UNT Theses and Dissertations - 11 Matching Results

Search Results

Results: 1 - 11
open access

Investigation of growth kinetics of self-assembling monolayers by means of contact angle, optical ellipsometry, angle-resolved XPS and IR spectroscopy.

Description: Absorption of octadecanethiol and p-nitrobenzenethiol onto gold surfaces from ethanol solutions has been studied by means of contact angle, optical ellipsometry, angle-resolved XPS (ARXPS), and with grazing angle total reflection FTIR. Growth of the monolayers from dilute solutions has been monitored and Langmuir isotherm adsorption curves were fitted to experimental data. A saturated film is formed within approximately 5h after immersion in solutions of concentrations ranging from 0.0005mM to … more
Date: August 2004
Creator: Jakubowicz, Agnieszka
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Stability of Field Emitter Arrays to Oxygen Exposures

Description: The purpose of these experiments was to determine the degradation mechanisms of molybdenum based field emitter arrays to oxygen exposures and to improve the overall reliability. In addition, we also evaluated the emission current stability of gold-coated field emitter arrays to oxygen exposures. oxygen at 1x10-6 torr was introduced into the chamber through a leak valve for different lengths of time and duty cycles. To ensure identical oxygen exposure and experimental measurement conditions, ti… more
Date: December 2002
Creator: Godbole, Soumitra Kumar
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Application of Thermomechanical Characterization Techniques to Bismuth Telluride Based Thermoelectric Materials

Description: The thermoelectric properties of bismuth telluride based thermoelectric (TE) materials are well-characterized, but comparatively little has been published on the thermomechanical properties. In this paper, dynamic mechanical analysis (DMA) and differential scanning calorimetry data for bismuth telluride based TE materials is presented. The TE materials' tan delta values, indicative of viscoelastic energy dissipation modes, approached that of glassy or crystalline polymers, were greater than ten… more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: August 2002
Creator: White, John B.
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Influence of design and coatings on the mechanical reliability of semiconductor wafers.

Description: We investigate some of the mechanical design factors of wafers and the effect on strength. Thin, solid, pre-stressed films are proposed as a means to improve the bulk mechanical properties of a wafer. Three-point bending was used to evaluate the laser scribe density and chemical processing effect on wafer strength. Drop and strike tests were employed to investigate the edge bevel profile effect on the mechanical properties of the wafer. To characterize the effect of thin films on stren… more
Date: August 2002
Creator: Yoder, Karl J.
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Mechanical Properties of Polymer Modified Mortar

Description: The mechanical properties of the polymer-modified mortar are markedly improved over conventional cement mortar. We utilized recycled ABS in powder form and a polymer latex emulsion, polymer percentage ranges from 0 to 25 percent by polymer/cement ratio were investigated. The mechanical properties investigated were compression strength and adhesion strength. Compression strength effects did not have an impact on adhesion strength. Adhesion strength was calculated with pullout testing apparatus … more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: August 2002
Creator: Palos, Artemio
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Hypotheses for Scratch Behavior of Polymer Systems that Recover

Description: Scratch recovery is a desirable property of many polymer systems. The reason why some materials have demonstrated excellent scratch recovery while others do not has been a mystery. Explaining the scratch resistance based upon the hardness of a material or its crosslink density is incorrect. In this thesis, novel polymers were tested in an attempt to discover materials that show excellent scratch recovery - one of the most important parameters in determining the wear of a material. Several hypo… more
Date: May 2002
Creator: Bujard, Bernard
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Characterizaton of Triethoxyfluorosilane and Tetraethoxysilane Based Aerogels

Description: Aerogels are highly porous, low dielectric constant (low k) materials being considered by the semiconductor industry as an interlayer dielectric. Low k materials are needed to overcome capacitance problems that limit device feature sizes. Precursors triethoxyfluorosilane (TEFS) and tetraethoxysilane (TEOS) were used to prepare bulk aerogels. Samples were prepared by sol-gel methods, and then carbon dioxide supercritically-dried. Effects of varying the water to precursor ratio were studied with … more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: December 2001
Creator: Roepsch, Jodi Ann
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Mineral-filled polypropylene: Improvement of scratch resistance

Description: A potential alternative to acrylonitrile-butadiene-styrene (ABS) and polycarbonate+ABS (PC+ABS), pigmented mineral-filled polypropylene (PP) finds an opening in automotive interior components such as instrument panels, knee bolsters, consoles, etc. Because of the lack of surface aesthetics, pigmented mineral-filled PP is experiencing a limitation to its acceptance in many applications. This study focuses on exploring various mineral fillers and additives in polypropylene to provide a material w… more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: December 2001
Creator: Khatib, Jamal F.
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Polyamide-imide and Montmorillonite Nanocomposites

Description: Solvent suspensions of a high performance polymer, Polyamide-imide (PAI) are widely used in magnetic wire coatings. Here we investigate the effect that the introduction of montmorillonite (MMT) has on PAI. MMT was introduced into an uncured PAI suspension; the sample was then cured by step-wise heat treatment. Polarized optical microscopy was used to choose the best suitable MMT for PAI matrix and to study the distribution of MMT in PAI matrix. Concentration dependent dispersion effect was stud… more
Date: August 2001
Creator: Ranade, Ajit
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Thermal, Electrical, and Structural Analysis of Graphite Foam

Description: A graphite foam was developed at Oak Ridge National Laboratory (ORNL) by Dr. James Klett and license was granted to POCO Graphite, Inc. to manufacture and market the product as PocoFoam™. Unlike many processes currently used to manufacture carbon foams, this process yields a highly graphitic structure and overcomes many limitations, such as oxidation stabilization, that are routinely encountered in the development of carbon foam materials. The structure, thermal properties, electrical resistiv… more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: August 2001
Creator: Morgan, Dwayne Russell
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Preparation and Characterization of a Treated Montmorillonite Clay and Epoxy Nanocomposite

Description: Montmorillonite reinforced polymers are a new development in the area of nanocomposite materials. Since reinforcement of epoxy is important to the development of high strength adhesives and composite matrices, the introduction of montmorillonite to epoxy is of interest. Compositional effects on epoxy reactivity, on molecular relaxation, and on mechanical properties were investigated. Change in reactivity was determined by Differential Scanning Calorimetry. Tensile properties at room temperature… more
Date: December 2000
Creator: Butzloff, Peter Robert
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
Back to Top of Screen