columns by Prestressing

Description: A series of tests was made in which the column strength of 17ST tubing was increased as much as 50 percent by prestressing the tubing to 40,000 pounds per square inch in compression under conditions of support that prevented column failure at this stress. This prestressing achieves it's beneficial effects entirely by improving the compressive properties of the material, principally the proportional limit.
Date: October 1937
Creator: Holt, M. & Hartman, E. C.
open access

Interrelation of Exhaust-Gas Constituents

Description: This report presents the results of an investigation conducted to determine the interrelation of the constituents of the exhaust gases of internal-combustion engines and the effect of engine performance on these relations. Six single-cylinder, liquid-cooled tests engines and one 9-cylinder radial air-cooled engine were tested. Various types of combustion chambers were used and the engines were operated at compression ratios from 5.1 to 7.0 using spark ignition and from 13.5 to 15.6 using compre… more
Date: September 7, 1937
Creator: Gerrish, Harold C. & Voss, Fred
open access

The lateral instability of deep rectangular beams

Description: "Experimental and analytical studies were made of solid and hollow deep rectangular beams to study their lateral instability under various conditions of loading and restraint. The tests were made on bars and tubes of 17ST aluminum alloy. Failure by lateral buckling occurred only in tests on the solid beams. It was found that, within the elastic range, the test results were in agreement with the classical theory for the lateral buckling of deep beams as given by Prandtl, Mitchell, and Timoshenko… more
Date: May 1937
Creator: Dumont, C. & Hill, H. N.
open access

Maximum Forces Applied by Pilots to Wheel-Type Controls

Description: "Measurements were made of the maximum push, pull, and tangential forces that could be applied to airplane wheel-type controls for a wide range of fore-and-aft positions of the wheel. The measurements were conducted with several sizes of wheels and several heights of the center of the wheel above the seat. Various one and two-hand grips with pilots both secure and free were studied for each of the two pilots used in the investigation" (p. 1).
Date: November 1937
Creator: McAvoy, William H.
open access

The measurement of air speed in airplanes

Description: Various methods of measuring the air speed of airplanes are described. Particular emphasis is placed on the procedure required to obtain precise measurements of speed by the use of the suspended Pitot-static head or the suspended static head. Typical calibration curves for service installations of Pitot-static heads are shown and the relation between errors in air speed and corresponding errors in observed altitude for such installations is discussed. There is included a brief discussion of var… more
Date: October 1937
Creator: Thompson, F. L.
open access

Measurements of Intensity and Scale of Wind-Tunnel Turbulence and Their Relation to the Critical Reynolds Number of Spheres

Description: The investigation of wind-tunnel turbulence, conducted at the National Bureau of Standards with the cooperation of the National Advisory Committee for Aeronautics, has been extended to include a new variable, namely, the scale of the turbulence. This report presents the results of a study of this new variable together with the intensity of the turbulence, and the effect of both on the critical Reynolds number of spheres.
Date: 1937
Creator: Dryden, Hugh L.; Schubauer, G. B.; Mock, W. C., Jr. & Skramstad, H. K.
open access

Method of Curved Models and Its Application to the Study of Curvilinear Flight of Airships: Part 1

Description: In the first part of this paper we shall present the theoretical side of the problem of constructing curved model forms and the method of testing the model. In the second part we shall present a detailed account of the first experiments according to the given method, carried out with a curved model of the nonrigid airship V-2, and a comparison of the experimental results with some data of full-scale tests made with this airship in 1933.
Date: June 1937
Creator: Gourjienko, G. A.
Back to Top of Screen