UNT Libraries Government Documents Department - 5,157 Matching Results

Search Results

prev Results: 25 - 48 next
open access

Additional Results in a Free-Flight Investigation of Control Effectiveness of Full-Span, 0.2-Chord Plain Ailerons at High Subsonic, Transonic, and Supersonic Speeds to Determine Some Effects of Wing Sweepback, Aspect Ratio, Taper, and Section Thickness Ratio

Description: Report discussing an aerodynamic control effectiveness study using free-flight, rocket-propelled test vehicles. Information about the effects of wing sweepback, aspect ratio, taper ratio, and section thickness ratio on the rolling effectiveness of full-span, sealed ailerons is provided.
Date: April 23, 1948
Creator: Sandahl, Carl A. & Strass, H. Kurt
Item Type: Refine your search to only Report
open access

Additional results of an investigation at transonic speeds to determine the effects of a heated propulsive jet on the drag characteristics of a series of related afterbodies

Description: From Introduction: "Presented in this report are the basic data obtained from investigation. The data are presented with limited analysis in order to expedite their availability to those concerned with jet-exit-afterbody design."
Date: September 24, 1956
Creator: Henry, Beverly Z., Jr. & Cahn, Maurice S.
Item Type: Refine your search to only Report
open access

Additional Results on the Static Longitudinal and Lateral Stability Characteristics of a 0.05-Scale Model of the Convair F2Y-1 Airplane at High Subsonic Speeds

Description: "Additional results on the static longitudinal and lateral stability characteristics of a 0.05-scale model of the Convair F2Y-1 water-based fighter airplane were obtained in the Langley high-speed 7- by 10-foot tunnel over a Mach number range of 0.50 to 0.92. The maximum angle-of-attack range (obtained at the lower Mach numbers) was from -2 degrees to 25 degrees. The sideslip-angle range investigated was from -4 degrees to 12 degrees" (p. 1).
Date: August 10, 1954
Creator: Spreeman, Kenneth P. & Few, Albert G., Jr.
Item Type: Refine your search to only Report
open access

Additional Studies of the Stability and Controllability of an Unswept-Wing Vertically Rising Airplane Model in Hovering Flight Including Studies of Various Tethered Landing Techniques

Description: Report discussing the results of an investigation to determine the stability and control characteristics of a flying model of an unswept-wing vertically rising airplane. Information about stabilization, maneuverability, rolling motions, and landings is provided.
Date: November 6, 1951
Creator: Bates, William R.; Lovell, Powell M., Jr. & Smith, Charles C., Jr.
Item Type: Refine your search to only Report
open access

Adhesive and protective characteristics of ceramic coating A-417 and its effect on engine life of forged Refractaloy-26 (AMS 5760) and cast stellite 21 (AMS 5385) turbine blades

Description: The adhesive and protective characteristics of National Bureau of Standards Coating A-417 were investigated, as well as the effect of the coating on the life of forged Refractaloy 26 and cast Stellite 21 turbine blades. Coated and uncoated blades were run in a full-scale J33-9 engine and were subjected to simulated service operations consisting of consecutive 20-minute cycles (15 min at rated speed and approximately 5 min at idle). The ceramic coating adhered well to Refractaloy 26 and Stellite… more
Date: February 12, 1953
Creator: Garrett, Floyd B. & Gyorgak, Charles A.
Item Type: Refine your search to only Report
open access

Aerodynamic and hydrodynamic characteristics of a deck-inlet multijet water-based-aircraft configuration designed for supersonic flight

Description: From Introduction: "In the present investigation, lift, drag, and pitching moment were determined over a Mach number range 0.6 to 1.42. Smooth-water takeoff and landing stability and resistance were investigated. A brief check of the rough-water spray and behavior was also made."
Date: December 5, 1956
Creator: Bielat, Ralph P.; Coffee, Claude W., Jr. & Petynia, William W.
Item Type: Refine your search to only Report
open access

Aerodynamic and hydrodynamic characteristics of a proposed supersonic multijet water-based hydro-ski aircraft with a variable-incidence wing

Description: From Introduction: "The configuration described in this paper represents one approach to such an airplane and the results of the wind-tunnel and tank evaluations are presented. In the present investigation, the aerodynamic longitudinal characteristics over a Mach number range from 0.6 to 1.97 were obtained."
Date: October 23, 1957
Creator: Petynia, William W.; Hasson, Dennis F. & Spooner, Stanley H.
Item Type: Refine your search to only Report
open access

Aerodynamic and hydrodynamic characteristics of models of some aircraft-towed mine-sweeping devices : TED No. NACA AR 8201

Description: This report details a study that was conducted by the U.S. Naval Air Development Center to "determine the feasibility of several airborne magnetic mine-sweeping methods. The advantages of a satisfactory airborne method are greater safety and speed than are possible with existing surface methods." The configurations and results of the double Q-sweep, the modified double-catenary sweep, and the M-sweep are examined.
Date: December 1, 1955
Creator: Shanks, Robert E.
Item Type: Refine your search to only Report
open access

Aerodynamic and inlet-flow-field characteristics at a free-stream Mach number of 3.0 for airplanes with circular fuselage cross sections and for two engine locations

Description: Report presenting an experimental investigation of several airplane configurations at Mach 3.0 in a continuous flow tunnel. The configurations had circular fuselage cross sections and a sweptback wing and either two nacelles or two side inlets.
Date: March 18, 1958
Creator: Dryer, Murray & Luidens, Roger W.
Item Type: Refine your search to only Report
open access

Aerodynamic and Lateral-Control Characteristics of a 1/28-Scale Model of the Bell X-1 Airplane Wing-Fuselage Combination: Transonic-Bump Method

Description: Report discussing an investigation into the lateral-control characteristics and the pitching-moment characteristics of a scale model of the X-1 wing-fuselage configuration. Information about the estimated variation of rolling effectiveness and wing-fuselage pitching-moment coefficient is described in detail.
Date: May 5, 1950
Creator: Lockwood, Vernard E.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics and pressure distributions of a 6-percent-thick 49 degree sweptback wing with blowing over half-span and full-span flaps

Description: From Introduction: "The investigation reported herein was initiated to define further the effects on the aerodynamic characteristics and load distribution of a thin, sweptback wing of a low-pressure blowing system and also to provide information on which to base a more thorough study of a complete airplane configuration."
Date: September 20, 1955
Creator: Whittle, Edward F., Jr. & McLemore, H. Clyde
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics at a Mach Number of 1.25 of a 6-Percent-Thick Triangular Wing and 6- and 9-Percent-Thick Triangular Wings in Combination With a Fuselage: Wing Aspect Ratio 2.31, Biconvex Airfoil Sections

Description: Report discussing testing to determine the aerodynamic characteristics of two semispan delta-wing configurations. Information about the lift characteristics, drag characteristics, pitching-moment characteristics, and comparison with other results is provided.
Date: May 5, 1950
Creator: Hall, Albert W. & Morris, Garland J.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics at a Mach Number of 1.38 of Four Wings of Aspect Ratio 4 Having Quarter-Chord Sweep Angles of 0 Degrees, 35 Degrees, 45 Degrees, and 60 Degrees

Description: Report discussing testing to determine the supersonic aerodynamic characteristics of four sweptback wings and wing-body configurations at several angles. Information about basic wing data, modifications to the 60 degree wing, the effects of sweep, and effects of fuselage are included.
Date: October 10, 1950
Creator: Kemp, William B., Jr.; Goodson, Kenneth W. & Booth, Robert A.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics at a Mach Number of 6.8 of Two Hypersonic Missile Configurations, One With Low-Aspect-Ratio Cruciform Fins and Trailing-Edge Flaps and One With a Flared Afterbody and All-Movable Controls

Description: Report presenting an investigation to determine the aerodynamic characteristics in pitch at a Mach number of 6.8 of hypersonic missile configurations with cruciform trailing-edge flaps and all-movable control surfaces. Testing indicated that all-movable controls on the flared-afterbody model should be capable of producing much larger values of trim lift and of normal acceleration than the trailing-edge-flap configuration. Some of the configurations tested include body alone, body with 5 degree … more
Date: August 4, 1958
Creator: Robinson, Ross B. & Bernot, Peter T.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics at a Mach Number of 6.8 of Two Hypersonic Missile Configurations, One With Low-Aspect-Ratio Cruciform Fins and Trailing-Edge Flaps and One With a Flared Afterbody and All-Movable Controls

Description: Report discussing an investigation to determine the aerodynamic characteristics of hypersonic missile configurations with cruciform trailing-edge flaps with all-movable control surfaces. The all-movable controls were found to produce much larger values of trim lift and normal acceleration than the trailing-edge-flap configuration.
Date: August 4, 1958
Creator: Robinson, Ross B. & Bernot, Peter T.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics at high and low subsonic Mach numbers of four NACA 6-series airfoil sections at angles of attack from -2 to 31 degrees

Description: From Introduction: "The airfoil sections tested, which differ only in thickness ratio, were the NACA 64-006, 64-008, 64-010, and 641-012. Lift, drag, and pitching-moment data were obtained for Mach numbers of 0.3 to that for tunnel choke at angles of attack of -2^o to 31^o. The results of this investigation are reported herein."
Date: June 5, 1953
Creator: Wilson, Homer B., Jr. & Horton, Elmer A.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics at High and Low Subsonic Mach Numbers of the NACA 0012, 64₂-015, and 64₃-018 Airfoil Sections at Angles of Attack from -2 Degrees to 30 Degrees

Description: An investigation has been made in the Langley low-turbulence pressure tunnel of the aerodynamic characteristics of the NACA 0012, 64(sub 2)-015, and 64(sub 3)-018 airfoil sections. Data were obtained at Mach numbers from 0.3 to that for tunnel choke, at angles of attack from -2deg to 30deg, and with the surface. of each airfoil smooth-and with roughness applied at the leading edge.The Reynolds numbers of the tests ranged from 0.8 x 10(exp 6) to 4.4 x 10(exp 6). The results are presented as vari… more
Date: July 23, 1954
Creator: Critzos, Chris C.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics at high speeds of a two-blade NACA 10-(3)(062)-045 propeller and of a two-blade NACA 10-(3)(08)-045 propeller

Description: From Introduction: "The aerodynamic characteristics of a series of 10-foot-diameter propellers are being investigated in the Langley 16-foot high-speed tunnel in a comprehensive propeller research program. Using high-critical-speed NACA 16-series airfoil sections (reference 1), these propellers are designed to have Betz minimum induced-energy loss loading (reference 2) for a blade angle of 45^o at the 0.7 radius, when used as a four-blade propeller operating at an advance ratio of approximately… more
Date: October 1, 1948
Creator: Solomon, William
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics at high speeds of full-scale propellers having Clark Y blade sections

Description: From Introduction: "The single purpose of this paper is to make available the data obtained from tests of these two Clark Y section propellers as quickly as possible with no attempt being made to analyze the results or to compare them with other high-speed-propeller test results."
Date: October 26, 1948
Creator: Johnson, Peter J.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics at High Speeds of Full-Scale Propellers Having Different Shank Designs

Description: "Tests of two 10-foot-diameter two-blade propellers which differed only in shank design have been made in the Langley 16-foot high-speed tunnel. The propellers are designated by their blade design numbers, NACA 10-(5)(08)-03, which had aerodynamically efficient airfoil shank sections, and NACA 10-(5)(08)-03R which had thick cylindrical shank sections typical of conventional blades. The propellers mere tested on a 2000-horsepower dynamometer through a range of blade-angles from 20 degrees to 55 … more
Date: February 13, 1947
Creator: Maynard, Julian D.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics at Mach number of 2.01 of two cruciform missile configurations having 70 degree delta wings with length-diameter ratios of 14.8 and 17.7 with several canard controls

Description: From Introduction: "The present paper contains the results of the investigation of the aerodynamic characteristics at Mach number of 2.01 of the two cruciform wing missiles equipped with larger canard controls and compares the result with that obtained previously with a smaller control."
Date: August 30, 1954
Creator: Spearman, M. Leroy & Robinson, Ross B.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics at Mach number of 4.06 of a typical supersonic airplane model using body and vertical-tail wedges to improve directional stability

Description: Report presenting an investigation at Mach number 4.06 on a typical supersonic airplane model with a 40 degree sweptback wing. The purpose of the investigation was to determine the effectiveness of using wedges on the body and on the vertical tail to increase the static directional stability. Results regarding the longitudinal characteristics and lateral characteristics are provided.
Date: December 3, 1957
Creator: Dunning, Robert W.
Item Type: Refine your search to only Report
Back to Top of Screen