UNT Libraries Government Documents Department - 38 Matching Results

Search Results

Results: 1 - 24 next

Table IV - Estimated Reserves of Vanadium-Bearing Rock In Areas of Extraction

Description: Table showing the estimated reserves of vanadium-bearing rock in the Paris-Bloomington, Montpelier, Sublette Ridge, Swift Creek, and Strawberry Creek - Greys River Divide extraction areas in west-central Wyoming and southeastern Idaho. Indicated tonnage and inferred tonnage values are given for each area in millions of tons, along with the percentage of vanadium ore rock, maximum and minimum thickness, and average thickness of the rock in the extraction area.
Date: July 23, 1942
Creator: Rubey, William Walden & McKelvey, V. E.
Item Type: Refine your search to only Dataset

[Plates I-X]

Description: Illustrations accompanying a report investigating the locations of vanadium-bearing phosphatic shale in West-Central Wyoming and Southeastern Idaho. The set includes seven maps (Plates I and V-X) showing the location of rock formations in the area and three charts (Plates II-IV) showing the correlation between the occurrence of vanadium deposits and the thin persistent beds of phosphate rock, oolite, siltstone, dolomite, and limestone with which they are interbedded.
Date: July 23, 1942
Creator: Rubey, William Walden & McKelvey, V. E.
Item Type: Refine your search to only Dataset
open access

On a New Method for Calculating the Potential Flow Past a Body of Revolution

Description: Report presenting a new method for obtaining the velocity potential of the flow about a solid of revolution moving uniformly in the direction of its axis of symmetry in a fluid otherwise at rest. The method is based essentially on the fact that the form of the differential equation for the velocity potential is invariant with regard to conformal transformations in a meridian plane. The general results are applied to a body of revolution obtained by revolving a symmetrical Joukowski profile abou… more
Date: July 1942
Creator: Kaplan, Carl
Item Type: Refine your search to only Report
open access

Bending With Large Deflection of a Clamped Rectangular Plate With Length-Width Ratio of 1.5 Under Normal Pressure

Description: "The Von Karman equations for a thin flat plate with large deflections are solved for the special case of a plate with clamped edges having a ratio of length to width of 1.5 and loaded by uniform normal pressure. Center deflections, membrane stresses, and extreme-fiber bending stresses are given as a function of pressure for center deflections up to twice the thickness of the plate. For small deflections the results coincide with those obtained by Hencky from the linear theory" (p. 1).
Date: July 1942
Creator: Levy, Samuel & Greenman, Samuel
Item Type: Refine your search to only Report
open access

Wind tunnel investigation of control surface characteristics 9: some analytical considerations and experimental test results for an internally balanced flap

Description: Report presenting an analysis of the probable aerodynamic section characteristics of a plain flap with various arrangements of internal balance. The results of the calculations previously obtained were found to be in agreement with the experiment. Some possible applications of the data to balancing tabs are also provided.
Date: July 1942
Creator: Sears, Richard I.
Item Type: Refine your search to only Report
open access

Wind-Tunnel Investigation of Control-Surface Characteristics: [Part] 7 - A Medium Aerodynamic Balance of Two Nose Shapes Used With a 30-Percent-Chord Flap on an NACA 0015 Airfoil

Description: Report presenting force-test measurements in two-dimensional flow made in the 4- by 6-foot vertical tunnel of the characteristics of an NACA 0015 airfoil with a balanced flap with a chord 30 percent of the airfoil chord and a flap-nose overhang 35 percent of the flap chord. Results regarding lift, hinge moment of flap, pitching moment, drag, and tab characteristics are provided.
Date: July 1942
Creator: Sears, Richard I. & Hoggard, H. Page, Jr.
Item Type: Refine your search to only Report
open access

Wind-tunnel investigation of control-surface characteristics 8: a large aerodynamic balance of two nose shapes used with a 30-percent-chord flap on an NACA 0015 airfoil

Description: Report presenting force tests in two-dimensional flow in the 4- by 6-foot vertical tunnel of the characteristics of an NACA 0015 airfoil with a balanced flap having a chord of 30 percent of the airfoil chord, a flap-nose overhang 50 percent of the flap chord, and a tab having a chord 20 percent of the flap chord. Results regarding the precision and presentation of data, lift, hinge moment of flap, pitching moments, drag, tab characteristics, and balancing effectiveness of various overhangs are … more
Date: July 1942
Creator: Sears, Richard I. & Gillis, Clarence L.
Item Type: Refine your search to only Report
open access

High-Speed Wind-Tunnel Tests of Gun Openings in the Nose of the Fuselage of a 1/4-Scale Model

Description: "In connection with recent tests of a 1/4-scale model pursuit airplane in the NACA 8-foot high-speed tunnel, gun openings having low drag were developed for installation in the nose of the fuselage. The increase in the fuselage-drag coefficient for the final form of openings was 0.0132 at a Mach number of 0.69 and at an angle of attack of 0 degrees. The corresponding drag coefficient based on the wing area was about 0.0005. The critical speed of the airplane was not affected by the gun openings… more
Date: July 1942
Creator: Fedziuk, Henry A.
Item Type: Refine your search to only Report
open access

Wind-tunnel investigation of an NACA full-span high-lift lateral-control combination 1: section characteristics, NACA 23012 airfoil

Description: Report presenting an investigation in the 7- by 10-foot wind tunnel to determine the aerodynamic section characteristics of several arrangements of an NACA full-span high-lift lateral-control combination. The combination consists of a full-span flap of airfoil profile that retracts ahead of a narrow-chord full-span aileron. Results regarding coefficients, precision, plain airfoil, determination of optimum aileron-flap arrangement, section aerodynamic characteristics, and lateral-control charact… more
Date: July 1942
Creator: Rogallo, F. M. & Lowry, John G.
Item Type: Refine your search to only Report
open access

Performance Characteristics of Mixed-Flow Impeller and Vaned Diffuser With Several Modifications

Description: Report presenting an investigation of the performance of a mixed-flow impeller and vaned diffuser unit with several modifications in a variable-component supercharger test rig. The investigation covered impeller tip speeds from 800 to 1200 feet per second over the range of air flows from wide-open throttle to incipient surge. The results showed the supercharger to have a peak efficiency of 0.77 and a peak pressure coefficient of 0.61 with the impeller frontal clearance at 0.035 inch.
Date: July 1942
Creator: King, J. Austin & Glodeck, Edward
Item Type: Refine your search to only Report
open access

A preliminary investigation of exhaust-gas ejectors for ground cooling

Description: Report presenting a preliminary investigation to determine the suitability of ejectors actuated by the exhaust of a radial air-cooled aircraft engine for providing engine cooling air at the ground condition. Various length and diameter ejectors were tested for varying engine power for nine ejectors actuated by the exhaust of individual cylinders and three ejectors actuated by the exhaust of groups of three cylinders.
Date: July 1942
Creator: Manganiello, Eugene J.
Item Type: Refine your search to only Report
open access

Wind-Tunnel Tests of Four- and Six-Blade Single- and Dual-Rotating Tractor Propellers

Description: "Test of 10-foot diameter, four and six blade single-rotating and dual-rotating propellers were conducted in the NACA propeller-research tunnel. The propellers were mounted at the front end of a streamline body incorporating spinners to house the hub portions. The effect of a symmetrical wing mounted in the slipstream ranged from 20 degrees to 65 degrees setting corresponds to airplane speeds greater than 500 miles per hour. The results indicate that dual-rotating propellers were from 0 to 6 pe… more
Date: July 13, 1942
Creator: Biermann, David & Hartman, Edwin P.
Item Type: Refine your search to only Report
open access

Analysis of Heat and Compressibility Effects in Internal Flow Systems and High-Speed Tests of a Ram-Jet System

Description: Report discussing an analysis has been made by the NACA of the effects of heat and compressibility in the flow through the internal systems of aircraft along with equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.
Date: July 21, 1942
Creator: Becker, John V. & Baals, Donald D.
Item Type: Refine your search to only Report
open access

Tests of Propeller-Speed Cooling Blowers

Description: Report presenting testing of cooling blowers for air-cooled engine installations and an exploration of the methods used in the blower design and operating characteristics of the blowers over a range of flight speeds and altitudes. The results indicate that the blowers operate as a more efficient type of propeller cuff and in many cases provide considerably more pressure boost than using a cuff.
Date: July 1942
Creator: Silverstein, Abe
Item Type: Refine your search to only Report
open access

Determination of the Stability and Control Characteristics of Airplanes from Tests of Powered Models

Description: Report presenting a technique of testing wind tunnel powered models developed as a result of experience gained in the investigation of the static longitudinal and lateral staiblity and control characteristics of several powered models in the 7- by 10-foot wind tunnel. A discussion of the conditions to be investigated, methods of presenting and interpreting the data, and a suggested operating technique are given.
Date: July 1942
Creator: Recant, Isidore G.
Item Type: Refine your search to only Report
open access

Calculated effects of full-span slotted and Fowler flaps on longitudinal stability and control characteristics for a typical fighter-type airplane with various tail modifications

Description: Report presenting an analytical study of the influence of full-span slotted and Fowler flaps on the requirements for horizontal tail surfaces. The elevator deflection required to land at three-point attitude, elevator deflection required to stall the airplane at altitude, and permissible center-of-gravity range have been calculated for a fighter-type airplane.
Date: July 1942
Creator: Goranson, R. Fabian
Item Type: Refine your search to only Report
open access

Generalized selection charts for bombers powered by one, two, four, and six 2000-horsepower engines

Description: Report presenting a study of the performance of bombers powered by one, two, four, and six 2000-horsepower engines supercharged to 25,000 feet. The performances are computed and are based on drag coefficients equal to the best obtained on modern airplanes and on weight estimates obtained from modern Army Air Forces airplanes. A chart is provided with the coordinates of power loading and wing loading noted so that all performances can be compared.
Date: July 1942
Creator: Brevoort, M. J.; Stickle, G. W. & Hill, Paul R.
Item Type: Refine your search to only Report
open access

Investigation of Means for Extending the Range of Several Bombers to 6000 Miles

Description: Report presenting an investigation of means to increase the range of several airplanes to 6000 miles, including the B-17E, B-24D, B-26C, and B-25A. Tank-wing trailers and tank gliders were found to be the most practical ways of increasing range and calculations are provided for determining the proper loading and dimensions.
Date: July 1942
Creator: Ribner, H. S. & Harmon, S. M.
Item Type: Refine your search to only Report
open access

Preliminary Investigation in the NACA Low-Turbulence Tunnel of Low-Drag Airfoil Sections Suitable for Admitting Air at the Leading Edge

Description: From Summary: "An investigation was carried out in the NACA low-turbulence tunnel to develop low-drag airfoil sections suitable for admitting air at the leading edge. A thickness distribution having the desired type of pressure distribution was found from tests of a flexible model. Other airfoil shapes were derived from this original shape by varying the thickness, the camper, the leading-edge radius, and the size of the leading-edge opening. Data are presented giving the characteristics of the… more
Date: July 1942
Creator: von Doenhoff, Albert E. & Horton, Elmer A.
Item Type: Refine your search to only Report
Back to Top of Screen