UNT Libraries Government Documents Department - 366 Matching Results

Search Results

Results: 1 - 24 next
open access

Accelerations Measured at Center of Gravity and Along Span of the Wing of a B-24D Airplane in Landing Impacts

Description: Report presenting measurements of a Consolidated B-24D airplane of accelerations at various points on the wing during landing impacts. landings were made with the wheels initially stationary but free to rotate, with the brakes set before contact, and with the main wheels rotating prior to contact.
Date: August 1944
Creator: Westfall, John R.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics of a 45 Degree Swept-Back Wing With Aspect Ratio of 3.5 and NACA 2S-50(05)-50(05) Airfoil Sections

Description: From Introduction: "The present paper presents the scale effect on the longitudinal aerodynamic characteristics, the aerodynamic characteristics in yaw, and the tuft studies for 0^o and 3.7^o yaw. The results of the effect of leading-edge and trailing-edge flaps on the aerodynamic characteristics of the wing will be presented in later reports."
Date: August 4, 1947
Creator: Proterra, Anthony J.
Item Type: Refine your search to only Report
open access

Aerodynamic Study of a Wing-Fuselage Combination Employing a Wing Swept Back 63 Degrees: Characteristics Throughout the Subsonic Speed Range With the Wing Cambered and Twisted for a Uniform Load at a Lift Coefficient of 0.25

Description: Report presenting wind-tunnel testing to determine the independent effects of Mach and Reynolds numbers on the aerodynamic characteristics of a wing-fuselage combination with a wing with the leading edge swept back 63 degrees and with camber and twist. Results regarding the fuselage alone and the effects of camber and twist are also provided.
Date: August 15, 1949
Creator: Jones, J. Lloyd & Demele, Fred A.
Item Type: Refine your search to only Report
open access

The aerodynamics of a wind-tunnel fan

Description: From Introduction: "This paper deals only with the aerodynamics of the fan proper and demonstrates the manner in which the radial distribution of axial velocity of fluid through a fan is governed by geometry of the fan itself."
Date: August 1941
Creator: Corson, Blake W.
Item Type: Refine your search to only Report
open access

Air-Flow and Performance Characteristics of Engine-Stage Supercharger of a Double-Row Radial Aircraft Engine 2: Effect of Design Variables

Description: Report presenting an investigation to determine the effect of the location of the diffuser vanes with respect to the supercharger outlets and the effect of flow conditions at the impeller inlet on the air-flow distribution in the outlets of the engine-stage supercharger of an 18-cylinder double-row radial aircraft engine. The effect of flow conditions at the impeller inlet was investigated by distorting the flow at the inlet and noting the effect in the supercharger outlets. Results regarding t… more
Date: August 1946
Creator: Baas, Edmund J. & Dugan, Paul D.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine 1 - Analysis of Turbine Performance

Description: A wind tunnel investigation was conducted to determine the performance of a turbine operating as an integral part of a turbojet engine. Data was obtained while the engine was running over full operable range of speeds at various altitudes and flight mach numbers, and with four nozzles of different outlet areas.A maximum turbine efficiency of 0.875 was obtained at altitude of 15 thousand feet, Mach number 0.53, and corrected turbine speed of 5900 rpm.
Date: August 23, 1948
Creator: Conrad, Earl W.; Dietz, Robert O., Jr. & Golladay, Richard L.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine 2 - Analysis of Compressor Performance

Description: Compressor performance properties for two 11-stage compressors of 3000-pound-thrust axial-flow turbojet engines were determined. Data are presented for a range of simulated altitudes and a range of Mach numbers for various modifications of the engine.
Date: August 23, 1948
Creator: Dietz, Robert O., Jr.; Berdysz, Joseph J. & Howard, Ephraim M.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine 3 - Analysis of Combustion-Chamber Performance

Description: Combustion chamber performance properties of a 3000-pound-thrust axial-flow turbojet engine were determined. Data are presented for a range of simulated altitudes from 15,000 to 45,0000 feet and a range of Mach numbers from 0.23 to 1.05 for various modifications of the engine.
Date: August 23, 1948
Creator: Campbell, Carl E.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine, 4, Operational Characteristics

Description: An investigation was conducted to evaluate the operational characteristics of a 3000 pound thrust axial flow turbojet engine over a range of simulated altitudes from 2000 to 50,000 feet and simulated flight Mach numbers from 0 to 1.04 throughout the operable range of engine speeds. Engine operating range, acceleration, deceleration, starting, altitude, and flight Mach number compensation of the fuel control system, and operation of the lubrication system at high and low ambient air temperatures… more
Date: August 23, 1948
Creator: Hawkins, W. Kent & Meyer, Carl L.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine, Part 5, Performance and Windmilling Drag Characteristics

Description: "An investigation has been conducted in the NACA Cleveland altitude wind tunnel to evaluate the performance and windmilling drag characteristics of an original and a modified turbojet engine of the same type. Data have been obtained at simulated altitudes from 5000 to 45,000 feet, simulated flight Mach numbers from 0.09 to 1.08, and engine speeds from 4000 to 12,500 rpm. Engine performance data are presented for both engines to show the effects of altitude at a flight Mach number of 0.25 and of… more
Date: August 23, 1948
Creator: Meyer, Carl L. & Bloomer, Harry E.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine. 2 - Operational Characteristics

Description: From Summary: "An investigation was conducted in the Cleveland altitude wind tunnel to determine the operational characteristics of an axial flow-type turbojet engine with a 4000-pound-thrust rating over a range of pressure altitudes from 5,000 to 50,000 feet, ram pressure ratios from 1.00 to 1.86, and temperatures from 60 deg to -50 deg F. The low-flow (standard) compressor with which the engine was originally equipped was replaced by a high-flow compressor for part of the investigation. The e… more
Date: August 6, 1948
Creator: Fleming, William A.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine, 3, Performance Characteristics with the High-Flow Compressor

Description: A wind tunnel investigation was conducted to determine the performance of a 4000-pound-thrust axial-flow turbojet engine with a high flow compressor. Pressure altitudes included 5000 to 40000 feet with ram pressure ratios from 1.00 to 1.82. Altitudes included 20000 to 40000 feet and ram pressure ratios from 1.09 to 1.75. A comparison is made between engine performance with high flow and low flow compressors.
Date: August 5, 1948
Creator: Fleming, William A. & Golladay, Richard L.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine, 4 - Analysis of Compressor Performance

Description: Operating characteristics of the 11-stage 4000-pound-thrust axial-flow turbojet engine were determined. A standard compressor and a compressor with the blade angles of the rotor and stator blades increased 5 degrees to obtain greater air flow, were investigated.
Date: August 5, 1948
Creator: Dietz, Robert O., Jr. & Suozzi, Frank L.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine 5 - Analysis of Turbine Performance

Description: "Performance characteristics of the turbine of a 4000-pound-thrust axial-flow turbojet engine was determined in investigations of the complete engine in the NACA Cleveland altitude wind tunnel. Characteristics are presented as functions of the total-pressure ratio across the turbine and of turbine speed and gas flow corrected to sea-level conditions. Three turbine nozzles of different areas were used to determine the area that gave optimum performance" (p. 1).
Date: August 4, 1948
Creator: Krebs, Richard P. & Hensley, Reece V.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine 6: Combustion-Chamber Performance

Description: "An analysis of the performance of the types A, B, and C combustion chambers of the 4000-pound-thrust axial-flow turbojet engine is presented. The data were obtained from investigations of the complete engine over a range of pressure altitudes from 5000 to 40,000 feet and ram pressure ratios from 1.00 to 1.86. The combustion-chamber pressure losses, the effect of the losses on cycle efficiency, and the combustion efficiency are discussed" (p. 1).
Date: August 4, 1948
Creator: Pinkel, I. Irving & Shames, Harold
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine, Part 1, Performance and Windmilling Drag Characteristics

Description: From Summary: "The results of altitude-wind-tunnel tests conducted to determine the performance of an axial-flow-type 4000-pound-thrust turbojet engine for a range of pressure altitudes from 5000 to 40,000 feet and ram pressure ratios from 1.02 to 1.86 are presented and the experimental and analytical methods employed are discussed. By means of suitable generalizing factors applied to the measured performance data, curves were obtained from which the engine performance at any altitude for a giv… more
Date: August 3, 1948
Creator: Fleming, William A.
Item Type: Refine your search to only Report
open access

Altitude-wind-tunnel investigation of thrust augmentation of a turbojet engine 3: performance with tail-pipe burning in standard-size tail pipe

Description: From Introduction: "Evaluation of tail-pipe burning in this engine with a larger tail-pipe combustion chamber is discussed in reference 1. Results of investigations on tail-pipe burning in this engine at static sea-level conditions are presented in reference 2. An investigation of thrust augmentation by means of injecting water at the inlet of an axial-flow compressor engine is discussed in reference 3."
Date: August 11, 1947
Creator: Fleming, William A. & Golladay, Richard L.
Item Type: Refine your search to only Report
open access

Analysis and modification of theory for impact of seaplanes on water

Description: From Summary: "An analysis of available theory on seaplane impact and a proposed modification thereto are presented. In previous methods the overall momentum of the float and virtual mass has been assumed to remain constant during the impact but the present analysis shows that this assumption is rigorously correct only when the resultant velocity of the float is normal to the keel."
Date: August 20, 1945
Creator: Mayo, Wilbur L.
Item Type: Refine your search to only Report
open access

Analysis of Cylinder-Pressure-Indicator Diagrams Showing Effects of Mixture Strength and Spark Timing

Description: "An investigation was made to determine the effect of mixture strength and of normal as well as optimum spark timing on the combustion, on the cylinder temperature, and on the performance characteristics of an engine. A single-cylinder test unit utilizing an air-cooled cylinder and a carburetor and operating with gasoline having an octane rating of 92 was used. The investigation covered a range of fuel-air ratios from 0.053 to 0.118. Indicator diagrams and engine-performance data were taken for… more
Date: August 1940
Creator: Gerrish, Harold C. & Voss, Fred
Item Type: Refine your search to only Report
Back to Top of Screen