UNT Libraries Government Documents Department - 334 Matching Results

This system will be undergoing maintenance April 18th between 9:00AM and 12:00PM CDT.

Search Results

open access

The Measurement of Fuel-Air Ratio by Analysis for the Oxidized Exhaust Gas

Description: "An investigation was made to determine a method of measuring fuel-air ratio that could be used for test purposes in flight and for checking conventional equipment in the laboratory. Two single-cylinder test engines equipped with typical commercial engine cylinders were used. The fuel-air ratio of the mixture delivered to the engines was determined by direct measurement of the quantity of air and of fuel supplied and also by analysis of the oxidized exhaust gas and of the normal exhaust gas. Fi… more
Date: 1943
Creator: Gerrish, Harold C. & Meem, J. Lawrence, Jr.
open access

The Lagrangian Multiplier Method of Finding Upper and Lower Limits to Critical Stresses of Clamped Plates

Description: "The theory of Lagrangian multipliers is applied to the problem of finding both upper and lower limits to the true compressive buckling stress of a clamped rectangular plate. The upper and lower limits thus bracket the truss, which cannot be exactly found by the differential-equation approach. The procedure for obtaining the upper limit, which is believed to be new, presents certain advantages over the classical Raleigh-Rite method of finding upper limits" (p. 1).
Date: 1946
Creator: Budiansky, Bernard & Hu, Pai C.
open access

A Theoretical Investigation of Longitudinal Stability of Airplanes with Free Controls Including Effect of Friction in Control System

Description: "The relation between the elevator hinge moment parameters and the control forces for changes in forward speed and in maneuvers is shown for several values of static stability and elevator mass balance. The stability of the short period oscillations is shown as a series of boundaries giving the limits of the stable regions in terms of the elevator hinge moment parameters. The effects of static stability, elevator moment of inertia, elevator mass unbalance, and airplane density are also consider… more
Date: 1944
Creator: Greenberg, Harry & Sternfield, Leonard
open access

Lifting-Surface-Theory Aspect-Ratio Corrections to the Lift and Hinge-Moment Parameters for Full-Span Elevators on Horizontal Tail Surfaces

Description: "A limited number of lifting-surface-theory solutions for wings with chordwise loadings resulting from angle of attack, parabolic-arc camber, and flap deflection are now available. These solutions were studied with the purpose of determining methods of extrapolating the results in such a way that they could be used to determine lifting-surface-theory values of the aspect-ratio corrections to the lift and hinge-moment parameters for both angle-of-attack and flap-deflection-type loading that coul… more
Date: 1948
Creator: Swanson, Robert S. & Crandall, Stewart M.
open access

Propeller analysis from experimental data

Description: The operation of the propeller is analyzed by the use of the distribution of forces along the radius, combined with theoretical equations. The data were obtained in the NACA 20-foot wind tunnel on a 4-foot-diameter, two-blade propeller, operating in front of four body shapes, ranging from a small shaft to support the propeller to conventional NACA cowling. A method of estimating the axial and the rotational energy in the wake as a fractional part of the propeller power is given. A knowledge of … more
Date: July 19, 1940
Creator: Stickle, George W. & Crigler, John L.
open access

Preignition characteristics of several fuels under simulated engine conditions

Description: "The preignition characteristics of a number of fuels have been studied under conditions similar to those encountered in an engine. These conditions were simulated by suddenly compressing a fuel-air mixture in contact with an electrically heated hot spot in the cylinder head of the NACA combustion apparatus. Schlieren photographs and indicator cards were taken of the burning, and the hot-spot temperatures necessary to cause ignition under various conditions were determined" (p. 121).
Date: September 16, 1940
Creator: Spencer, R. C.
open access

Free-spinning wind-tunnel tests of a low-wing monoplane with systematic changes in wings and tails V: effect of airplane relative density

Description: The reported tests are a continuation of an NACA investigation being made in the free-spinning wind tunnel to determine the effects of independent variations in load distribution, wing and tail arrangement, and control disposition on the spin characteristics of airplanes. The standard series of tests was repeated to determine the effect of airplane relative density. Tests were made at values of the relative-density parameter of 6.8, 8.4 (basic), and 12.0; and the results were analyzed. The test… more
Date: January 11, 1940
Creator: Seidman, Oscar & Neihouse, A. I.
open access

A theoretical study of lateral stability with an automatic pilot

Description: "The influence of automatic operation of the aileron and rudder controls on the lateral stability of an airplane is discussed. The control deflections are assumed to be proportional to the deviations and to the rates of deviation of the airplane from steady-flight conditions. The effects of changes in the types of deviation governing control application are considered. For one simple method of control in which the aileron deflection is proportional to the angle of bank and the rudder deflection… more
Date: March 4, 1940
Creator: Imlay, Frederick H.
open access

The Calculated Effect of Various Hydrodynamic and Aerodynamic Factors on the Take-Off of a Large Flying Boat

Description: Report presents the results of an investigation made to determine the influence of various factors on the take-off performance of a hypothetical large flying boat by means of take-off calculations. The factors varied in the calculations were size of hull (load coefficient), wing setting, trim, deflection of flap, wing loading, aspect ratio, and parasite drag. The take-off times and distances were calculated to the stalling speeds and the performance above these speeds was separately studied to … more
Date: April 29, 1940
Creator: Olson, R. E. & Allison, J. M.
open access

A high-speed motion-picture study of normal combustion, knock and preignition in a spark-ignition engines

Description: Combustion in a spark-ignition engine was investigated by means of the NACA high-speed motion-picture cameras. This camera is operated at a speed of 40,000 photographs a second and therefore makes possible the study of changes that take place in the intervals as short as 0.000025 second. When the motion pictures are projected at the normal speed of 16 frames a second, any rate of movement shown is slowed down 2500 times. Photographs are presented of normal combustion, of combustion from preigni… more
Date: July 24, 1940
Creator: Rothrock, A. M.; Spencer, R. C. & Miller, Cearcy D.
open access

Wind-tunnel investigation of effect of interference on lateral-stability characteristics of four NACA 23012 wings, an elliptical and a circular fuselage and vertical fins

Description: Report presents the results of a wind-tunnel investigation of the effect of wing-fuselage interference on lateral-stability characteristics made in the NACA 7 by 10-foot wind tunnel on four fuselages and two fins, representing high-wing, low-wing, and midwing monoplanes. The fuselages are of circular and elliptical cross section. The wings have rounded tips and, in plan form, one is rectangular and the three are tapered 3:1 with various amounts of sweep. The rate of change in the coefficients o… more
Date: August 8, 1940
Creator: House, Rufus O. & Wallace, Arthur R.
open access

Design Charts Relating to the Stalling of Tapered Wings

Description: An aid in airplane design, charts have been prepared to show the effects of wing taper, thickness ratio, and Reynolds number on the spanwise location of the initial stalling point. Means of improving poor stalling characteristics resulting from certain combinations of the variables have also been considered; additional figures illustrate the influence of camber increase to the wing tips, washout, central sharp leading edges, and wing-tip slots on the stalling characteristics. Data are included … more
Date: January 18, 1940
Creator: Soulé, H. A. & Anderson, R. F.
open access

Tensile Elastic Properties of Typical Stainless Steels and Nonferrous Metals as Affected by Plastic Deformation and by Heat Treatment

Description: A general discussion is given of the relationships between stress, strain, and permanent set. From stress-set curves are derived proof stresses based on five different percentages of permanent set. The influence of prior plastic extension on these values is illustrated and discussed. A discussion is given of the influence of work-hardening, rest interval, and internal stress on the form of the proof stress-extension curve.
Date: February 23, 1940
Creator: McAdam, D. J., Jr. & Mebs, R. W.
open access

Wind-Tunnel Investigation of Spoiler, Deflector, and Slot Lateral-Control Devices on Wings With Full-Span Split and Slotted Flaps

Description: Report presents the results of an extensive investigation made in the NACA 7 by 10-foot wind tunnel of spoiler, deflector, and slot types of lateral-control device on wings with full-span split and slotted flaps. The static rolling and yawing moments were determined for all the devices tested, and the static hinge moments and the time response were determined for a few devices of each type.
Date: August 13, 1940
Creator: Wenzinger, Carl J. & Rogallo, Francis M.
open access

The additional-mass effect of plates as determined by experiments

Description: From Introduction: "The apparent increase in the inertia properties of a body moving in a fluid medium has been called the additional-mass effect. This report presents a resume of test procedures and results of experimental determinations of the additional-mass effect of flat plates. In addition to data obtained from various foreign sources and from a NACA investigation in 1933, the results of tests recently conducted by the National Advisory Committee for Aeronautics are included."
Date: 1941
Creator: Gracey, William
open access

Tests of the NACA 0025 and 0035 Airfoils in the Full-Scale Wind Tunnel

Description: This report presents the results of an investigation conducted in the NACA full-scale wind tunnel to determine the aerodynamic characteristics of the 6 by 36-foot rectangular NACA 0025 and 0035 airfoils. The aerodynamic characteristics of the plain airfoils with rounded and square tips were determined by force tests through a complete angle-of-attack range; in addition, the profile drag was determined by the momentum method. The transition points on the airfoils were located by boundary-layer d… more
Date: 1941
Creator: Bullivant, W. Kenneth
open access

Internal-Flow Systems for Aircraft

Description: An investigation has been made to determine efficient arrangements for an internal-flow system of an aircraft when such a system operates by itself or in combination with other flow systems. The investigation included a theoretical treatment of the problem and tests in the NACA 5-foot vertical wind tunnel of inlet and outlet openings in a flat plate and in a wing.
Date: 1941
Creator: Rogallo, F. M.
open access

Lateral Control Required for Satisfactory Flying Qualities Based on Flight Tests of Numerous Airplanes

Description: Report presents the results of an analysis made of the aileron control characteristics of numerous airplanes tested in flight by the National Advisory Committee for Aeronautics. By the use of previously developed theory, the observed values of pb/2v for the various wing-aileron arrangements were examined to determine the effective section characteristics of the various aileron types.
Date: April 18, 1941
Creator: Gilruth, R. R. & Turner, W. N.
open access

Determination of ground effect from tests of a glider in towed flight

Description: Report presents the results of an investigation made to find the effect of ground on the aerodynamic characteristics of a Franklin PS-2 glider. The lift, the drag, and the angle of attack of the glider in towed flight were determined at several heights from 0.14 to 1.19 span lengths and at various speeds for each height. Two wing arrangements were tested: the plain wing, and the wing with a nearly full-span 30-percent-chord split flap deflected 45 degrees. The experimental results for the plain… more
Date: April 8, 1940
Creator: Wetmore, J. W. & Turner, L. I., Jr.
Back to Top of Screen