Technical Report Archive & Image Library (TRAIL) - 6,928 Matching Results

Search Results

Results: 1 - 24 next
open access

An 8-Foot Axisymmetrical Fixed Nozzle for Subsonic Mach Numbers Up to 0.99 and for a Supersonic Mach Number of 1.2

Description: From Introduction: "This paper, which should be of interest to those concerned with transonic wind tunnels, covers the design and operating characteristics of the nozzle."
Date: February 23, 1950
Creator: Ritchie, Virgil S.; Wright, Ray H. & Tulin, Marshall P.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Ability of Pilots to Control Simulated Short-Period Yawing Oscillations

Description: Report discussing an investigation into the ability of human pilots to control short-period yawing oscillations using a yaw simulating device. The ability to control the oscillations was determined to be a function of period, control effectiveness, and inherent damping. Pilot control effectiveness was found to improve with practice.
Date: November 13, 1950
Creator: Phillips, William H. & Cheatham, Donald C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Abnormal grain growth in M-252 and S-816 alloys

Description: Report discussing an experimental investigation was carried out on air- and vacuum-melted M-252 and S-816 alloys to find conditions of heating and hot-working which resulted in abnormal grain growth. The experiments were mainly limited to normal conditions of heating for hot-working and heat treatment and normal temperatures of solution treatment were used to allow grain growth after susceptibility to abnormal grain growth was developed by various experimental conditions. Results indicated that… more
Date: November 1957
Creator: Decker, R. F.; Rush, A. I.; Dano, A. G. & Freeman, J. W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Abnormal grain growth in nickel-base heat-resistant alloys

Description: From Introduction: "The data included in this report for Nimonic 80A alloy, for instance, represent experiments carried out to help clarify a production problem of grain-size control in an alloy which has been extensively used. The general procedure of the investigation was to carry out controlled laboratory experiments on samples of bar stock to find conditions of heating and hot-working which resulted in abnormal grain growth."
Date: December 1957
Creator: Decker, R. F.; Rush, A. I.; Dano, A. G. & Freeman, J. W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Abnormal Grain Growth in S-816 Alloy

Description: From Introduction: "This report presents the results obtained to date of an investigation to establish the fundamental causes of abnormal growth in S-816 alloy under conditions encountered during the forging of blades for the gas turbine of jet engines."
Date: April 1952
Creator: Rush, A. I.; Freeman, J. W. & White, A. E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acceleration Characteristics of a Turbojet Engine With Variable-Position Inlet Guide Vanes

Description: Report presenting a study of the acceleration characteristics of a turbojet engine equipped with variable-position inlet guide vanes in the altitude test chamber. Maximum acceleration values for 3 engines of the same model were also obtained during testing and were found to differ as much as 50 percent. Results regarding the effect of fuel step size and inlet guide vane on acceleration, effect of flight condition, reproducibility of engine acceleration, compressor pressure ratio in relation to … more
Date: July 7, 1955
Creator: Dobson, W. F. & Wallner, Lewis E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acceleration of high-pressure-ratio single-spool turbojet engine as determined from component performance characteristics 1: effect of air bleed at compressor outlet

Description: From Summary: "An analytical investigation was made to determine from component performance characteristics the effect of air bleed at the compressor outlet on the acceleration characteristics of a typical high-pressure-ratio single-spool turbojet engine. Consideration of several operating lines on the compressor performance map with two turbine-inlet temperatures showed that for a minimum acceleration time the turbine-inlet temperature should be the maximum allowable, and the operating line on… more
Date: March 10, 1953
Creator: Rebeske, John J., Jr. & Rohlik, Harold E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acceleration of high-pressure-ratio single-spool turbojet engine as determined from component performance characteristics 2: effect of compressor interstage air bleed

Description: Report presenting an analytical investigation to determine the effect of compressor interstage air bleed with the use of constant-area bleed ports on the acceleration characteristics of a typical high-pressure-ratio single-spool turbojet engine. Constant-area interstage bleed, properly located, gave smaller acceleration times than variable-area compressor exit bleed. Results regarding acceleration with interstage bleed, acceleration using constant-area interstage bleed in combination with compr… more
Date: July 3, 1953
Creator: Rebeske, John J., Jr. & Dugan, James F., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acceleration of high-pressure-ratio single-spool turbojet engine as determined from component performance characteristics 3: effect of turbine stator adjustment

Description: From Summary: "An analytical investigation was made to determine from component performance the effect of turbine stator adjustment on the acceleration characteristics of a typical high-pressure-ratio single-spool turbojet engine. Turbine stator adjustment was adequate to permit engine operation in the intermediate-speed range, but was less satisfactory than the relatively simple schemes of compressor-interstage and -outlet bleed."
Date: August 2, 1954
Creator: Rohlik, Harold E. & Rebeske, John J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An Acceleration Schedule Control for Accelerating a Turbojet Engine and Its Use With a Speed Control

Description: Memorandum presenting a study of an acceleration-limiting control on a turbojet engine in order to determine its feasibility as an acceleration control. A proportional-plus-integral type of controller was used in the investigation. Results regarding the one-loop control and two-loop control are provided.
Date: May 12, 1958
Creator: Gerus, Theodore F.; Powers, Albert G. & Heppler, Herbert J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An Acceleration Schedule Control for Accelerating a Turbojet Engine and Its Use With a Speed Control

Description: Memorandum presenting an acceleration-limiting control used on a turbojet engine to study the feasibility of its use as an acceleration control. A proportional-plus-integral type of controller was used in this investigation. Results regarding one-loop control and two-loop control are provided.
Date: May 12, 1958
Creator: Gerus, Theodore F.; Powers, Albert G. & Heppler, Herbert J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Accelerations and passenger harness loads measured in full-scale light-airplane crashes

Description: From Introduction: "Light-airplane accident data, compiled by Crash Injury Research of Cornell University Medical College, indicate that human beings have often withstood declarations in excess of those imposed in airplane crashes involving extensive damage to the airplane structure (ref. 1). This study also correlates the extent of damage to the airplane structure with the injury incurred by the occupants during crash accidents."
Date: August 1953
Creator: Eiband, A. Martin; Simpkinson, Scott H. & Black, Dugald O.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Accelerations in fighter-airplane crashes

Description: From Introduction: "This report describes some measurements of these quantities obtained by crashing fighter aircraft under circumstances approximating those observed in service."
Date: November 4, 1957
Creator: Acker, Loren W.; Black, Dugald O. & Moser, Jacob C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Accelerations in Transport-Airplane Crashes

Description: From Introduction: "A study of crash-impact survival in light airplanes is reported in references 1 and 2. A similar study for fighter airplanes is reported in reference 3. This report discusses crash-impact survival in transport airplanes."
Date: February 1958
Creator: Preston, G. Merritt & Pesman, Gerard J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Accuracy of Approximate Methods for Predicting Pressures on Pointed Nonlifting Bodies of Revolution in Supersonic Flow

Description: Note presenting an investigation of the accuracy and range of applicability of the linearized theory, second-order theory, tangent-cone method, conical-shock-expansion theory, and Newtonian theory for predicting pressure distributions on pointed bodies of revolution at zero angle of attack. Three shapes, cone, ogive, and a modified optimum body, are investigated over a wide range of fineness ratios and Mach numbers. The results indicated that for most combinations of fineness ratio and Mach num… more
Date: August 1952
Creator: Ehret, Dorris M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Accuracy of the Substitute-Stringer Approach for Determining the Bending Frequencies of Multistringer Box Beams

Description: "The accuracy of the substitute-stringer approach for including the effects of shear lag in the calculation of the transverse modes and frequencies of multistringer box beams is investigated. Box beams, the covers of which consist of normal-stress-carrying stringers on sheets which carry not only shear but also normal stress, are analyzed exactly. Frequencies of beams with various numbers of stringers, obtained by means of this exact analysis, serve to determine the possible accuracy of the fre… more
Date: April 1956
Creator: Davenport, William W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An accurate and rapid method for the design of supersonic nozzles

Description: From Introduction: "This report presents a computational procedure which provides for the rapid and accurate calculation of any streamline in a series of special flows. Detailed information is given on the boundary conditions and equations used for computing the characteristic nets and stream function."
Date: February 1955
Creator: Beckwith, Ivan E. & Moore, John A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Achievement of Continuous Wall Curvature in Design of Two-Dimensional Symmetrical Supersonic Nozzles

Description: "Auxiliary boundary conditions are derived to assure continuity of wall curvature in applying the method of characteristics to the design of two-dimensional symmetrical supersonic nozzles. An illustrative example is included" (p. 1).
Date: January 1952
Creator: Evvard, J. C. & Marcus, Lawrence R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acoustic analysis of ram-jet buzz

Description: From Introduction: "The surging of a system containing a centrifugal- or axial-flow compressor (e.g., refs. 1 to 4) is an example of self-sustained oscillation. Inlets designed for supersonic jet engines also have been observed to induce oscillations (e.g., refs. 5 to 11) which are usually referred to as "buzz." The origin of buzz in ram-jet engines is the subject of the present report."
Date: November 1955
Creator: Mirels, Harold
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acoustic radiation from two-dimensional rectangular cutouts in aerodynamic surfaces

Description: From Introduction: "The experiments in high-speed flow showed that an intense, high-frequency acoustic radiation is an essential feature of the problem. Consequently, a study of the acoustic field (involving schlieren observations and frequency and intensity measurements) was undertaken. This report presents the salient features of the study, which was mainly exploratory."
Date: August 1955
Creator: Krishnamurty, K.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acoustic, thrust, and drag characteristics of several full-scale noise suppressors for turbojet engines

Description: From Introduction: " Considerable analytical and experimental research has been done to find means of reducing the noise levels of the turbojet transports. Noise levels can be decreased by engine redesign to reduce the jet-exit velocity (ref. 1), proper flight-climb techniques (ref. 2), and the use of noise-suppression exhaust nozzles (refs. 3 to 5). The present report is concerned with the last method."
Date: April 1958
Creator: Ciepluch, Carl C.; North, Warren J.; Coles, Willard D. & Antl, Robert J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acoustical Treatment for the NACA 8- by 6-Foot Supersonic Propulsion Wind Tunnel

Description: "This report presents results of a research and engineering program performed during the first half of 1950 that resulted in an acoustical treatment for the 8- by 6-foot supersonic wind tunnel at the Lewis Flight Propulsion Laboratory" (p. 1).
Date: June 1955
Creator: Beranek, Leo L.; Labate, Samuel & Ingard, Uno
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acoustics of a Nonhomogeneous Moving Medium

Description: Report discussing theoretical basis of the acoustics of a moving nonhomogeneous medium. Experiments that illustrate or confirm some of the theoretical explanation or derivation of these acoustics are also included.
Date: February 1956
Creator: Blokhintsev, D. I.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An active particle diffusion theory of flame quenching for laminar flames

Description: An equation for quenching distance based on the destruction of chain carriers by the surface is derived. The equation expresses the quenching distance in terms of the diffusion coefficients and partial pressures of the chain carriers and gas phase molecules, the efficiency of the surface as a chain breaker, the total pressure of the mixture, and a constant which depends on the geometry of the quenching surface. Quenching distances measured by flashback for propane-air flames are shown to be con… more
Date: March 4, 1952
Creator: Simon, Dorothy M. & Belles, Frank E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen