UNT Libraries Government Documents Department - 1,263 Matching Results

Search Results

prev Results: 31 - 54 next
open access

Air-Flow and Performance Characteristics of Engine-Stage Supercharger of a Double-Row Radial Aircraft Engine 2: Effect of Design Variables

Description: Report presenting an investigation to determine the effect of the location of the diffuser vanes with respect to the supercharger outlets and the effect of flow conditions at the impeller inlet on the air-flow distribution in the outlets of the engine-stage supercharger of an 18-cylinder double-row radial aircraft engine. The effect of flow conditions at the impeller inlet was investigated by distorting the flow at the inlet and noting the effect in the supercharger outlets. Results regarding t… more
Date: August 1946
Creator: Baas, Edmund J. & Dugan, Paul D.
Item Type: Refine your search to only Report
open access

Airfoil-Contour Modifications Based on (Epsilon)-Curve Method of Calculating Pressure Distribution

Description: From Introduction: "Certain alternations of a qualitative nature may be performed in spite of the fact that a pressure change cannot be prescribed. It is the purpose of this paper to indicate a method by which qualitative alternation may be performed. It will be noted that the present method of contour modification will serve the intended purpose of the inverse method."
Date: July 1944
Creator: Theodorsen, Theodore
Item Type: Refine your search to only Report
open access

Airfoil Section Data From Tests of 10 Practical-Construction Sections of Helicopter Rotor Blades Submitted by the Sikorsky Aircraft Division, United Aircraft Corporation

Description: Report presenting 10 practical-construction models of sections of helicopter rotor blades tested in the NACA two-dimensional low-turbulence pressure tunnel at atmospheric pressure. Lift, drag, and pitching-moment characteristics of blades representing the present method of construction of the YR-4A helicopter were determined.
Date: September 1944
Creator: Tetervin, Neal
Item Type: Refine your search to only Report
open access

Airspeed Fluctuations as a Measure of Atmospheric Turbulence

Description: "Increments in structural loads due to atmospheric turbulence can be accurately expressed in terms of flight speed and effective gust velocities (reference 4). Data from which the effective gust velocities could be computed were also obtained during the flights of the XC-35 airplane. These data have been used to determine the significance of the fluctuations in the pilot's indicated-airspeed readings in relation to structural loads to due to atmospheric turbulence" (p. 3).
Date: July 1945
Creator: Tolefson, H. B.
Item Type: Refine your search to only Report
open access

Altitude Rating of Electrical Apparatus

Description: "This paper studies the effect of altitude on the ratings of rotating electric machines and after determining the fundamental principles involved, discusses these in relation to the application of such machines in modern aircraft" (p. 1).
Date: January 1943
Creator: Lebenbaum, Paul, Jr.
Item Type: Refine your search to only Report
open access

Altitude-wind-tunnel tests of power-plant installation in jet-propelled fighter

Description: From Introduction: "The research program included clean-up tests (unpublished data) and stability and control tests (reference 1) made in the NACA Langley full-scale tunnel. An investigation of the aerodynamic characteristics of the power-plant installation in the Cleveland altitude wind tunnel is discussed in this report."
Date: February 1946
Creator: Preston, G. Merritt; Black, Fred O., Jr. & Jagger, James M.
Item Type: Refine your search to only Report
open access

Aluminum-Zinc-Magnesium-Copper Casting Alloys

Description: From Introduction: "This paper contains data on the mechanical properties of sand-cast test bars having a considerable range in zinc, magnesium, and copper content and more detailed data on the properties and foundry characteristics of an aluminum-zinc-magnesium-copper alloy having a preferred composition for high strength and ductility."
Date: July 1941
Creator: Kempf, L. W.
Item Type: Refine your search to only Report
open access

Analysis and Correlation of Data Obtained by Six Laboratories on Fuel-Vapor Loss From Fuel Tanks During Simulated Flight

Description: Report presenting an analysis of data on fuel-vapor loss from fuel tanks during simulated flight obtained by six laboratories to show the effects of individual variables such as altitude, initial fuel temperature, rate of climb, booster-pump agitation, fuel depth, fuel-surface area, types of fuel, and vent-line pressure drop on fuel-vapor loss.
Date: December 1944
Creator: Stone, Charles S.; Baker, Sol & Englert, Gerald W.
Item Type: Refine your search to only Report
open access

Analysis of a thermal ice-prevention system for wing leading-edge landing-light installations

Description: From Introduction: "A typical ice formation on a wing leading-edge-type light installation is shown in figure 1. Although the primary purpose of this analytic investigation was to determine the practicability of providing a landing-light thermal ice-prevention system which could be incorporated with the wing leading-edge thermal ice-prevention system of the B-17 F airplane, the analysis has been developed in a general form for future application to similar deigns. "
Date: January 1944
Creator: Hillendahl, Wesley H.
Item Type: Refine your search to only Report
open access

Analysis of Effect of Rolling Pull-Outs on Wing and Aileron Loads of a Fighter Airplane

Description: An analysis was made to determine the effect of rolling pull-out maneuvers on the wing and aileron loads of a typical fighter airplane, the P-47B. The results obtained indicate that higher loads are imposed upon wings and ailerons because of the rolling pull-out maneuver, than would be obtained by application of the loading requirements to which the airplane was designed. An increase of 102 lb or 15 percent of wing weight would be required if the wing were designed for rolling pull-out maneuver… more
Date: March 1946
Creator: Pearson, Henry A. & Aiken, William S., Jr.
Item Type: Refine your search to only Report
open access

Analysis of factors affecting net lift increment attainable with trailing-edge split flaps on tailless airplanes

Description: From Introduction: "The lift increments of different flap arrangements were determined by the method of reference 1 with a simple chord correction factor being applied. This procedure is somewhat similar in basic principles to the method of reference 2. The accuracy of the present method was determined by calculating by means of this method the lift and moment increments of flaps on 10 different finite wing-flap combinations for which wind-tunnel data were available."
Date: September 1944
Creator: Maggin, Bernard
Item Type: Refine your search to only Report
open access

Analysis of Heat and Compressibility Effects in Internal Flow Systems and High-Speed Tests of a Ram-Jet System

Description: Report presenting an analysis of the effects of heat and compressibility in the flow through the internal systems of aircraft. Equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.
Date: September 1942
Creator: Becker, John V. & Baals, Donald D.
Item Type: Refine your search to only Report
open access

An Analysis of Jet-Propulsion Systems Making Direct Use of the Working Substance of a Thermodynamic Cycle

Description: From Summary: "The results of the analysis showed that the combined efficiency, which is unacceptably low at speeds less than 300 miles per hour, becomes nearly equal to that of conventional power plants of current design at 500 miles per hour. It was also shown that the efficiency will be increased considerably as the physical limitations on cycle temperature and blower speed are raised and as the efficiencies of the system components are improved."
Date: February 1945
Creator: Rubert, Kennedy F.
Item Type: Refine your search to only Report
open access

The Analysis of Strains Indicated by Multiple-Strand Resistance-Type Wire Strain Gages Used as Rosettes

Description: "Methods are given for making the necessary corrections to the strains indicated by multiple-strand resistance-type wire strain gages used singly or as rosettes to measure strains at an angle to the principal strain. The results of tests to determine the validity of the methods of correction are reported" (p. 1).
Date: January 1943
Creator: Dow, Norris F.
Item Type: Refine your search to only Report
open access

An analysis of the fatigue life of an airplane wing structure under overload conditions

Description: From Introduction: "Fatigue life expectancy in normal transport operations was investigated in reference 1 and was found to be of equal importance with single-gust life. The effect of overload operation of transport airplanes on the probability of encountering single critical gusts was investigated in reference 2 and the frequency of critical gusts was found to increase rapidly with overload. The effect of overload operation on fatigue strength, however, has not heretofore been evaluated, hence… more
Date: February 1946
Creator: Putnam, Abbott A. & Reisert, Thomas D.
Item Type: Refine your search to only Report
open access

An analysis of the skipping characteristics of some full-size flying boats

Description: From Introduction: "The purpose of this report is to gather together in one place information on the skipping characteristics of number of flying boats. A graph showing the influence of the hull form on the skipping characteristics is given which should be useful in laying out the proportions of the hull in preliminary design to insure good landing behavior."
Date: January 1946
Creator: Locke, F. W. S., Jr.
Item Type: Refine your search to only Report
open access

Analysis of V-G Records from the SNB-1 Airplane

Description: Availability data obtained on SNB-1 trainer-class airplanes were analyzed and results presented as flight envelopes which predict occurrences of large values of air speed and acceleration. Comparison is made with SNJ-4 trainer-class airplane data analyzed by the same method. It is concluded that flight envelopes are satisfactory; that the two types show large differences in flight loads and speeds experience; and that SNB-1 will seldom, if ever, exceed design limit load factor and restricted sp… more
Date: July 1946
Creator: Walker, Walter G. & Meadows, May T.
Item Type: Refine your search to only Report
Back to Top of Screen