UNT Libraries Government Documents Department - 167 Matching Results

Search Results

prev Results: 97 - 120 next
open access

Casting of Blanket Bricks, Ring, Plug, and Control Rods for the Experimental Breeder Reactor (CP-4)

Description: The cup assembly of the Experimental Breeder Reactor (EBR) consists of blanket bricks, inner rings, and safety plug, all of natural uranium. The design of the finish machined brick is shown in Figure 1. These pie shaped bricks when stacked together, 12 bricks arranged in circular form and stacked seven rings high, comprise the cylindrical portion of the outer blanket, 17.875" I.D. x 30.875" O.D. after machining and canning. The inner ring, which is shown in Figure 2, fits inside the bottom laye… more
Date: March 19, 1953
Creator: Macherey, Robert E.
Item Type: Refine your search to only Report
open access

Reactor Engineering Division Quarterly Report : December 1, 1952 Through February 28, 1953

Description: Report issued by the Argonne National Laboratory covering the quarterly report from the Reactor Engineering Division. A summary of reactor programs, research, designs, development, and experiments are presented. This report includes tables, illustrations, and photographs.
Date: March 15, 1953
Creator: Argonne National Laboratory. Reactor Engineering Division
Item Type: Refine your search to only Report
open access

Thermal Annealing of Neutron Induced Discomposition in Artificial Graphite : [Part] III, Heating-During-Irradiation Experiments

Description: Experiments are described in which the pile-induced changes in electrical resistivity and elastic modulus of graphite were investigated as functions of the sample temperature during bombardment and the amount of bombardment. The data are for relatively low bombardment times (up to ca. 20 L-units) and temperatures (up to 340*C) and are not sufficiently extensive to permit unequivocal conclusions.
Date: April 13, 1953
Creator: Neubert, T. J.
Item Type: Refine your search to only Report
open access

Effects of Metal Purity and Heat Treatment on the Corrosion of Uranium in Boiling Water

Description: Corrosion rates of present reactor grade uranium were measured in boiling distilled water and were found to have higher values almost by a factor of two then previously reported corrosion rates of uranium. Mallinckrodt biscuit metal showed corrosion rates in the same medium somewhat lower than reactor grade uranium, and high purity metal prepared at Argonne National Laboratory corroded considerably less rapidly than the biscuit metal.
Date: April 14, 1953
Creator: Draley, Joseph Edward, 1919- & McWhirter, J. W.
Item Type: Refine your search to only Report
open access

The Isolation and Purification of Neptunium-237 Obtained From Hanford Wastes

Description: Through the efforts of the Hanford Engineer Works a quantity of neptunium-237 was separated from uranium waste solutions by a modification of the standard plutonium precipitation process, This material, as concentrates, was shipped to Argonne for final isolation and purification of the neptunium.
Date: May 6, 1953
Creator: Hindman, J. C.; Wehner, Philip, 1917-; Sullivan, J. C. & Cohen, Donald
Item Type: Refine your search to only Report
open access

Refractive Indices of the Systems Uranium Hexafluoride-Bromine Trifluoride and Uranium Hexafluoride-Bromine Pentafluoride

Description: A spectrometer has been used with a hollow prism electrically heated to 70 C to measure the refractive indices of solutions of uranium hexafluoride in bromine trifluoride and uranium hexafluoride in bromine pentafluoride. The refractive indices of the two binary systems have been expressed as a function of composition.
Date: May 25, 1953
Creator: Stein, Lawrence & Vogel, Richard C.
Item Type: Refine your search to only Report
open access

Chemical Engineering Division Summary Report : January, February, And March 1953

Description: Dissolution of the large number of samples obtained from the natural uranium blanket of the Experimental Breeder Reactor after approximately 485,000 kw.-hr. of operation has been completed, and analysis of these samples for uranium consumed and plutonium formed is well along. An attempt is being made to distinguish quantitatively between uranium-238 and uranium-235 fission in the blanket area by determining the ratio of ruthenium-106 to cesium-137 in the fission products.
Date: May 12, 1953
Creator: Lawroski, Stephen & Stevenson, C. E.
Item Type: Refine your search to only Report
open access

Plaster of Paris Replicas of Reactor Fuel Slugs

Description: A method is described for preparing plaster of Paris replicas of irradiated fuel slugs. An impression mold is made by pouring the plaster about a fuel slug held in a specially designed holder. The slug is removed from the holder and the impression mold issued to cast a replica, also made of plaster of Paris. The replicas, including one end only, are accurate reproduction of the original slug for surface features down to about one-half mil and for dimensions within one or two mills. Two dental i… more
Date: June 12, 1953
Creator: Deily, George J.
Item Type: Refine your search to only Report
open access

Reactor Engineering Division Quarterly Report March 1, 1953 through May 31, 1953

Description: Report issued by the Argonne National Laboratory covering the quarterly report from the Reactor Engineering Division. A summary of reactor programs, designs, development, and experiments are presented. This report includes tables, illustrations, and photographs.
Date: June 15, 1953
Creator: Argonne National Laboratory. Reactor Engineering Division.
Item Type: Refine your search to only Report
open access

Feasibility Report on Fast Exponential Experiment

Description: The general program established at Argonne National Laboratory in connection with the Fast Power Breeder Reactor (PBR) includes performance of exponential experiments on assemblies having compositions which may exist in the reactor core. This report deals with that phase of the program known as the Fast Exponential Experiment which may be described very briefly as follows. An assembly of fissile (U-235) and fertile material (too small to be self-critical) intermixed with poisons (such as are en… more
Date: June 10, 1953
Creator: Brittan, R. O.; Hummel H. H.; Livingood, John J. (John Jacob), 1903-; Martens, F. H. & Spinrad, Bernard I.
Item Type: Refine your search to only Report
open access

Development of Zirconium Clad Uranium Plates for Reactor Fuel

Description: In this investigation a method has been developed for production of Zrclad uranium plate based upon previous investigations at Argonne and Oak Ridge National Laboratories, and preliminary in investigations in their present work. The present preliminary investigations included experimental studies of the effect of interface atmosphere upon roll bonding and led to the conclusion that thin layers of air between bonding surfaces could be tolerated.
Date: unknown
Creator: Lawless, J. J.; Bean, C. H.; Wooland, J. R. & Macherey, R. E.
Item Type: Refine your search to only Report
open access

Plutonium Production Analysis - Graphical Method

Description: In the a study of plutonium production, the analytical solutions of the various isotope production equations are difficult and time consuming when spatial variation of the flux is considered. In an effort to reduce the time and labor required to determine the integrated production of a given thermal reactor, a graphical method of analysis is presented. The method is based on the assumption that the reactor may be divided into a relatively small number of regions such that the flux in each of th… more
Date: January 1954
Creator: Mumm, J. F. & Templin L. J.
Item Type: Refine your search to only Report
open access

Preliminary Report on Low Columbium: Uranium Corrosion Resistant Alloys

Description: Uranium alloys containing 3 and 6 w/o niobium have been prepared in which the impurity content is rather low. These alloys show very promising resistance to corrosion by water at 260 and 300 degree C. The corrosion resistance is exhibited in degassed water and in water which is saturated with air or oxygen at room temperature before testing.
Date: June 24, 1953
Creator: Draley, Joseph Edward, 1919-
Item Type: Refine your search to only Report
open access

Deposition of Corrosion Products by Cataphoresis

Description: This report is a record of experimentation conducted intermittently over a period of two years and directed toward preventing deposition of transport corrosion products on fuel elements and other critical components in high-temperature, circulating water nuclear reactor. It includes the postulated mechanism for deposition, a description of experimental equipment, experimental data, results obtained from the experiments, and recommendations for future study.
Date: June 25, 1953
Creator: Fagan, Walter
Item Type: Refine your search to only Report
open access

Dissolution of Uranium Oxide Arising From Slug Failure

Description: The purpose of this work was to study reagents which might be effective in dissolving uranium oxide produced during slug failures in water-cooled reactor systems. An aspect of this problem which has subsequently become of primary importance is the solubility or transportability of the oxide in pure water.
Date: July 1953
Creator: Johnston, F. J.; Wills, P. E. & Katz, Joseph J. (Joseph Jacob), 1912-2008
Item Type: Refine your search to only Report
open access

Zrclad Zirconium-Uranium Alloy Rod for Heat Thru-Put Test

Description: The purpose of this work was (1) to investigate the possibility of producing zirconium-clad zirconium-uranium alloy objects by casting the core alloy directly into zirconium and zirconium-3 w/o tin jackets, producing a diffusion bond at the jacket-core interfaces, and (2) to produce small scale heat thru-put test specimens by this method.
Date: April 17, 1952
Creator: Shuck, Arthur B., 1918-
Item Type: Refine your search to only Report
open access

Corrosion of Plutonium Alloys in NaK

Description: A plutonium-aluminum alloy containing 4 atom per cent aluminum showed no attack after exposure to purified NaK for one month at 400 C in the absence of any oxide. The same specimen and other plutonium alloys, including pure plutonium, showed marked deterioration in shorter exposure in the presence of oxide films from a welded stainless steel container. Pure uranium was resistant even in the presence of such oxides.
Date: July 1953
Creator: Hyman, H. H. & Katz, Joseph J. (Joseph Jacob), 1912-2008
Item Type: Refine your search to only Report
open access

Critical Studies with G. E. Type Fuel Elements

Description: The ZPR-I is a facility to study low power critical assemblies using enriched uranium as fuel, having a light water moderator and an essentially infinite water reflector on all sides. The fuel is held in elements 43" long with a 1" square cross section. Any of these elements may be placed in or removed from any position in the reactor tank. Thus, any desired core configuration may be easily obtained.
Date: August 1953
Creator: Martens, F. H. & Helfrich, G. F.
Item Type: Refine your search to only Report
open access

The Electrolytic Refining of Uranium

Description: This technical report describes work done on the electrolytic refining of natural uranium in fused salt baths composed of various eutectics of alkali metal chlorides in which were dissolved UF, or UCl3.
Date: August 2, 1953
Creator: Marzano, Carlo, 1905- & Noland, N. A.
Item Type: Refine your search to only Report
open access

An Improved Continuous Ether Extractor for the Determination of Uranium in Dissolver Solutions

Description: An improved continuous ether extractor is described. The modifications include a means of safely disposing of the active raffinate and a means of positivity checking the raffinate for completeness of uranium extraction. The results obtained on synthetic samples and on dissolver solutions are given. This work was undertaken because of a need for the determination of uranium in dissolver solutions with an accuracy of 0.1 per cent. After a review of available methods it was decided that a gravimet… more
Date: August 27, 1953
Creator: Bane, R. W. & Jensen, K. J.
Item Type: Refine your search to only Report
open access

Development of a Process to Produce Zirconium Hanford Type Process Tubing by Roll Forming And Inert Arc Welding

Description: The development of methods which were successful in producing zirconium Hanford type process tubing by roll forming and inert are welding (He) flat strip to which appropriate rails had ben previously attached by resistance welding is described in this report. Grade 2 drip arc melted crystal bar material was used.
Date: May 1, 1953
Creator: Noland, R. A. & O'Keefe, G. B.
Item Type: Refine your search to only Report
open access

Preferred Orientation in 300 C Rolled and in Recrystallized Uranium Sheet

Description: The rolling and recrystallization textures in 300 C rolled uranium sheet were investigated using a Geiger counter diffractometer with the modified Schulz reflection technique. Seven sections of sheet material were used in order to obtain sufficient data for quantitative pole figures by the reflection technique. A special integrating specimen table was used for obtaining and recording the data atomically.
Date: September 15, 1953
Creator: Mueller, Melvin Henry, 1918-; Knott, Harold W. & Beck, Paul A. (Paul Adams), 1908-
Item Type: Refine your search to only Report
open access

The Development of Equipment and Methods for Centrifugally Casting Reactor Fuel Slugs

Description: This technical report describes the design and construction of equipment and the development of methods for multiple mold, centrifugal casting of reactor fuel slugs. Advantages of the centrifugal casting method over the conventional fabrication methods were found to be (1) fewer operations, (2) fewer and more easily recovered residues, (3) less expensive equipment, and (4) the production of fuel slugs in shapes and in alloys not well adapted to other methods of manufacture. The method consisted… more
Date: September 29, 1953
Creator: Shuck, Arthur B., 1918-
Item Type: Refine your search to only Report
Back to Top of Screen