UNT Libraries Government Documents Department - 223 Matching Results

Search Results

open access

Standard X-ray Diffraction Powder Patterns: Section 13. Data for 58 substances

Description: Report documenting standard x-ray diffraction powder patterns for various compounds, intended to replace previous data or provide information for new substances. It describes the methods and, for each substance, outlines any previous data as well as information about the sample used and structural data, with a table of diffraction patterns.
Date: June 1976
Creator: Morris, Marlene C.; McMurdie, Howard F.; Evans, Eloise H.; Paretzkin, Boris; de Groot, Johan H.; Hubbard, Camden R. et al.
open access

The Electroslag Melting Process

Description: "This Bulletin traces the development of the electroslag melting process from its modest beginnings to the present. Important basic mechanisms such as electrochemistry, thermochemistry, and heat transport are described. Since the choice of flux is a unique parameter in the electroslag process, two chapters are developed to this subject. Electroslag melting experience for reactive metals, base metals, ferrous alloys, superalloys, and the refractory metals, both inside and outside the Bureau of M… more
Date: 1976
Creator: Nafziger, R. H.
open access

Contributions to the Data on Theoretical Metallurgy: [Part] 16. Thermodynamic Properties of Nickel and its Inorganic Compounds

Description: From Introduction: "The compilation of thermodynamic properties of nickel and its inorganic compounds was undertaken as part of a continuing effort by the Federal Bureau of Mines to provide information for the extractive metallurgist to use as guidelines for research on improving established process or developing new ones. This report also provides useful information for other areas of thermochemical research."
Date: 1976
Creator: Mah, Alla D. & Pankratz, L. B.
open access

Automatic Measurement of Network Parameters: A Survey

Description: Report issued by the Bureau of Standards over a survey conducted on measurement methods of network parameters. As stated in the introduction, "this paper is concerned with the development of automatic methods of measuring basically the magnitudes and phase differences, or the complex ratio of two sinusoidal voltages, and applications of this capability to determining complex reflection coefficients and transmission coefficients and group delay times of electrical networks" (p. 1). This report i… more
Date: June 1976
Creator: Beatty, Robert William
open access

Computers, Health Records, and Citizen Rights

Description: Report issued by the Bureau of Standards over studies on the benefits of computerized record-keeping. Medical records were chosen for the studies, and they also focus on patient privacy and rights. This report includes tables, and illustrations.
Date: December 1976
Creator: Westin, Alan F.; Baker, Michael A.; Annas, George J.; Silberberg, Richard; Broder, Jamie; Isbell, Florence et al.
open access

The First Spectrum of Hafnium (HF I)

Description: Report continuing W. K. Meggers' previous analysis in LS-coupling. This coupling is not rigorous in Hf I, and many intervals are irregular. Consequently, the levels are given also in numerical order with the even and odd levels presented in separate tables. The long line lists are given in two Appendices: Appendix A contains the observed Zeeman data for the individual lines, 531 in all; Appendix B consists of the complete line list of observed and classified lines. By far the greater part of th… more
Date: July 1976
Creator: Meggers, William F. & Moore, Charlotte E.
open access

The Dynamics of Fields of Higher Spin

Description: Report presenting a relativistic theory of motion that is free of many of the difficulties common in relativistic equations of motion. This Lagrangian theory describes fields and particles with arbitrary mass and charge and having any discrete spin, integer or half integer.
Date: August 1976
Creator: Hayward, Raymond W.
open access

Liquid-in-Glass Thermometry

Description: Report containing information of general interest to manufacturers and users of liquid-in-glass thermometers. This report supersedes Monograph 90. Instructions explaining how to submit a thermometer to the National Bureau of Standards for calibration are provided, and the techniques and equipment, such as stirred liquid comparison baths, used in the calibration procedures are described. A discussion of important principles of acceptable thermometer design and factors affecting their use is incl… more
Date: January 1976
Creator: Wise, Jacquelyn A.
open access

Electrokinetic Consolidation of Slimes in an Underground Mine

Description: Report issued by the Bureau of Mines over tests conducted on underground mine slimes from a collection sump. Testing methods and results are discussed. This report includes tables, illustrations, and photographs.
Date: 1976
Creator: Sprute, R. H. & Kelsh, D. J.
open access

Coal Project: Background Information (Planning and Management)

Description: From foreword: "This report presents summary information on coal development in the United States, and material on the potential interactions of that development with fish and wildlife resources."
Date: July 14, 1976
Creator: Coal Project (U.S.)
open access

Health Physics Division Annual Progress Report: Period Ending June 30, 1976

Description: Annual report for the Oak Ridge National Laboratory Health Physics Division including sections on medical physics and internal dosimetry; chemical physics and spectroscopy; biological and radiation physics; assessment technology; emergency technology; analytic dosimetry and education group; theses, papers, publications, and lectures; and miscellaneous staff activities.
Date: October 1976
Creator: Oak Ridge National Laboratory. Health Physics Division.
open access

FORTIO: a FORTRAN I/O Interface

Description: A set of OS/370 Basic Assembly Language programs is described which provides a FORTRAN IV interface with OS/370 Macros.
Date: April 1976
Creator: Shalla, L.
open access

Final Report on the Small-Scale Vapor-Explosion Experiments Using a Molten NaCl-H2O System

Description: Vapor explosions were produced by injecting small quantities of water into a container filled with molten sodium chloride. Minimum explosion efficiencies, as evaluated from reaction-impulse measurements, were relatively large. Subsurface movies showed that the explosions resulted from a two-step sequence: an initial bulk-mixing phase in which the two liquids intermix on a large scale, but remain locally separated by an insulating gas-vapor layer; and a second step, immediately following breakdo… more
Date: April 1976
Creator: Anderson, R. P. & Bova, L.
open access

A Unified and Mechanistic Approach to Creep-Fatigue Damage

Description: A new creep-fatigue equation is proposed that takes into account both plastic strain and strain rate. The coefficients and exponents in the damage-rate equation are interpreted by means of the various damage mechanisms of the material. The damage-rate equation has been integrated to analyze various phenomena such as the effects of plastic strain rate on monotonic tensile or creep rupture time, rising mean strain on the low-cycle fatigue behavior at elevated temperature, tensile and compressive … more
Date: January 1976
Creator: Majumdar, S. & Maiya, P. S.
open access

Automated Approach to Quantitative Error Analysis in Neutron Transport Calculations

Description: A method is described how a quantitative measure for the robustness of a given transport theory code for coarse network calculations can be obtained. A code, that performs this task automatically and at only nominal cost, is described and has been implemented for slab geometry. This code generates also user oriented benchmark problems which exhibit the analytic behavior at interfaces.
Date: September 1976
Creator: Bareiss, Erwin H. & Derstine, Keith L.
open access

Materials Science Division Coal Technology Quarterly Report: January-March 1976

Description: Quarterly report of the Argonne National Laboratory Materials Science Division regarding the evaluation of ceramic refractories to withstand abrasion-corrosion by coal slag that will be encountered in the Bituminous Coal Research (BCR) Bi-Gas coal-gasification pilot plant, development of computer models to predict corrosion and erosion behavior of materials, and analysis of pilot-plant components that have failed or are removed from service for other reasons.
Date: 1976?
Creator: Argonne National Laboratory
open access

An Overview of Pool-Type LMFBRs : General Characteristics

Description: This report describes the results of a study conducted by a "Pool Study Group" organized at ANL in mid-1975 to examine the present state of the air of design of pool-type LMFBRs. The study concentrated on examination of various design options used to date in the principle pool-type projects and design studies in this country and abroad, including the Phenix and Super-Phenix reactors (France), PFR and CFR (U.K.), RN-600 (U.S.S.R.) and EBR-II (U.S.A.). The objective of the report is to provide a … more
Date: May 1976
Creator: Amorosi, A.; Hutter, E.; Marciniak, T. J.; Monson, H. O.; Seidensticker, R. W. & Simmons, W. R.
open access

Examination of the SCEPTRE and CSMP Programs for Solving the Point-Kinetics Equations with Feedback

Description: Two modeling programs, SCEPTRE and CSMP, are used to solve the point-kinetics equations - - seven coupled nonlinear differential equations - - with a linear-feedback function. The constants used are appropriate for EBR-II; therefore the computational accuracy may be tested against the experimental rod drops. Run-time, versatility, programming ease, and accuracy are criteria used to evaluate the two programs. SCEPTRE is found to be more efficient in run time and CSMP more versatile. The ease of … more
Date: September 1976
Creator: Walkowski, P. D. & Peterson, B. R. (Bruce R.)
open access

Finite-Element Analysis of a Thick-Wall Tube Containing a Crater-Like Surface Flaw

Description: A three-dimensional finite-element elastic analysis is carried out for a thick-wall tube (as sued in typical LMFBR steam generators) that contains a surface flaw in the form of a paraboloid of revolution. Effects of the depth and aspect ratio of the flaw on the stress distribution and stress concentration in the tube are explored.
Date: June 1976
Creator: Majumdar, S.
open access

PTA-1: A Computer Program for Analysis of Pressure Transients in Hydraulic Networks, Including the Effect of Pipe Plasticity

Description: The computer program PTA-1 performs pressure-transient analysis of large piping networks using the one-dimensional method of characteristics applied to a fluid-hammer formulation. The effect of elastic-plastic deformation of piping on pulse propagation is included in the computation. The program is particularly oriented toward the analysis of the effects of a sodium/water reaction on the intermediate heat-transport system of a liquid-metal-cooled fast breeder reactor, but may be applied just as… more
Date: November 1976
Creator: Youngdahl, C. K. & Kot, C. A.
open access

Fission-Product Releases to the Primary System of EBR-II, January 1974-March 1975

Description: Seven releases of fission products occurred in EBR-II from January 1974 to March 1975 - - five from mixed-oxide elements and two from sodium-bonded driver-fuel elements. Four releases were from elements that contained a xenon tag, which aided considerably in locating three of the elements; data from the fourth element allowed estimation of changes of tag composition with reactor exposure. Rapid release of fission from two breached mixed-oxide elements caused the reactor to trip because of incre… more
Date: October 1976
Creator: So, B. Y. C.; Lambert, J. D. B.; Johnson, D. L.; Ebersole, E. R. & Brunson, G. S.
open access

Inelastic-Collision Cross Sections for Ne

Description: Cross sections for inelastic collisions of slow electrons and the dipole oscillator-strength distribution for the neon atom are given in tabular form. The results are based on experimental data that were checked and adjusted for internal consistency.
Date: 1976
Creator: Soong, S. C. & Kim, Yong-Ki
Back to Top of Screen