UNT Libraries Government Documents Department - 432,980 Matching Results

Search Results

prev Results: 31 - 54 next
open access

1.2 MW klystron for Asymmetric Storage Ring B Factory

Description: A cw klystron operating at 476 MHz has been developed jointly by SLAC and Varian Associates. The unique set of characteristics of this tube were strongly guided by requirements of the fast feedback necessary to prevent oscillations of the storage ring beams caused by the detuned accelerating cavity. This requires a combination of bandwidth and short group delay within the klystron. The RF feedback stabilization scheme also requires amplitude modulation making it necessary to operate the klystro… more
Date: March 1995
Creator: Fowkes, W. R.; Caryotakis, G. & Doyle, E.
Item Type: Refine your search to only Article
open access

1/2 Sintering of Mullite-Containing Materials: I. Effect of Composition

Description: Sintering behavior of mullite-containing powders was studied over a range of chemical compositions (Al{sub 2}O{sub 3}/SiO{sub 2} ratio). Densification measurements were made for both liquid phase-containing and solid state systems. Small amounts of liquid phase were observed to have a significant effect on densification rate. A linear relationship was obtained between the percent of theoretical density and the logarithm of time for compositions in the range 73-75 wt% Al{sub 2}O{sub 3}. Currentl… more
Date: December 1, 1981
Creator: Sacks, Michael D. & Pask, Joseph A.
Item Type: Refine your search to only Article
open access

1/2/Sup +/. -->. 1/2/Sup -/ Beta Decay of /Sup 19/Ne and the Parity Nonconserving Nn Force

Description: A branching ratio of (1.20 +- 0.20) x 10/sup -4/ is obtained for the ..beta../sup +/ decay of /sup 19/Ne to the 110 keV 1/2/sup -/ level of /sup 19/F. This transition (presumably dominated by the ..delta..J/sup ..pi../ = 0/sup -/ axial charge operator) provides a crucial test of wavefunctions used in interpreting the parity mixing of the ground and 110 keV levels of /sup 19/F. These wavefunctions, which yield a parity mixing larger than that observed experimentally, also predict too large a ..b… more
Date: 1978~
Creator: Adelberger, E. G.; Hindi, M. M.; Hoyle, C. D.; Swanson, H. E. & Von Lintig, R. D.
Item Type: Refine your search to only Report
open access

1.3 GHz superconducting RF cavity program at Fermilab

Description: At Fermilab, 9-cell 1.3 GHz superconducting RF (SRF) cavities are prepared, qualified, and assembled into cryomodules (CMs) for Project X, an International Linear Collider (ILC), or other future projects. The 1.3 GHz SRF cavity program includes targeted R&D on 1-cell 1.3 GHz cavities for cavity performance improvement. Production cavity qualification includes cavity inspection, surface processing, clean assembly, and one or more cryogenic low-power CW qualification tests which typically inc… more
Date: March 1, 2011
Creator: Ginsburg, C. M.; Arkan, T.; Barbanotti, S.; Carter, H.; Champion, M.; Cooley, L. et al.
Item Type: Refine your search to only Article
open access

1,3-Propanediol Made From Fermentation-Derived Malonic Acid: Office of Industrial Technologies (OIT) Agriculture Project Fact Sheet

Description: 1,3-Propanediol is one of two ingredients used in producing polytrimethylene terephthalate (PTT), a polymer which can be used in polyester and nylon applications. Researchers are developing a process to ferment biomass feedstock to malonic acid using filamentous fungi and then catalytically convert malonic acid to 1,3-propanediol.
Date: September 12, 2001
Creator: Carde, T.
Item Type: Refine your search to only Book
open access

1,4-diphenylbutadiyne as a potential tritium getter

Description: Research on the acetylene compound 1,4-diphenylbutadiyne is an effort to develop an air-operative tritium gas scavenger. T/sub 2/ adds to the acetylene bond of the organic in the presence of a metal catalyst. The catalyst also stimulates the oxidation reaction as well. The butadiyne compound has shown good reaction efficiency at 300 ppM T/sub 2/ in static dry air. At this concentration 75% of the scavenged tritium was in the organic. This work has expanded to the investigation of liquid acetyle… more
Date: October 1, 1980
Creator: Miller, H. H.; Bissell, E. E.; Tsugawa, R. T. & Souers, P. C.
Item Type: Refine your search to only Article
open access

A 1. 5--4 Kelvin detachable cold-sample transfer system: Application to inertially confined fusion with spin-polarized hydrogens fuels

Description: A compact cold-transfer apparatus for engaging and retrieving samples at liquid helium temperatures (1.5--4K), maintaining the samples at such temperatures for periods of hours, and subsequently inserting them in diverse apparatuses followed by disengagement, is described. The properties of several thermal radiation-insulating shrouds, necessary for very low sample temperatures, are presented. The immediate intended application is transportable target-shells containing highly spin-polarized deu… more
Date: January 1, 1990
Creator: Alexander, N.; Barden, J.; Fan, Q. & Honig, A.
Item Type: Refine your search to only Report
open access

1. 5 GeV/c multiturn shaving extraction and its transport line for the Brookhaven AGS

Description: A system for fast shaving extraction at 1.5 GeV/c is implemented to extract the circulating beam in five turns. A numerical simulation is first carried out to determine the emittance and the rf structure of the extracted beam. This is followed by several machine study sessions which establish the optimal extraction configuration, confirm the emittance, and modify the transport line for low energy beam. Finally, a one-week run for the Neutrino Oscillation experiment demonstrates that the system … more
Date: January 1, 1979
Creator: Weng, W. T.; Blumberg, L. N.; Gill, E.; Soukas, A.; Witkover, R. L.; Egleman, E. et al.
Item Type: Refine your search to only Article
open access

A 1.5 GeV compact light source with superconducting bending magnets

Description: This paper describes the design of a compact electron synchrotron light source for producing X-rays for medical imaging, protein crystallography, nano-machining and other uses up to 35 keV. The source will provide synchrotron light from six 6.9 tesla superconducting 60{degree} bending magnet stations. In addition the ring, contains conventional quadrupoles and sextupoles. The light source has a circumference of 26 meters, which permits it to be located in a variety of industrial and medical fac… more
Date: May 1995
Creator: Garren, A. A.; Cline, D. B.; Kolonko, J. J.; Green, M. A.; Johnson, D. E.; Leung, E. M. et al.
Item Type: Refine your search to only Article
open access

1.5-GEV FFAG ACCELERATOR AS INJECTOR TO THE BNL-AGS.

Description: A 1.5-GeV Fixed-Field Alternating-Gradient (FFAG) proton Accelerator is being studied as a new injector to the Alternating-Gradient Synchrotron (AGS) of Brookhaven National Laboratory (BNL). The major benefit is that it would considerably shorten the overall AGS acceleration cycle, and, consequently, may yield to an improvement of beam stability, intensity and size. The AGS-FFAG will also facilitate the proposed upgrade of the AGS facility toward a 1-MW average proton beam power at the top ener… more
Date: July 5, 2004
Creator: Ruggiero, A. G.; Blaskiewicz, M.; Trbojevic, D.; Tsoupas, N. & Zhang, W.
Item Type: Refine your search to only Article
open access

1.5 megawatt dc chopper power supplies for plasma shape control on Doublet III

Description: The Doublet III device is designed to study noncircular plasmas, including doublet and dee-shaped cross-sections. The plasma shape is determined by a system of 24 field-shaping coils which surround the vacuum vessel. Control of the magnetic flux linking these coils allows the plasma shape to be varied and controlled. This paper describes the high-speed dc chopper which is a major component of the field-shaping coil power system. The high-speed dc choppers, with a frequency response of up to 5 k… more
Date: November 1979
Creator: Rock, P. J. & Wesley, J. C.
Item Type: Refine your search to only Article
open access

1/5-scale experiment of a Mark I boiling-water reactor pressure-suppression system under hypothetical LOCA conditions

Description: Experimental results show the sensitivity of hydrodynamically generated vertical loads to changes in the drywell pressurization rate, downcomer submergence, and vent-line loss coefficient. Insignificant effects on peak vertical loads were observed when the vent-line loss was varied. Peak vertical loads can be reduced by adding initial drywell overpressure so that the downcomers are partly cleared of water. Spatial variation of pressure at about the time of vent clearing is seen in comparisons o… more
Date: July 8, 1977
Creator: Pitts, J. H. & McCauley, E. W.
Item Type: Refine your search to only Article
open access

1.06 ÎĽm 150 psec laser damage study of diamond turned, diamond turned/ polished and polished metal mirrors

Description: Using a well characterized 1.06 μm 150 ps glass laser pulse the damage characteristics for diamond turned, diamond turned/ polished, and polished copper and silver mirrors less than 5 cm diameter were studied. Although most samples were tested with a normal angle of incidence, some were tested at 45$sup 0$ with different linear polarization showing an increase in damage threshold for S polarization. Different damage mechanisms observed will be discussed. Laser damage is related to residual surf… more
Date: July 24, 1975
Creator: Saito, T. T.; Milam, D.; Baker, P. & Murphy, G.
Item Type: Refine your search to only Article
open access

1.8.2.1.2 Site system engineering implementation Fiscal Year 1998 multi-year work plan

Description: Manage the Site Systems Engineering process to provide a traceable, integrated, requirements-driven, and technically defensible baseline., Through the Site Integration Group, Systems Engineering ensures integration of technical activities across all site projects. Systems Engineering`s primary interfaces are with the Project Direction Office and with the projects, as well as with the Planning organization.
Date: October 3, 1997
Creator: Ferguson, J. E.
Item Type: Refine your search to only Report
open access

1.8.3 Site system engineering FY 1997 program plan

Description: The FY 1997 Multi-Year Work Plan (MYWP) technical baseline describes the functions to be accomplished and the technical standards that govern the work. The following information is provided in this FY 1997 MYWP: technical baseline, work breakdown structure, schedule baseline, cost baseline, and execution year.
Date: September 13, 1996
Creator: Grygiel, M. L.
Item Type: Refine your search to only Report
open access

A 1.8 K test facility for superconducting RF cavities

Description: To demonstrate the feasibility of superconducting RF technology for a high energy e{sup +}/e{sup {minus}} collider, a research and development program has begun with collaborators from Europe, Asia, and North America. The immediate goal of the R&D program is to build and operate a 50 meter-long linac at DESY with 1.3 GHz superconducting RF cavities at a temperature of 1.8 K - 2.0 K and an accelerating gradient of 15 MV/meter. The refrigeration for the test system at DESY initially will have a c… more
Date: April 1, 1994
Creator: Horlitz, G.; Knopf, U.; Lange, R.; Petersen, B.; Sellmann, D.; Trines, D. et al.
Item Type: Refine your search to only Article
Back to Top of Screen