UNT Libraries Government Documents Department - 151 Matching Results

Search Results

Results: 1 - 24 next
open access

The 5- by 7-meter wind tunnel of the DVL

Description: The report contains a description of the DVL wind tunnel. According to the cones fixed, an elliptical stream with axes 5 by 7 meters and length 9 meters, or a stream 6 by 8 meters in cross section and 11 meters in length is available. The top speed with the smaller cone is 65 meters per second. The testing equipment consists of an automatic six-component balance and a test rig for propellers and engines up to 650 horsepower.
Date: March 1936
Creator: Kramer, M.
Item Type: Refine your search to only Report
open access

Air flow in the boundary layer near a plate

Description: From Summary: "The published data on the distribution of speed near a thin flat plate with sharp leading edge placed parallel to the flow (skin friction plate) are reviewed and the results of some additional measurements are described. The purpose of the experiments was to study the basic phenomena of boundary-layer flow under simple conditions."
Date: March 1936
Creator: Dryden, Hugh L.
Item Type: Refine your search to only Report
open access

Aircraft Accidents: Methods of Analysis

Description: This report is a revision of NACA-TR-357. It was prepared by the Committee on Aircraft Accidents. The purpose of this report is to provide a basis for the classification and comparison of aircraft accidents, both civil and military.
Date: June 22, 1936
Creator: Committee on Aircraft Accidents
Item Type: Refine your search to only Report
open access

Analysis and Model Tests of Autogiro Jump Take-Off

Description: From Introduction: "The possibilities of the jump take-off have been established by some full-scale experiments. It is the purpose of this paper to study the factors that govern the jump take-off in its simplest form and to present the results of model tests in which the effect of differences in the rotor parameters was determined."
Date: October 1936
Creator: Wheatley, John B. & Bioletti, Carlton
Item Type: Refine your search to only Report
open access

An Analysis of Lateral Stability in Power-Off Flight With Charts for Use in Design

Description: "The aerodynamic and mass factors governing lateral stability are discussed and formulas are given for their estimation. Relatively simple relationships between the governing factors and the resulting stability characteristics are presented. A series of charts is included with which approximate stability characteristics may be rapidly estimated" (p. 1).
Date: November 17, 1936
Creator: Zimmerman, Charles H.
Item Type: Refine your search to only Report
open access

An Approximate Spin Design Criterion for Monoplanes

Description: "An approximate empirical criterion, based on the projected side area and the mass distribution of the airplane, was formulated. The British results were analyzed and applied to American designs. A simpler design criterion, based solely on the type and the dimensions of the tail, was developed; it is useful in a rapid estimation of whether a new design is likely to comply with the minimum requirements for safety in spinning" (p. 1).
Date: June 1936
Creator: Seidman, Oscar & Donlan, Charles J.
Item Type: Refine your search to only Report
open access

Automatic Stabilization

Description: This report lays more stress on the principles underlying automatic piloting than on the means of applications. Mechanical details of servomotors and the mechanical release device necessary to assure instantaneous return of the controls to the pilot in case of malfunction are not included. Descriptions are provided of various commercial systems.
Date: December 1936
Creator: Haus
Item Type: Refine your search to only Report
open access

Automatic Stabilization

Description: This report concerns the study of automatic stabilizers and extends it to include the control of the three-control system of the airplane instead of just altitude control. Some of the topics discussed include lateral disturbed motion, static stability, the mathematical theory of lateral motion, and large angles of incidence. Various mechanisms and stabilizers are also discussed.
Date: August 1936
Creator: Haus
Item Type: Refine your search to only Report
open access

Behavior of Turbulent Boundary Layers on Curved Convex Walls

Description: The system of linear differential equations which indicated the approach of separation and the so-called "boundary-layer thickness" by Gruschwitz is extended in this report to include the case where the friction layer is subject to centrifugal forces. Evaluation of the data yields a strong functional dependence of the momentum change and wall drag on the boundary-layer thickness radius of curvature ratio for the wall. It is further shown that the transition from laminar to turbulent flow occurs… more
Date: April 1936
Creator: Schmidbauer, Hans
Item Type: Refine your search to only Report
open access

Bending of Beams of Thin Sections

Description: The tendency toward economy of material and lightness of structure has long since led to the increased application of beams having large ratios of moment of area W to cross-sectional area F. This paper tries to provide an answer to how thin the beams can be.
Date: April 1936
Creator: Huber, Maximilian T.
Item Type: Refine your search to only Report
open access

Bibliography of Temperature Measurement: July 1960 to December 1962

Description: Report presenting 700 additional references to the field of temperature measurement as a supplement to NBS Monograph 27, "Bibliography of Temperature Measurement, January 1953 to June 1960" issued April 6, 1961. These references were collected from two general sources: Scientific and technical literature and government reports. The period covered is from July 1960 to December 1962 with some earlier references which were found later. The arrangement of material is the same as in Monograph 27.
Date: September 13, 1936
Creator: Halpern, Carl
Item Type: Refine your search to only Report
open access

Blower Cooling of Finned Cylinders

Description: "Several electrically heated finned steel cylinders enclosed in jackets were cooled by air from a blower. The effect of the air conditions and fin dimensions on the average surface heat-transfer coefficient q and the power required to force the air around the cylinders were determined. Tests were conducted at air velocities between the fins from 10 to 130 miles per hour and at specific weights of the air varying from 0.046 to 0.074 pound per cubic foot. The fin dimensions of the cylinders cover… more
Date: November 14, 1936
Creator: Schey, Oscar W. & Ellerbrock, Herman H., Jr.
Item Type: Refine your search to only Report
open access

Boosted Performance of a Compression-Ignition Engine With a Displaced Piston

Description: From Summary: "Performance tests were made using a rectangular displacer arranged so that the combustion air was forced through equal passages at either end of the displacer into the vertical-disk combustion chamber of a single-cylinder, four-stroke-cycle compression-ignition test engine. After making tests to determine optimum displacer height, shape, and fuel-spray arrangement, engine-performance tests were made at 1,500 and 2,000 r.p.m. for a range of boost pressures from 0 to 20 inches of m… more
Date: May 1936
Creator: Moore, Charles S. & Foster, Hampton H.
Item Type: Refine your search to only Report
open access

Calculated and measured pressure distributions over the midspan section of the NACA 4412 airfoil

Description: Pressures were simultaneously measured in the variable-density tunnel at 54 orifices distributed over the midspan section of 5 by 30 inch rectangular model of the NACA 4412 airfoil at 17 angles of attack ranging from -20 degrees to 30 degrees at a Reynolds number of approximately 3,000,000. Accurate data were thus obtained for studying the deviations of the results of potential-flow theory from measured results. The results of the analysis and a discussion of the experimental technique are pres… more
Date: March 25, 1936
Creator: Pinkerton, Robert M.
Item Type: Refine your search to only Report
open access

Calculated Effect of Various Types of Flap on Take-Off Over Obstacles

Description: "In order to determine whether or not flaps could be expected to have any beneficial effect on take-off performance, the distances required to take off and climb to an altitude of 50 feet were calculated for hypothetical airplanes, corresponding to relatively high-speed types and equipped with several types of flap. The types considered are the Fowler wing, the Hall wing, the split flap, the balanced split flap, the plain flap, and the external-airfoil flap. The results indicate that substantia… more
Date: May 1936
Creator: Wetmore, J. W.
Item Type: Refine your search to only Report
open access

Carbon-monoxide indicators for aircraft

Description: Several improvements that have been made on commercially available carbon-monoxide indicators to make them more suitable for aircraft use are described. These improvements include an automatic flow regulator, which permits the use of a simplified instrument on aircraft where a source of suction is available, and a more reliable alarm attachment. A field method for testing instruments on standard samples of carbon monoxide is described. Performance data and instructions in operation and maintena… more
Date: July 1936
Creator: Womack, S. H. J. & Peterson, J. B.
Item Type: Refine your search to only Report
open access

The Cetene Scale and the Induction Period Preceding the Spontaneous Ignition of Diesel Fuels in Bombs

Description: In the present report a comparison is made between the scale obtained with mixtures of cetane and l-methyl naphthalene in a bomb, and that obtained with the same fuels in a Waukesha engine. The tests were conducted in a metal bomb heated by a Nichrome spiral. The fuel was injected into the bomb from a Bosch jet by means of a specially constructed plunger pump. The instant injection and the pressure curve in the bomb were registered by a beam of light which was reflected from a mirror connected … more
Date: December 1936
Creator: Michailova, M. N. & Neumann, M. B.
Item Type: Refine your search to only Report
open access

Characteristics of six propellers including the high-speed range

Description: This investigation is part of an extensive experimental study that has been carried out at full scale in the NACA 20-foot tunnel, the purpose of which has been to furnish information in regard to the functioning of the propeller-cowling-nacelle unit under all conditions of take-off, climbing, and normal flight. This report presents the results of tests of six propellers in the normal and high-speed flight range and also includes a study of the take-off characteristics.
Date: June 4, 1936
Creator: Theodorsen, Theodore; Stickle, George W. & Brevoort, M. J.
Item Type: Refine your search to only Report
open access

Charts for Calculating the Performance of Airplanes Having Constant-Speed Propellers

Description: "Charts are presented for determining the performance of airplanes having variable-pitch propellers, the pitch of which is assumed to be adjusted to maintain constant speed for all rates of flight. The charts are based on the general performance equations developed by Oswald in reference 1, and are used in a similar manner. Examples applying the charts to airplanes having both supercharged and unsupercharged engines are included" (p. 1).
Date: September 1936
Creator: White, Roland J. & Martin, Victor J.
Item Type: Refine your search to only Report
open access

Charts for Checking the Stability of Compression Members in Trusses

Description: "The present report contains a set of charts developed for computing the fixity effect on a compression member in a truss through its adjacent members, the amount of fixity being considered variable with the particular total truss load. The use of the charts is illustrated on two- and three-bay systems, as well as on a triangular truss" (p. 1).
Date: July 1936
Creator: Borkmann, K.
Item Type: Refine your search to only Report
Back to Top of Screen