Technical Report Archive & Image Library (TRAIL) - 5,448 Matching Results

Search Results

prev Results: 73 - 96 next
open access

Aerodynamic characteristics of a wing with unswept quarter-chord line, aspect ratio 4, taper ratio 0.6, and NACA 65A006 airfoil section

Description: From Introduction: "This paper presents the results of the investigation of the wing-alone and of the wing-fuselage configuration employing a wing with an unswept quarter-chord line, aspect ratio 4, taper ratio 0.6, and an NACA 65A006 airfoil section parallel to the air stream. The results of closely related sweptback-wing investigations, which are part of the present transonic programs, are presented in references 1 to 3."
Date: October 21, 1949
Creator: Goodson, Kenneth W. & Morrison, William D., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of an 0.08-Scale Model of the Martin XB-51 Airplane at High Subsonic Speeds

Description: Report discussing tests of a scale model of the XB-51 airplane to determine its force, stability, and control characteristics in pitch and yaw at various Mach numbers. The effects of the dive breaks and the bomb bay are also described.
Date: October 7, 1949
Creator: Barnes, Robert H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of an Airfoil-Forebody Swept Flying-Boat Hull With a Wing and Tail Swept Back 51.3 Degrees at the Leading Edge

Description: Report discussing an investigation of the aerodynamic characteristics of an airfoil-forebody swept flying boat hull with a wing and tail swept back 51.3 degrees at the leading edge. The swept hull's minimum drag coefficient was about the same as the parent model or streamline model. Various combinations of flaps were also utilized.
Date: September 9, 1949
Creator: Naeseth, Rodger L. & MacLeod, Richard G.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Flying-Boat Hulls Having Length-Beam Ratios of 20 and 30

Description: Report discussing the aerodynamic effects of length-beam ratios 20 and 30 as compared to length-beam ratios from 6 to 15. There was slightly more longitudinal stability and slightly less directional stability than in the lower ratios and not much change in the minimum drag coefficient.
Date: November 10, 1948
Creator: Riebe, John M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Four NACA Airfoil Sections Designed for Helicopter Rotor Blades

Description: "The purpose of the present work is to extend the previous investigation and to derive additional airfoil sections designed to minimize the undesirable characteristics of the previously tested airfoils. The tests of these additional airfoils were made in the Langley two-dimensional low-turbulence tunnel (LTT)" (p. 2).
Date: February 1946
Creator: Stivers, Louis S., Jr. & Rice, Fred J., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Four Republic Airfoil Sections from Tests in Langley Two-Dimensional Low-Turbulence Tunnels

Description: "Four airfoils sections, designed by the Republic Aviation Corporation for the root and tip sections of the XF-12 airplane, were tested in the Langley two-dimensional low-turbulence tunnels to obtain their aerodynamic characteristics. Lift characteristics were obtained at Reynolds numbers of 3,000,000, 6,000,000, 9,000,000, and 14,000,000, whereas drag characteristics were obtained at Reynolds numbers of 3,000,000, 6,000,000, and 9,000,000. Pressure distributions were obtained for one of the ro… more
Date: September 27, 1945
Creator: Klein, Milton M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Horizontal Tail Surfaces

Description: From Summary: "Collected data are presented on the aerodynamic characteristics of 17 horizontal tail surfaces including several with balanced elevators and two with end plates. Curves are given for coefficients of normal force, drag, and elevator hinge moment. A limited analysis of the results has been made. The normal-force coefficients are in better agreement with the lifting-surface theory of Prandtl and Blenk for airfoils of low aspect ratio than with the usual lifting-line theory. Only par… more
Date: 1940
Creator: Silverstein, Abe & Katzoff, S.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Several Modifications of a 0.45-Scale Model of the Vertical Tail of the Curtiss XP-62 Airplane

Description: "In the course of an investigation to find a satisfactory vertical tail for the XP-62 airplane, a 0.45-scale vertical tail model on a stub fuselage was tested in the Langley 7- by 10-foot tunnel. This model was fitted with a flat plate to represent the horizontal tail surface. The data are presented herein for their general interest value rather than their application to this particular airplane" (p. 1).
Date: July 1946
Creator: Lowry, John G.; Turner, Thomas R. & Liddell, Robert B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Several NACA Airfoil Sections at Seven Reynolds Numbers From 0.7 X 10(Exp 6) to 9.0 X 10(Exp 6)

Description: Report presenting an investigation of the two-dimensional aerodynamic characteristics of several NACA airfoil sections at four Reynolds numbers. Results regarding the minimum drag, maximum lift, lift-curve slope, and angle of zero lift and pitching moment are provided.
Date: May 27, 1948
Creator: Loftin, Laurence K., Jr. & Poteat, M. Irene
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of the NACA 8-H-12 airfoil section at six Reynolds numbers from 1.8 x 10(exp 6) to 11.0 x 10(exp 6)

Description: Report presenting an investigation in the two-dimensional low-turbulence pressure tunnel to determine the aerodynamic characteristics of the NACA 8-H-12 airfoil section at four Reynolds numbers. The section lift, drag, and pitching-moment characteristics are presented for smooth and rough surface conditions. Generally, no unusual scale effects are present for either condition.
Date: December 1949
Creator: Schaefer, Raymond F. & Smith, Hamilton A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of the NACA 747A315 and 747A415 Airfoils From Tests in the NACA Two-Dimensional Low-Turbulence Pressure Tunnel

Description: Report presenting two low-drag airfoils, the NACA 747A315 and the NACA 747A415, which are designed to have reduced pitching moments about the quarter-chord point and moderately high values of the design lift coefficient and are tested in the tow-dimensional low-turbulence pressure tunnel.
Date: September 1944
Creator: von Doenhoff, Albert E. & Stivers, Louis S., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Three Deep-Stepped Planing-Tail Flying-Boat Hulls

Description: "An investigation was made in the Langley 300 MPH 7- by 10-foot tunnel to determine the aerodynamic characteristics of three deep-stepped planing-tail flying-boat hulls differing only in the amount of step fairing. The hulls were derived by increasing the unfaired step depth of a planing-tail hull of a previous aerodynamic investigation to a depth about 92 percent of the hull beam. Tests were also made on a transverse-stepped hull with an extended afterbody for the purpose of comparison and in … more
Date: March 13, 1947
Creator: Riebe, John M. & Naeseth, Rodger L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Two All-Movable Wings Tested in the Presence of a Fuselage at a Mach Number of 1.9

Description: Report presenting testing of half-span models of two wings of different plan form as both all-movable and fixed surfaces in the presence of a half fuselage. All-movable surfaces are being considered for supersonic aircraft as possible angle-of-attack indicators, control surfaces, and all-movable wings. Results regarding the lift characteristics, center of pressure, and drag of the wings are provided.
Date: October 28, 1948
Creator: Conner, D. William
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The aerodynamic characteristics throughout the subsonic speed range of a thin, sharp-edged horizontal tail of aspect ratio 4 equipped with a constant-chord elevator

Description: From Introduction: "Recent investigations have indicated several wing plan forms, wing sections, and wing-body-tail combinations suitable for flight at supersonic speeds. One such lifting surface, a thin, sharp-edged without sweep of aspect ratio 4 and taper ratio 0.5, has been the subject of an investigation in the Ames 12-foot pressure wind tunnel. The aim of the investigation was to determine the aerodynamic characteristics of such a wing plan form throughout the range of subsonic Mach numbe… more
Date: June 30, 1949
Creator: Bandettini, Angelo & Reed, Verlin D.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Data for a Wing Section of the Republic XF-12 Airplane Equipped With a Double Slotted Flap

Description: Report presenting an investigation in the two-dimensional low-turbulence tunnels for the purpose of developing an optimum flap configuration for maximum lift on an airfoil section for the Republic XF-12 airplane equipped with a double slotted flap. Lift and flap loads were obtained at several flap deflections for two flap paths. Results regarding lift, drag, and flap loads are provided.
Date: January 1946
Creator: Cahill, Jones F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Factors Affecting the Ability of a Pilot to Return an Airplane to Level From a Banked Attitude by Use of the Rudder Alone and Without Change of Heading

Description: Report presenting a study of the aerodynamic factors upon which the ability to perform the maneuver depends in an attempt to obtain a better understanding of the conditions involved and, if possible, to evolve criterions that may be used during design.
Date: October 1941
Creator: Harmon, S. M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Heat-Power Engine Operating on a Closed Cycle

Description: "Hot-air engines with dynamic compressors and turbines offer new prospects of success through utilization of units of high efficiencies and through the employment of modern materials of great strength at high temperature. Particular consideration is given to an aerodynamic prime mover operating on a closed circuit and heated externally. Increase of the pressure level of the circulating air permits a great increase of limit load of the unit. This also affords a possibility of regulation for whic… more
Date: November 1942
Creator: Ackeret, J. & Keller, D. C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic heating and the deflection of drops by an obstacle in an air stream in relation to aircraft icing

Description: From Summary: "Two topics of interest to persons attempting to apply the heat method of preventing ice formation on aircraft are considered. Surfaces moving through air at high speed are shown, both theoretically and experimentally, to be subject to important aerodynamic heating effects that will materially reduce the heat required to prevent ice. Numerical calculations of the path of water drops in an air stream around a circular cylinder are given. From these calculations, information is obta… more
Date: October 1940
Creator: Kantrowitz, Arthur
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic problems in the design of efficient propellers

Description: From General Analysis: "The purpose of part I of this paper is to show how the loading that gives the minimum induced energy loss can be obtained from rather elementary considerations and to present design charts from which such a plan form can be quickly obtained for any set of design conditions."
Date: August 1942
Creator: Feldman, Lewis
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Properties of Cruciform-Wing and Body Combinations at Subsonic, Transonic, and Supersonic Speeds

Description: From Introduction: "Although the aerodynamic characteristics of the components of such configurations may be well known, the mutual interference resulting from combining the wings, as well as the wings and body, may be so great that is desirable to study the aerodynamic properties of the complete configurations. Two methods of handling this problem are presented in this report. The first method is essentially an extension of the theory for slender wing-body combinations of reference 1 to determ… more
Date: June 1949
Creator: Spreiter, John R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Properties of Slender Wing-Body Combinations at Subsonic, Transonic, and Supersonic Speeds

Description: From Introduction: "In an incomprehensible medium, the mutual interference of a fuselage and wing of high-aspect ratio (to which lifting-line theory is applicable) has been treated by Lennertz, Wiselsberger, Pepper, and Multhopp in reference 1, 2, 3, and 4. It is the purpose of this note to treat the effect of on the aerodynamic loading of the mutual interference between a low-aspect-ratio pointed wing and a fuselage consisting of a slender body of revolution."
Date: July 1948
Creator: Spreiter, John R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic study of a wing-fuselage combination employing a wing swept back 63 degrees: Aerodynamic characteristics in sideslip of a large-scale model having a 63 degree swept-back vertical tail

Description: Report presenting an investigation to determine the effects of a vertical tail with the leading edge swept back 63 degrees on the aerodynamic characteristics of a wing-fuselage combination with a wing with the leading edge swept back 63 degrees. The aerodynamic characteristics in sideslip with and without the vertical tail are also presented. Results regarding the directional stability, rudder effectiveness, and rudder hinge moments are described.
Date: October 7, 1949
Creator: McCormack, Gerald M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen