Technical Report Archive & Image Library (TRAIL) - 30,096 Matching Results

Search Results

prev Results: 41 - 64 next
open access

The effect of compressibility on two-dimensional tunnel-wall interference for a symmetrical airfoil

Description: Summary: The effective change in the velocity of flow past a wing section, caused by the presence of wind-tunnel walls, is known for potential flow. This theory is extended by investigation of the two-dimensional compressible flow past a thin Rankine Oval. It is shown that for a symmetrical section at zero angle of attack the velocity increment due to the tunnel walls in the incompressible case must be multiplied by the factor 1/1-M^2 to take account of compressibility effects. The Mach numb… more
Date: May 1943
Creator: Nitzberg, Gerald E.
Partner: UNT Libraries Government Documents Department
open access

Lioré-Olivier LeO 194 Seaplane

Description: Report presenting a description of the Lioré-Olivier LeO 194 seaplane and a particular series of flights made over several months. Its fuselage is made entirely of wood. It has 6 gasoline tanks each with a capacity of 255 liters. It is a single engine biplane with wings mounted above the body of the seaplane.
Date: April 1927
Partner: UNT Libraries Government Documents Department
open access

The Hanriot-Biche 110 C1 Airplane (French): An All-Metal Low-Wing Pursuit Monoplane

Description: Circular presenting a description of the Hanriot-Biche 110 C1 airplane, which is a French all-metal low-wing pursuit monoplane. Details regarding the wing, girders and tail surfaces, pilot's cockpit, power plant, landing gear, flying qualities, and photographs are provided.
Date: July 1933
Creator: Rabion, René
Partner: UNT Libraries Government Documents Department
open access

A method for determining the rate of heat transfer from a wing or streamline body

Description: From Summary: "A method for calculating the rate of heat transfer from the surface of an airfoil or streamline body is presented. A comparison with the results of an experimental investigation indicates that the accuracy of the method is good. This method may be used to calculate the heat supply necessary for heat de-icing or in ascertaining the heat loss from the fuselage of an aircraft operating at great altitude, for example."
Date: December 1942
Creator: Frick, Charles W., Jr. & McCullough, George B.
Partner: UNT Libraries Government Documents Department
open access

Emergency Measures for Increasing the Range of Fighter Airplanes

Description: "An analysis was made to show the relative effectiveness of streamline external fuel tanks, a fuel tank in the form of a wing mounted in a biplane position, and auxiliary wing panels attached at the wing tips to increase the span as temporary means for increasing the range of a fighter-type airplane. Figures and charts for the various devices considered show the results of calculations of range, duration of flight, and take-off distance for both land-base and carrier operation. The results indi… more
Date: May 1943
Creator: Jones, Robert T. & Wetmore, Joseph W.
Partner: UNT Libraries Government Documents Department
open access

Review of Flight Tests of NACA C and D Cowlings on the XP-42 Airplane

Description: Report presenting the results of flight tests of the performance and cooling characteristics of three NACA D cowlings and of a conventional NACA C cowling on the XP-42 airplane. The D cowling is, generally, characterized by the use of an annular inlet and diffuser section for the engine-cooling air. An increase in maximum speed was noted in the XP-42 airplane due to the change from a C cowling to a D cowling.
Date: April 1943
Creator: Johnston, J. Ford
Partner: UNT Libraries Government Documents Department
open access

Morane-Saulnier 121 Single-Seat Pursuit Airplane (French)

Description: The M.-S. 121 is noted for it's excellent visibility inherent in the parasol design. The wings have no dihedral but a very pronounced sweep back. A description of the components, flight characteristics, performance, drawings, and photographs are provided.
Date: June 1928
Partner: UNT Libraries Government Documents Department
open access

Fuel-Evaporation Loss as Determined by the Change in the Specific Gravity of the Fuel in an Aircraft Fuel Tank

Description: Report discusses the results of an investigation to determine the feasibility of using the change in the specific gravity of fuels in aircraft fuel tanks to measure fuel-vaporization loss. Six fuels were tested via fuel-distillation tests and simulated-flight tests. An equation based on the specific gravity of the fuel is also described.
Date: May 1945
Creator: Stone, Charles S. & Kramer, Walter E.
Partner: UNT Libraries Government Documents Department
open access

FORTIO: a FORTRAN I/O Interface

Description: A set of OS/370 Basic Assembly Language programs is described which provides a FORTRAN IV interface with OS/370 Macros.
Date: April 1976
Creator: Shalla, L.
Partner: UNT Libraries Government Documents Department
open access

Final Report on the Small-Scale Vapor-Explosion Experiments Using a Molten NaCl-H2O System

Description: Vapor explosions were produced by injecting small quantities of water into a container filled with molten sodium chloride. Minimum explosion efficiencies, as evaluated from reaction-impulse measurements, were relatively large. Subsurface movies showed that the explosions resulted from a two-step sequence: an initial bulk-mixing phase in which the two liquids intermix on a large scale, but remain locally separated by an insulating gas-vapor layer; and a second step, immediately following breakdo… more
Date: April 1976
Creator: Anderson, R. P. & Bova, L.
Partner: UNT Libraries Government Documents Department
open access

A Unified and Mechanistic Approach to Creep-Fatigue Damage

Description: A new creep-fatigue equation is proposed that takes into account both plastic strain and strain rate. The coefficients and exponents in the damage-rate equation are interpreted by means of the various damage mechanisms of the material. The damage-rate equation has been integrated to analyze various phenomena such as the effects of plastic strain rate on monotonic tensile or creep rupture time, rising mean strain on the low-cycle fatigue behavior at elevated temperature, tensile and compressive … more
Date: January 1976
Creator: Majumdar, S. & Maiya, P. S.
Partner: UNT Libraries Government Documents Department
open access

Automated Approach to Quantitative Error Analysis in Neutron Transport Calculations

Description: A method is described how a quantitative measure for the robustness of a given transport theory code for coarse network calculations can be obtained. A code, that performs this task automatically and at only nominal cost, is described and has been implemented for slab geometry. This code generates also user oriented benchmark problems which exhibit the analytic behavior at interfaces.
Date: September 1976
Creator: Bareiss, Erwin H. & Derstine, Keith L.
Partner: UNT Libraries Government Documents Department
open access

Materials Science Division Coal Technology Quarterly Report: January-March 1976

Description: Quarterly report of the Argonne National Laboratory Materials Science Division regarding the evaluation of ceramic refractories to withstand abrasion-corrosion by coal slag that will be encountered in the Bituminous Coal Research (BCR) Bi-Gas coal-gasification pilot plant, development of computer models to predict corrosion and erosion behavior of materials, and analysis of pilot-plant components that have failed or are removed from service for other reasons.
Date: 1976?
Creator: Argonne National Laboratory
Partner: UNT Libraries Government Documents Department
open access

An Overview of Pool-Type LMFBRs : General Characteristics

Description: This report describes the results of a study conducted by a "Pool Study Group" organized at ANL in mid-1975 to examine the present state of the air of design of pool-type LMFBRs. The study concentrated on examination of various design options used to date in the principle pool-type projects and design studies in this country and abroad, including the Phenix and Super-Phenix reactors (France), PFR and CFR (U.K.), RN-600 (U.S.S.R.) and EBR-II (U.S.A.). The objective of the report is to provide a … more
Date: May 1976
Creator: Amorosi, A.; Hutter, E.; Marciniak, T. J.; Monson, H. O.; Seidensticker, R. W. & Simmons, W. R.
Partner: UNT Libraries Government Documents Department
open access

Examination of the SCEPTRE and CSMP Programs for Solving the Point-Kinetics Equations with Feedback

Description: Two modeling programs, SCEPTRE and CSMP, are used to solve the point-kinetics equations - - seven coupled nonlinear differential equations - - with a linear-feedback function. The constants used are appropriate for EBR-II; therefore the computational accuracy may be tested against the experimental rod drops. Run-time, versatility, programming ease, and accuracy are criteria used to evaluate the two programs. SCEPTRE is found to be more efficient in run time and CSMP more versatile. The ease of … more
Date: September 1976
Creator: Walkowski, P. D. & Peterson, B. R. (Bruce R.)
Partner: UNT Libraries Government Documents Department
open access

Finite-Element Analysis of a Thick-Wall Tube Containing a Crater-Like Surface Flaw

Description: A three-dimensional finite-element elastic analysis is carried out for a thick-wall tube (as sued in typical LMFBR steam generators) that contains a surface flaw in the form of a paraboloid of revolution. Effects of the depth and aspect ratio of the flaw on the stress distribution and stress concentration in the tube are explored.
Date: June 1976
Creator: Majumdar, S.
Partner: UNT Libraries Government Documents Department
open access

PTA-1: A Computer Program for Analysis of Pressure Transients in Hydraulic Networks, Including the Effect of Pipe Plasticity

Description: The computer program PTA-1 performs pressure-transient analysis of large piping networks using the one-dimensional method of characteristics applied to a fluid-hammer formulation. The effect of elastic-plastic deformation of piping on pulse propagation is included in the computation. The program is particularly oriented toward the analysis of the effects of a sodium/water reaction on the intermediate heat-transport system of a liquid-metal-cooled fast breeder reactor, but may be applied just as… more
Date: November 1976
Creator: Youngdahl, C. K. & Kot, C. A.
Partner: UNT Libraries Government Documents Department
open access

Fission-Product Releases to the Primary System of EBR-II, January 1974-March 1975

Description: Seven releases of fission products occurred in EBR-II from January 1974 to March 1975 - - five from mixed-oxide elements and two from sodium-bonded driver-fuel elements. Four releases were from elements that contained a xenon tag, which aided considerably in locating three of the elements; data from the fourth element allowed estimation of changes of tag composition with reactor exposure. Rapid release of fission from two breached mixed-oxide elements caused the reactor to trip because of incre… more
Date: October 1976
Creator: So, B. Y. C.; Lambert, J. D. B.; Johnson, D. L.; Ebersole, E. R. & Brunson, G. S.
Partner: UNT Libraries Government Documents Department
open access

Inelastic-Collision Cross Sections for Ne

Description: Cross sections for inelastic collisions of slow electrons and the dipole oscillator-strength distribution for the neon atom are given in tabular form. The results are based on experimental data that were checked and adjusted for internal consistency.
Date: 1976
Creator: Soong, S. C. & Kim, Yong-Ki
Partner: UNT Libraries Government Documents Department
open access

Predicted Heat-Transfer Performance of an Evacuated Glass-Jacketed CPC Receiver : Countercurrent Flow Design

Description: The heat-transfer performance of an evacuated glass-jacketed CPC-receiver facility, free on one end and fixed onto the glass jacket at the other, was carried out using heat-transfer relationships and the best information available in the literature. Specifically, the collector examined was a 3x-CPC facility, 8 ft long, with an entrance aperture 4.5 in. wide covered with a single glass cover, and provided with an aluminum reflecting surface (rho = 0.88). To maximize heat retention, a selectively… more
Date: May 1976
Creator: Thodos, George
Partner: UNT Libraries Government Documents Department
Back to Top of Screen