UNT Libraries Government Documents Department - 107 Matching Results

Search Results

open access

100 Areas technical activities report: Engineering, August 1947

Description: There were seven charges of metal inspected during the month for corrosion and blistering studies. There were no unusual cases of blistering noted and the corrosion rates were normal for this time of year. Borescopic examination of the graphite packing around the ``B`` Hole in the F Pile revealed that the graphite is no more severely cracked than in the D Pile when it was inspected about a year ago. Examination of the graphite at the downstream and of Tube 1385-D did not indicate that any damag… more
Date: September 22, 1947
Creator: Woods, W. K.
open access

100 Areas technical activities report: Physics, July 1949

Description: The pile physics group reports on reactivity power coefficients from the production test No. 105-248-P, the water leak in B pile, graphite properties, xenon equations from the B pile shutdown of March 1946, and reactivity balance. The experimental physics group headed by J.M. West reports on graphite testing, the P-11 project, and shielding. The experimental physics group headed by E.B. Montgomery reports on diffusion length measurements in the DR and H piles. (GHH)
Date: August 22, 1949
Creator: Staebler, U. M.
open access

100-F area unit purge, May 3, 1945

Description: This report discusses the pressure drop on the 100-F unit, as measured on the eight pressure drop tubes, which had increased to 24 lbs./in.{sup 2} above base by May 2. The unit was shut down on May 3 to purge with 50 ppm solids for 1.1 hr. and to take care of necessary maintenance work.
Date: May 22, 1945
Creator: Kiddker, C. P.
open access

234-5 Project specification letter 234-41, 235-41 (Supplement D), Chemical Development Laboratory

Description: This letter itemizes the miscellaneous equipment and supplies not previously specified which should be ordered to equip the 234-5 Chemical Development Laboratory. Equipment currently carried in store stock is not included in this list. The vendor is given only to identify the item or as a suggested source of supply.
Date: October 22, 1948
Creator: Work, J.B.
open access

300 Area, February 12 through February 18

Description: Extrusion was run on one day, February 2, and a total of 271 billets (178 Type G, 12 type BT, and 81 red band) were processed. Two failures occurred among the red band billets; UM 6610 had begun to melt in the furnace and TX 3323 disintegrated on being extruded through the die. Samples of these billets are being checked chemically and metallurgically in an attempt to ascertain the cause for the hot-short characteristics of these billets. A sample cut from a rod which possessed zero strength (fe… more
Date: February 22, 1946
open access

Aircraft woodwork.

Description: Discusses woodworking in aircraft manufacturing in general, and in detail the characteristics of wood, the glue and hardware necessary, hand tools and machines, as well as repair of the aircraft.
Date: December 22, 1942
Creator: United States. War Department.
open access

Altitude-Wind-Tunnel Investigation of Westinghouse 19B-2 19B-8, and 19XB-1 Jet-Propulsion Engines, Part 1, Operational Characteristics

Description: From Summary: "An investigation was conducted in the NACA Cleveland altitude wind tunnel to determine the operational characteristics of the Westinghouse 19B-2, 19B-8, and 19XB-l jet-propulsion engines. The 19B engine is one of the earliest experimental Westinghouse axial flow engines. The 19XB-1 engine is an experimental prototype of the Westinghouse 15 series, having a rated thrust of 1400 pounds. Improvements in performance and operational characteristics have resulted in the 19XB-2B engine … more
Date: November 22, 1948
Creator: Fleming, William A.
open access

Analyses of Decay Curves of Irradiated Plastics

Description: The following report covers the results of a general program that was conducted at the Oak Ridge National Laboratory to investigate the effects on plastic materials of exposure to radiation in the pile. In the investigation, several plastics were irradiated, and on removal from the pile, their rates of decay were determined by measurement of gamma activity in an ionization chamber.
Date: June 22, 1949
Creator: Saleeby, R. N.; Cheshire, J. R. & Jensen, W. P.
open access

An Analysis of Project Data on the Corrosion of Uranium in Various Media

Description: This is a summarizing and reviewing report in which almost all the experimental data representing Project work done prior to 1949 on the corrosion of pure uranium are brought together and analyzed. New data obtained in this laboratory on corrosion rates in laboratory atmosphere and on the identification of corrosion products by electron diffraction are included. The data for corrosion in each of several different media have been plotted according to logarithm-of-the-rate versus reciprocal-tempe… more
Date: December 22, 1948
Creator: Waber, James T. (James Thomas), 1920-
open access

The application of Green's theorem to the solution of boundary-value problems in linearized supersonic wing theory

Description: From Introduction: "The present paper is restricted to a discussion of wing theory subject to the assumptions of linearized compressible flow. It therefore employs solutions of Laplace's equation and the wave equation for cases where the boundary condition are specified in the plane of the wing."
Date: December 22, 1948
Creator: Heaslet, Max A. & Lomax, Harvard
open access

The application of the statistical theory of extreme values to gust-load problems

Description: From Introduction: "Recent developments in the statistical theory of extreme values (references 4 to 10) have indicated a somewhat more rational approach to the problem of predicting the probability of occurrence The present report summarizes some of these findings, indicates the method of application, and evaluates their applicability to certain gust-load problems ."
Date: July 22, 1949
Creator: Press, Harry
open access

Columbia River temperature study at 100-F Area

Description: In August 1946 it was discovered that two effluent lines near the Columbia River at Hanford were damaged. The upstream effluent line has broken off 37 fact from the shoreline and the downstream effluent line had been bent and partly broken seventeen feet from shoreline and has swung downstream to a point about 50 feet from shorelines. This study was made to determine how fast and in what fashion the temperature of the effluent water is dissipated in the Columbia River under the present conditio… more
Date: October 22, 1946
Creator: Lewis, W. R. & Rohrbacher, R. A.
open access

Comparison of National Bureau of Standards ceramic coatings L-7C and A-417 on turbine blades in a turbojet engine

Description: Report presenting an investigation to determine which of two ceramic coatings, L-7C and A-417, developed by the National Bureau of Standards is more suitable as a protective coating for turbine blades in a turbojet engine. Four cast Vitallium turbine blades, two coated with each of the ceramics, were installed in a turbine wheel of a turbojet engine and subjected to accelerated cyclic life tests.
Date: December 22, 1948
Creator: Morse, C. Robert
open access

Control Chart Method Applied to Errors in Radioactive Counting

Description: Abstract: The Control Chart statistical methods, developed by Showhart for the control of quality of manufactured products, are applied to the control of Geiger-Miller counting instruments. Experiments are reported to show the use to the Control Chart method for detecting disturbances in instrumental behavior and for detecting radioactive effects so weak that they are near the limit of detection of the instruments. As a corollary, the control chart can be used to reduce to its practical limit t… more
Date: February 22, 1947
Creator: Schlecht, W. G.
open access

Correlation of the Trim Limits of Stability Obtained for a PB2Y-3 Flying Boat and a 1/8-Size Powered Dynamic Model

Description: Tests of a PB2Y-3 flying boat were made at the U.S. Naval Air Station, Patuxent River, Md., to determine its hydrodynamic trim limits of stability. Corresponding tests were also made of a 1/8-size powered dynamic model of the same flying boat in Langley tank no. 1. During the tank tests, the full-size testing procedure was reproduced as closely as possible in order to obtain data for a direct correlation of the results. As a nominal gross load of 66,000 pounds, the lower trim limits of the full… more
Date: April 22, 1947
Creator: Garrison, Charlie C.; Goldenbaum, David M. & Hacskaylo, Andrew
Back to Top of Screen