Report details the characteristics and advantages of the swift traffic airplane constructed by Zeppelin Works at Staaken. The maximum speed, weight, construction, layout, and landing capabilities of the plane are included.
The report discusses the problem of rating the various seaplane designs from the 1926 seaplane contest. The whole process of rating consists in measuring the climbing speed, flying weight and carrying capacity of a seaplane and then using these data as the basis of a construction problem.
This report presents a description of an abacus with three scales: one for English measures, one for metric measures, and one with the "points of reduction", as well as construction details. There is also a detailed description on how to use the abacus.
Comparing the results of the calculations for computing the mean pressure of an aviation engine for any number of revolutions, with those of experiment, the writer, by numerous examples, shows the perfect agreement between them. This report will show that, by means of a special abacus, an engineer can instantly plot the characteristics of an engine.
Report discussing the problem to be solved, as presented to the pilot or observer of an aircraft, is as follows: The aircraft starting from A must land at B, the only data being the speed of the airplane, the altitude and the orientation D of the course. The above data would be amply sufficient, were it not for the fact that the airplane is constantly subjected to a wind of variable direction and strength.
Report discussing the use of magnetic fields and wire to navigate aircraft in conditions of poor visibility is presented. This field may be considered to be derived from a double lemniscate, considered in the particular case where the origin is a double point formed from the magnetic field of the slack wire, from the field produced by the return currents and from the field due to the currents induced in the conducting mass. These fields are dephased in two ways, one in the direction of the wire, the other in a direction perpendicular to it.
Report discussing a demonstration was given within the last few days at the British Museum by Mr. J. W. Gordon, author of "Generalized Linear Perspective" (Constable and Co.), a work describing a newly-worked-out system by which photographs can be made available for the purpose of exactly recording the dimensions of the objects photographed even when the objects themselves are presented foreshortened in the photograph.
Report discussing the origin of air traffic dates from the war. The important development of aeronautic industries and the progress made in recent years, under the impelling force of circumstances, rendered it possible, after the close of hostilities, to consider the practical utilization of this new means of economic expansion.
Report discussing before proceeding to discuss the preparation of dope solutions, it will be necessary to consider some of the essential properties which should be possessed of a dope film, deposited in and on the surface of an aero fabric. The first is that it should tighten the material and second it should withstand weathering.
From Introduction: "The increasing use of airplane wings equipped with ailerons and the importance of knowing the aerodynamic characteristics of tail units (empennages) provided with movable parts (rudders and elevators) impart some interest to the so-called "empirical profiles." For this purpose we thought best to employ the method proposed by Munk for the approximate theoretical study of thin, slightly curved profiles, assimilable, from an aerodynamic view-point, to their mean camber line."
From Introduction: "In the following discussion, a knowledge of the theoretical principles of airplane construction is assumed, as presented in detail by Vogt and Lippisch in Nos. 7 and 10-19 of the 1919 volume of this publication. A few quantities will however be otherwise designated, in accordance with the Gottingen symbols."
This report presents a listing of the many experiments in aerodynamics taking place at Cuatro Vientos. Some of the studies include: testing spheres, in order to determine coefficients; mechanical and chemical tests of materials; and various tests of propeller strength and flexibility.
Report presenting a description of the aerodynamics laboratory of the Vienna Technical High School. The main focus of this report is detailing some of the accomplishments that the laboratory has made.
Ballistics is a science hundreds of years old and this report is an attempt to show how these older principles can be used in the newer science of aerodynamics.
The following report endeavors to show that aeromechanical experimentation has become an important aid to theory. Experiments can be tried with separate parts of airplanes or with models of whole airplanes, with propellers, and with anything else that comes into contact with moving air.
"The development of aeronautic instruments. Vibrations, rapid changes of the conditions of flight and of atmospheric conditions, influence of the air stream all call for particular design and construction of the individual instruments. This is shown by certain examples of individual instruments and of various classes of instruments for measuring pressure, change of altitude, temperature, velocity, inclination and turning or combinations of these" (p. 1).
The problem of insuring the emerging commercial aeronautic industry is detailed. The author also motes that a complete solution cannot be obtained until the necessary statistics are compiled.
Different methods of presenting aeronautical artifacts are examined. The advantages of operating an aeronautical museum and its ability to increase public interest in aircraft are provided.
Memorandum presenting an overview of the development of aeronautical industries and commercial aircraft as well as some of the problems that are resulting from it. Details of the aeronautical budget in various countries, organization of the air service, material exports, and airline operations are provided.
In this report is described an experimental method which the writer has evolved for dealing with air-cooled engines, and some of the data obtained by its means. Methods of temperature measurement and cooling are provided.
This report describes the apparatus used to take air-flow photographs. The photographs show chiefly the spiral course of the lines of flow near the tip of the wing. They constitute therefore a visual presentation of the phenomena covered by airfoil theory.
"The question of behavior of a streamlined body with round or square cross-sections is of importance in determining the shape to give an airplane fuselage. It is our task here to show how the lift and drag are affected, with the object placed obliquely to the air stream" (p. 1).
We are undertaking the task of computing the air forces on a slightly cambered airfoil in the absence of friction and with an infinite aspect ratio. We also assume in advance that the leading edge is very sharp and that its tangent lies in the direction of motion.
From Discussion: "To meet these unusual conditions three sets of ball-bearings were employed and arranged in tandem, thereby reducing their speeds by the ratio of the number of sets used, as shown in Fig.3. This proved to be a complete success. The results obtained in experiments with a two-blade, 4 foot propeller of series 2, are given in Fig. 9."
Report presenting the development in air transport that has taken place since civil aviation between England and Europe started at the end of August 1919. The primary subjects explored include the character of loads on aircraft, routes operated, results in passengers carried and efficiency of the service, costs of the service, question of subsidies, and probable future developments.
It has been less well understood that the induced drag (or, better said, the undesired increase in the induced drag as compared with the theoretical minimum calculated by Prandtl) plays a decisive role in the process of taking off and therefore in the requisite engine power. This paper seeks to clarify the induced drag.
The "Bulletin Technique", of March, 1919, gave the results of tests and studies made up to that date in connection with airplane parachutes. This work has been continued.
For some time, the designers of airplanes have begun to occupy themselves with the question of longitudinal stability. In their quest to simplify calculation and data collection, the designers have attached the greatest importance to the coefficient of initial longitudinal stability. In this study a diagram was constructed from the data of the tunnel tests, which depends neither on the position of the center of gravity nor of the angle of deflection of the elevators. This diagram is constructed by means of straight lines drawn through the metacenters of the complete airplane, in a direction parallel to the tangents to the polar of the airplane relative to a system of axes fixed with reference to the airplane.
We are here giving a summary of the rules established by the Theoretical Section of the Central Aerodynamic Institute of Moscow for the different calculation cases of an airplane. It appears the engineers of the Aerodynamic Institute considered only thick or medium profiles. For these profiles they have attempted to increase the safety when the center of pressure moves appreciably toward the trailing edge.
Attempts by other countries to develop patents for alloys similar to duralumin are presented. Duralumin is aluminum alloyed with 3.5-4.5% copper, 0.5% magnesium, and 0.25-1% of manganese. A description of various materials that some have attempted to patent are provided.
The "AM" cock was designed specially for gasoline pipes on vehicles using internal combustion engines (airplanes, airships, automobiles, tractors, battle "tanks", boats, etc.). The report descirbes the functioning and construction of the device.
This airship was built by the Zeppelin Airship Company at Friedrichshafen in 1923-4, for the United States Navy, as the reparations service of the German Government in fulfillment of the treaty of peace. A description of the design, components, flight characteristics, blueprints, and photographs are provided.
The following examples do not take up the discussion of viewpoints to be heeded in determining the design of a framework for given external conditions. Rather they are methods for determining the forces in airplane fuselages and wings, though similar considerations are applied to certain simple cases of a different kind. The object of this treatise is to summarize and amplify these considerations from definite viewpoints.
This report presents an analysis of results of wind-tunnel tests conducted at the D.V.L. Values were determined for the effectiveness of all the controls at various angles of attack. The autorotation was studied by subjecting the rotating model to an air blast.
This report presents a method of calculating polar curves which is at least as precise as graphical methods, but it more rapid. Knowing the wind tunnel test of a wing and the performances of an airplane of the same profile, it is easy to verify the characteristic coefficients and, at the same time, the methods determining induced resistances.
Report presenting an explanation of the Flettner wind-driven rotor ship and how it functions using the "Magnus effect". The advantages of the construction of this type of ship and the development of flow around the cylinder used to power it are described.
This report presents the attempt to develop a law which will permit the use of results obtained on small models in a tunnel for the calculation of full-sized airplanes, or if it exists, a law of similitude relating air forces on a full-sized plane to those on a reduced scale model.
This dialog allows you to filter your current search.
Each of the World Regions listed note their name and the number of records that will be limited down to if you choose that option.
This dialog allows you to filter your current search.
Each of the Countries listed note their name and the number of records that will be limited down to if you choose that option.
This dialog allows you to filter your current search.
Each of the U.S. States listed note their name and the number of records that will be limited down to if you choose that option.
This dialog allows you to filter your current search.
Each of the Counties listed note their name and the number of records that will be limited down to if you choose that option.
This dialog allows you to filter your current search.
Each of the Years listed note their name and the number of records that will be limited down to if you choose that option.
The list can be sorted by name or the count.
This dialog allows you to filter your current search.
Each of the Months listed note their name and the number of records that will be limited down to if you choose that option.
The list can be sorted by name or the count.
This dialog allows you to filter your current search.
Each of the Days listed note their name and the number of records that will be limited down to if you choose that option.