You limited your search to:

  Partner: UNT Libraries
 Department: College of Engineering
 Decade: 2010-2019
 Collection: UNT Theses and Dissertations
Tesla Turbine Torque Modeling for Construction of a Dynamometer and Turbine

Tesla Turbine Torque Modeling for Construction of a Dynamometer and Turbine

Date: May 2011
Creator: Emran, Tamir Ali
Description: While conventional turbines have been extensively researched and tested, Tesla and boundary layer type turbines have not. In order to construct a dynamometer, thermodynamic flow apparatus and future turbines, we modeled the Tesla turbine using theoretical calculations and preliminary experiments. Thus a series of experiments were run to determine stall torque and maximum run speed for a known pressure range. This data was then applied to modeling formulas to estimate stall torque over an extended range of variables. The data were then used to design an appropriate dynamometer and airflow experiment. The model data also served to estimate various specifications and power output of the future turbine. An Obi Laser SSTG‐001 Tesla turbine was used in the experiments described. Experimental stall torque measurements were conducted in two stages. Shaft speed measurements were taken with an optical laser tachometer and Tesla turbine stall torque was measured using a spring force gauge. Two methods were chosen to model Tesla turbine stall torque: 1) flow over flat plate and 2) free vortex with a sink. A functional dynamometer and thermodynamic apparatus were constructed once the model was confirmed to be within the experimental uncertainty. Results of the experiments show that the experimental turbine ...
Contributing Partner: UNT Libraries
Evaluation of Fine Particulate Matter Pollution Sources Affecting Dallas, Texas

Evaluation of Fine Particulate Matter Pollution Sources Affecting Dallas, Texas

Date: May 2012
Creator: Puthenparampil Koruth, Joseph
Description: Dallas is the third largest growing industrialized city in the state of Texas. the prevailing air quality here is highly influenced by the industrialization and particulate matter 2.5µm (PM2.5) has been found to be one of the main pollutants in this region. Exposure to PM2.5 in elevated levels could cause respiratory problems and other health issues, some of which could be fatal. the current study dealt with the quantification and analysis of the sources of emission of PM2.5 and an emission inventory for PM2.5 was assessed. 24-hour average samples of PM2.5 were collected at two monitoring sites under the Texas Commission on Environmental Quality (TCEQ) in Dallas, Dallas convention Centre (CAMS 312) and Dallas Hinton sites (CAMS 60). the data was collected from January 2003 to December 2009 and by using two positive matrix models PMF 2 and EPA PMF the PM2.5 source were identified. 9 sources were identified from CAMS 312 of which secondary sulfate (31% by PMF2 and 26% by EPA PMF) was found to be one of the major sources. Data from CAMS 60 enabled the identification of 8 sources by PMF2 and 9 by EPA PMF. These data also confirmed secondary sulfate (35% by PMF2 and ...
Contributing Partner: UNT Libraries
A Wide Band Frequency-adjustable Piezoelectric Energy Harvester: an Experimental Study

A Wide Band Frequency-adjustable Piezoelectric Energy Harvester: an Experimental Study

Date: August 2012
Creator: Lee, Pohua
Description: Piezoelectric energy harvester has become a new powering choice for small electronic device. Due to its piezoelectric effect, electric energy can be obtained from ambient vibrations. This thesis is intending to build a frequency-adjustable piezoelectric energy harvester system. The system is structured with two piezoelectric bimorph beams, which are connected to each other by a spring. The feasibility of the frequency-adjustable piezoelectric energy harvester has been proved by investigating effects of the spring, loading mass and impedance on the operation frequencies.
Contributing Partner: UNT Libraries