You limited your search to:

  Partner: UNT Libraries
 Decade: 2000-2009
 Degree Discipline: Computer Engineering
 Collection: UNT Theses and Dissertations
A New N-way Reconfigurable Data Cache Architecture for Embedded Systems

A New N-way Reconfigurable Data Cache Architecture for Embedded Systems

Access: Use of this item is restricted to the UNT Community.
Date: December 2009
Creator: Bani, Ruchi Rastogi
Description: Performance and power consumption are most important issues while designing embedded systems. Several studies have shown that cache memory consumes about 50% of the total power in these systems. Thus, the architecture of the cache governs both performance and power usage of embedded systems. A new N-way reconfigurable data cache is proposed especially for embedded systems. This thesis explores the issues and design considerations involved in designing a reconfigurable cache. The proposed reconfigurable data cache architecture can be configured as direct-mapped, two-way, or four-way set associative using a mode selector. The module has been designed and simulated in Xilinx ISE 9.1i and ModelSim SE 6.3e using the Verilog hardware description language.
Contributing Partner: UNT Libraries
FPGA Implementation of Low Density Party Check Codes Decoder

FPGA Implementation of Low Density Party Check Codes Decoder

Date: August 2009
Creator: Vijayakumar, Suresh
Description: Reliable communication over the noisy channel has become one of the major concerns in the field of digital wireless communications. The low density parity check codes (LDPC) has gained lot of attention recently because of their excellent error-correcting capacity. It was first proposed by Robert G. Gallager in 1960. LDPC codes belong to the class of linear block codes. Near capacity performance is achievable on a large collection of data transmission and storage.In my thesis I have focused on hardware implementation of (3, 6) - regular LDPC codes. A fully parallel decoder will require too high complexity of hardware realization. Partly parallel decoder has the advantage of effective compromise between decoding throughput and high hardware complexity. The decoding of the codeword follows the belief propagation alias probability propagation algorithm in log domain. A 9216 bit, (3, 6) regular LDPC code with code rate ┬Ż was implemented on FPGA targeting Xilinx Virtex 4 XC4VLX80 device with package FF1148. This decoder achieves a maximum throughput of 82 Mbps. The entire model was designed in VHDL in the Xilinx ISE 9.2 environment.
Contributing Partner: UNT Libraries
Region aware DCT domain invisible robust blind watermarking for color images.

Region aware DCT domain invisible robust blind watermarking for color images.

Date: December 2008
Creator: Naraharisetti, Sahasan
Description: The multimedia revolution has made a strong impact on our society. The explosive growth of the Internet, the access to this digital information generates new opportunities and challenges. The ease of editing and duplication in digital domain created the concern of copyright protection for content providers. Various schemes to embed secondary data in the digital media are investigated to preserve copyright and to discourage unauthorized duplication: where digital watermarking is a viable solution. This thesis proposes a novel invisible watermarking scheme: a discrete cosine transform (DCT) domain based watermark embedding and blind extraction algorithm for copyright protection of the color images. Testing of the proposed watermarking scheme's robustness and security via different benchmarks proves its resilience to digital attacks. The detectors response, PSNR and RMSE results show that our algorithm has a better security performance than most of the existing algorithms.
Contributing Partner: UNT Libraries
A CAM-based, high-performance classifier-scheduler for a video network processor.

A CAM-based, high-performance classifier-scheduler for a video network processor.

Date: May 2008
Creator: Tarigopula, Srivamsi
Description: Classification and scheduling are key functionalities of a network processor. Network processors are equipped with application specific integrated circuits (ASIC), so that as IP (Internet Protocol) packets arrive, they can be processed directly without using the central processing unit. A new network processor is proposed called the video network processor (VNP) for real time broadcasting of video streams for IP television (IPTV). This thesis explores the challenge in designing a combined classification and scheduling module for a VNP. I propose and design the classifier-scheduler module which will classify and schedule data for VNP. The proposed module discriminates between IP packets and video packets. The video packets are further processed for digital rights management (DRM). IP packets which carry regular traffic will traverse without any modification. Basic architecture of VNP and architecture of classifier-scheduler module based on content addressable memory (CAM) and random access memory (RAM) has been proposed. The module has been designed and simulated in Xilinx 9.1i; is built in ISE simulator with a throughput of 1.79 Mbps and a maximum working frequency of 111.89 MHz at a power dissipation of 33.6mW. The code has been translated and mapped for Spartan and Virtex family of devices.
Contributing Partner: UNT Libraries
Modeling and reduction of gate leakage during behavioral synthesis of nanoscale CMOS circuits.

Modeling and reduction of gate leakage during behavioral synthesis of nanoscale CMOS circuits.

Access: Use of this item is restricted to the UNT Community.
Date: May 2006
Creator: Velagapudi, Ramakrishna
Description: The major sources of power dissipation in a nanometer CMOS circuit are capacitive switching, short-circuit current, static leakage and gate oxide tunneling. However, with the aggressive scaling of technology the gate oxide direct tunneling current (gate leakage) is emerging as a prominent component of power dissipation. For sub-65 nm CMOS technology where the gate oxide (SiO2) thickness is very low, the direct tunneling current is the major form of tunneling. There are two contribution parts in this thesis: analytical modeling of behavioral level components for direct tunneling current and propagation delay, and the reduction of tunneling current during behavioral synthesis. Gate oxides of multiple thicknesses are useful in reducing the gate leakage dissipation. Analytical models from first principles to calculate the tunneling current and the propagation delay of behavioral level components is presented, which are backed by BSIM4/5 models and SPICE simulations. These components are characterized for 45 nm technology and an algorithm is provided for scheduling of datapath operations such that the overall tunneling current dissipation of a datapath circuit under design is minimal. It is observed that the oxide thickness that is being considered is very low it may not remain constant during the course of fabrication. Hence ...
Contributing Partner: UNT Libraries
Design and Optimization of Components in a 45nm CMOS Phase Locked Loop

Design and Optimization of Components in a 45nm CMOS Phase Locked Loop

Access: Use of this item is restricted to the UNT Community.
Date: December 2006
Creator: Sarivisetti, Gayathri
Description: A novel scheme of optimizing the individual components of a phase locked loop (PLL) which is used for stable clock generation and synchronization of signals is considered in this work. Verilog-A is used for the high level system design of the main components of the PLL, followed by the individual component wise optimization. The design of experiments (DOE) approach to optimize the analog, 45nm voltage controlled oscillator (VCO) is presented. Also a mixed signal analysis using the analog and digital Verilog behavior of components is studied. Overall a high level system design of a PLL, a systematic optimization of each of its components, and an analog and mixed signal behavioral design approach have been implemented using cadence custom IC design tools.
Contributing Partner: UNT Libraries
Comparison and Evaluation of Existing Analog Circuit Simulator using Sigma-Delta Modulator

Comparison and Evaluation of Existing Analog Circuit Simulator using Sigma-Delta Modulator

Access: Use of this item is restricted to the UNT Community.
Date: December 2006
Creator: Ale, Anil Kumar
Description: In the world of VLSI (very large scale integration) technology, there are many different types of circuit simulators that are used to design and predict the circuit behavior before actual fabrication of the circuit. In this thesis, I compared and evaluated existing circuit simulators by considering standard benchmark circuits. The circuit simulators which I evaluated and explored are Ngspice, Tclspice, Winspice (open source) and Spectre® (commercial). I also tested standard benchmarks using these circuit simulators and compared their outputs. The simulators are evaluated using design metrics in order to quantify their performance and identify efficient circuit simulators. In addition, I designed a sigma-delta modulator and its individual components using the analog behavioral language Verilog-A. Initially, I performed simulations of individual components of the sigma-delta modulator and later of the whole system. Finally, CMOS (complementary metal-oxide semiconductor) transistor-level circuits were designed for the differential amplifier, operational amplifier and comparator of the modulator.
Contributing Partner: UNT Libraries
Timing and Congestion Driven Algorithms for FPGA Placement

Timing and Congestion Driven Algorithms for FPGA Placement

Date: December 2006
Creator: Zhuo, Yue
Description: Placement is one of the most important steps in physical design for VLSI circuits. For field programmable gate arrays (FPGAs), the placement step determines the location of each logic block. I present novel timing and congestion driven placement algorithms for FPGAs with minimal runtime overhead. By predicting the post-routing timing-critical edges and estimating congestion accurately, this algorithm is able to simultaneously reduce the critical path delay and the minimum number of routing tracks. The core of the algorithm consists of a criticality-history record of connection edges and a congestion map. This approach is applied to the 20 largest Microelectronics Center of North Carolina (MCNC) benchmark circuits. Experimental results show that compared with the state-of-the-art FPGA place and route package, the Versatile Place and Route (VPR) suite, this algorithm yields an average of 8.1% reduction (maximum 30.5%) in the critical path delay and 5% reduction in channel width. Meanwhile, the average runtime of the algorithm is only 2.3X as of VPR.
Contributing Partner: UNT Libraries
Energy-Aware Time Synchronization in Wireless Sensor Networks

Energy-Aware Time Synchronization in Wireless Sensor Networks

Date: December 2006
Creator: Saravanos, Yanos
Description: I present a time synchronization algorithm for wireless sensor networks that aims to conserve sensor battery power. The proposed method creates a hierarchical tree by flooding the sensor network from a designated source point. It then uses a hybrid algorithm derived from the timing-sync protocol for sensor networks (TSPN) and the reference broadcast synchronization method (RBS) to periodically synchronize sensor clocks by minimizing energy consumption. In multi-hop ad-hoc networks, a depleted sensor will drop information from all other sensors that route data through it, decreasing the physical area being monitored by the network. The proposed method uses several techniques and thresholds to maintain network connectivity. A new root sensor is chosen when the current one's battery power decreases to a designated value. I implement this new synchronization technique using Matlab and show that it can provide significant power savings over both TPSN and RBS.
Contributing Partner: UNT Libraries
VLSI Architecture and FPGA Prototyping of a Secure Digital Camera for Biometric Application

VLSI Architecture and FPGA Prototyping of a Secure Digital Camera for Biometric Application

Date: August 2006
Creator: Adamo, Oluwayomi Bamidele
Description: This thesis presents a secure digital camera (SDC) that inserts biometric data into images found in forms of identification such as the newly proposed electronic passport. However, putting biometric data in passports makes the data vulnerable for theft, causing privacy related issues. An effective solution to combating unauthorized access such as skimming (obtaining data from the passport's owner who did not willingly submit the data) or eavesdropping (intercepting information as it moves from the chip to the reader) could be judicious use of watermarking and encryption at the source end of the biometric process in hardware like digital camera or scanners etc. To address such issues, a novel approach and its architecture in the framework of a digital camera, conceptualized as an SDC is presented. The SDC inserts biometric data into passport image with the aid of watermarking and encryption processes. The VLSI (very large scale integration) architecture of the functional units of the SDC such as watermarking and encryption unit is presented. The result of the hardware implementation of Rijndael advanced encryption standard (AES) and a discrete cosine transform (DCT) based visible and invisible watermarking algorithm is presented. The prototype chip can carry out simultaneous encryption and watermarking, which ...
Contributing Partner: UNT Libraries
FIRST PREV 1 2 NEXT LAST