UNT Libraries Government Documents Department - 334 Matching Results

Search Results

prev Results: 21 - 44 next
open access

Analysis of variation of piston temperature with piston dimensions and undercrown cooling

Description: From Summary: "A theoretical analysis is presented that permits estimation of the changes in piston-temperature distribution induced by variations in the crown thickness, the ring-groove-pad thickness, and the undercrown surface heat-transfer coefficient. The analysis consists of the calculation of operating temperatures at various points in the piston body on the basis of the experimentally determined surface heat-transfer coefficients and boundary-region temperatures, as well as arbitrarily s… more
Date: January 15, 1948
Creator: Sanders, J. C. & Schramm, W. B.
Item Type: Refine your search to only Report
open access

Analysis of wind-tunnel stability and control tests in terms of flying qualities of full-scale airplanes

Description: From Introduction: "The purpose of this paper is to outline a suggested form of presentation of the results of a stability and control investigation in terms of flying qualities as defined in reference 1 and to systematize and review briefly the analytical work required for this type of presentation. No effort is made to specify definite test procedures."
Date: April 1, 1943
Creator: Kayten, Gerald G.
Item Type: Refine your search to only Report
open access

An apparatus for varying effective dihedral in flight with application to a study of tolerable dihedral on a conventional fighter airplane

Description: From Summary: "An apparatus for varying effective dihedral in flight by means of servo actuation of the ailerons in response to sideslip angle is described. The results of brief flight tests of the apparatus on a conventional fighter airplane are presented and discussed. The results of an investigation employing the apparatus to determine the tolerable (safe for normal fighter operation) range of effective dihedral on the test airplane are presented."
Date: August 24, 1949
Creator: Kauffman, William M.; Liddell, Charles J., Jr.; Smith, Allan & Van Dyke, Rudolph D., Jr.
Item Type: Refine your search to only Report
open access

The application of Green's theorem to the solution of boundary-value problems in linearized supersonic wing theory

Description: From Introduction: "The present paper is restricted to a discussion of wing theory subject to the assumptions of linearized compressible flow. It therefore employs solutions of Laplace's equation and the wave equation for cases where the boundary condition are specified in the plane of the wing."
Date: December 22, 1948
Creator: Heaslet, Max A. & Lomax, Harvard
Item Type: Refine your search to only Report
open access

Application of Radial-Equilibrium Condition to Axial-Flow Compressor and Turbine Design

Description: "Basic general equations governing the three-dimensional compressible flow of gas through a compressor or turbine are given in terms of total enthalpy, entropy, and velocity components of the gas. Two methods of solution are obtained for the simplified, steady axially symmetric flow; one involves the use of a number of successive planes normal to the axis of the machine and short distances apart, and the other involves only three stations for a stage in which an appropriate radial-flow path is … more
Date: January 1, 1949
Creator: Wu, Chung-Hua & Wolfenstein, Lincoln
Item Type: Refine your search to only Report
open access

Application of Spring Tabs to Elevator Controls

Description: Equations are presented for calculating the stick-force characteristics obtained with a spring-tab type of elevator control. The main problems encountered in the design of a satisfactory elevator spring tab are to provide stick forces in the desired range, to maintain the force per g sufficiently constant throughout the speed range, to avoid undesirable "feel" of the control in ground handling or in flight at low airspeeds, and to prevent flutter. Examples are presented to show the design featu… more
Date: November 24, 1944
Creator: Phillips, William H.
Item Type: Refine your search to only Report
open access

Application of the Analogy Between Water Flow With a Free Surface and Two-Dimensional Compressible Gas Flow

Description: "The theory of the hydraulic analogy -- that is, the analogy between water flow with a free surface and two-dimensional compressible gas flow -- and the limitations and conditions of the analogy are discussed. A test was run using the hydraulic analogy as applied to the flow about circular cylinders of various diameters at subsonic velocities extending into the supercritical range. The apparatus and techniques used in this application are described and criticized" (p. 311).
Date: August 21, 1946
Creator: Orlin, W. James; Lindner, Norman J. & Bitterly, Jack G.
Item Type: Refine your search to only Report
open access

Application of the Method of Characteristics to Supersonic Rotational Flow

Description: "A system for calculating the physical properties of supersonic rotational flow with axial symmetry and supersonic rotational flow in a two-dimensional field was determined by use of the characteristics method. The system was applied to the study of external and internal flow for supersonic inlets with axial symmetry. For a circular conical inlet the shock that occurred at the lip of the inlet became stronger as it approached the axis of the inlet and became a normal shock at the axis" (p. 111). more
Date: April 29, 1946
Creator: Ferri, Antonio
Item Type: Refine your search to only Report
open access

The application of the statistical theory of extreme values to gust-load problems

Description: From Introduction: "Recent developments in the statistical theory of extreme values (references 4 to 10) have indicated a somewhat more rational approach to the problem of predicting the probability of occurrence The present report summarizes some of these findings, indicates the method of application, and evaluates their applicability to certain gust-load problems ."
Date: July 22, 1949
Creator: Press, Harry
Item Type: Refine your search to only Report
open access

Application of Theodorsen's theory to propeller design

Description: A theoretical analysis is presented for obtaining, by use of Theodorsen's propeller theory, the load distribution along a propeller radius to give the optimum propeller efficiency for any design condition. The efficiencies realized by designing for the optimum load distribution are given in graphs, and the optimum efficiency for any design condition may be read directly from the graph without any laborious calculations. Examples are included to illustrate the method of obtaining the optimum loa… more
Date: March 15, 1948
Creator: Crigler, John L.
Item Type: Refine your search to only Report
open access

Appreciation and Prediction of Flying Qualities

Description: "The material given in this report summarizes some of the results of recent research that will aid the designers of an airplane in selecting or modifying a configuration to provide satisfactory stability and control characteristics. The requirements of the NACA for satisfactory flying qualities, which specify the important stability and control characteristics of an airplane from the pilot's standpoint, are used as the main topics of the report. A discussion is given of the reasons for the requ… more
Date: April 12, 1948
Creator: Phillips, William H.
Item Type: Refine your search to only Report
open access

Attainable Circulation About Airfoils in Cascade

Description: "From consideration of available information on boundary-layer behavior, a relation among profile thickness, maximum surface velocity, Reynolds number, velocity diagram, and solidity is established for a cascade of airfoils immersed in a two-dimensional incompressible fluid flow. Several cascades are computed to show the effect of various cascade design parameters on minimum required cascade solidity. Comparisons with experimentally determined blade performance show that the derived blade loadi… more
Date: September 1949
Creator: Goldstein, Arthur W. & Mager, Artur
Item Type: Refine your search to only Report
open access

Bending and shear stresses developed by the instantaneous arrest of the root of a moving cantilever beam

Description: A theoretical and experimental investigation has been made of the behavior of a cantilever beam in transverse motion when its root is suddenly brought to rest. Equations are given for determining the stresses, the deflections, and the accelerations that arise in the beam as a result of the impact. The theoretical equations, which have been confirmed experimentally, reveal that, at a given percentage of the distance from root to tip, the bending stresses for a particular mode are independent of … more
Date: September 27, 1944
Creator: Stowell, Elbridge Z.; Schwartz, Edward B. & Houbolt, John C.
Item Type: Refine your search to only Report
open access

Bending of Rectangular Plates With Large Deflections

Description: "The solution of Von Karman's fundamental equations for large deflections of plates is presented for the case of a simply supported rectangular plate under combined edge compression and lateral loading. Numerical solutions are given for square plates and for rectangular plates with a width-span ratio of 3:1. The effective widths under edge compression are compared with effective widths according to Von Karman, Bengston, Marguerre, and Cox and with experimental results by Ramberg, Mcpherson, and… more
Date: May 27, 1941
Creator: Levy, Samuel
Item Type: Refine your search to only Report
open access

Bending-Torsion Flutter Calculations Modified by Subsonic Compressibility Corrections

Description: From Summary: "A number of calculations of bending-torsion wing flutter are made at two Mach numbers, m=0 (incompressible case) and m=0.7, and results are compared. The air forces employed for the case of m=0.7 are based on Frazer's recalculation of Possio's results, which are derived on the assumption of small disturbances to the main flow. For ordinary wings of normal density and of low bending frequency in comparison with torsion frequency, the compressibility correction to the flutter speed… more
Date: December 18, 1945
Creator: Garrick, I. E.
Item Type: Refine your search to only Report
open access

The Calculated Effect of Various Hydrodynamic and Aerodynamic Factors on the Take-Off of a Large Flying Boat

Description: Report presents the results of an investigation made to determine the influence of various factors on the take-off performance of a hypothetical large flying boat by means of take-off calculations. The factors varied in the calculations were size of hull (load coefficient), wing setting, trim, deflection of flap, wing loading, aspect ratio, and parasite drag. The take-off times and distances were calculated to the stalling speeds and the performance above these speeds was separately studied to … more
Date: April 29, 1940
Creator: Olson, R. E. & Allison, J. M.
Item Type: Refine your search to only Report
open access

The calculation of downwash behind supersonic wings with an application to triangular plan forms

Description: A method is developed consistent with the assumptions of small perturbation theory which provides a means of determining the downwash behind a wing in supersonic flow for a known load distribution. The analysis is based upon the use of supersonic doublets which are distributed over the plan form and wake of the wing in a manner determined from the wing loading. The equivalence in subsonic and supersonic flow of the downwash at infinity corresponding to a given load distribution is proved.
Date: November 9, 1948
Creator: Lomax, Harvard; Sluder, Loma & Heaslet, Max A.
Item Type: Refine your search to only Report
open access

Calculation of the aerodynamic loading of swept and unswept flexible wings of arbitrary stiffness

Description: A method is presented for calculating the aerodynamic loading, the divergence speed, and certain stability derivatives of swept and unswept wings and tail surfaces of arbitrary stiffness. Provision is made for using either stiffness curves and root rotation constants or structural influence coefficients in the analysis. Computing forms, tables of numerical constants required in the analysis, and an illustrative example are included to facilitate calculations by means of the method.
Date: December 24, 1948
Creator: Diederich, Franklin W.
Item Type: Refine your search to only Report
open access

Calculations of Economy of 18-Cylinder Radial Aircraft Engine With Exhaust-Gas Turbine Geared to the Crankshaft

Description: Calculations based on dynamometer test-stand data obtained on an 18-cylinder radial engine were made to determine the improvement in fuel consumption that can be obtained at various altitudes by gearing an exhaust-gas turbine to the engine crankshaft in order to increase the engine-shaft work.
Date: January 1, 1945
Creator: Hannum, Richard W. & Zimmerman, Richard H.
Item Type: Refine your search to only Report
open access

Characteristics of Low-Aspect-Ratio Wings at Supercritical Mach Numbers

Description: "The separation of the flow over wings precipitated by the compression shock that forms as speeds are increased into the supercritical Mach number range has imposed serious difficulties in the improvement of aircraft performance. Three difficulties rise principally as a consequence of the rapid drag rise and the loss of lift that causes serious stability changes when the wing shock-stalls. Favorable relieving effects due to the three-dimensional flow around the tips were obtained and these effe… more
Date: 1949
Creator: Stack, John & Lindsey, W. F.
Item Type: Refine your search to only Report
open access

Charts for the Determination of Wing Torsional Stiffness Required for Specified Rolling Characteristics or Aileron Reversal Speed

Description: From Summary :"A series of charts are presented by which the wing torsional stiffness required to meet a given standard of rolling effectiveness may be quickly determined. The charts may also be used to obtain quickly the aileron reversal speed and the variation of the loss in rolling effectiveness with airspeed. The charts apply to linearly tapered wings and elliptical wings of tubular-shell construction having various aspect ratios with aileron span and location of ailerons as variables. In t… more
Date: November 9, 1944
Creator: Pearson, Henry A. & Aiken, William S., Jr.
Item Type: Refine your search to only Report
open access

Charts for the Minimum-Weight Design of 24S-T Aluminum-Alloy Flat Compression Panels With Longitudinal Z-Section Stiffeners

Description: "Design charts are developed for 24S-T aluminum-alloy flat compression panels with longitudinal z-section stiffeners. These charts make possible the design of the lightest panels of this type for a wide range of design requirements. Examples of the use of the charts are given and it is pointed out on the basis of these examples that, over a wide range of design conditions, the maintenance of buckle-free surfaces does not conflict with the achievement of high structural efficiency" (p. 553).
Date: July 9, 1945
Creator: Schuette, Evan H.
Item Type: Refine your search to only Report
Back to Top of Screen