Technical Report Archive & Image Library (TRAIL) - 5,157 Matching Results

Search Results

open access

Some Notes on the Probable Damage to an Intercontinental-Ballistic-Missile Warhead Following Puncture of the Heat Shield

Description: Report discussing a study of the effects of puncturing the heat shield of an intercontinental-ballistic-missile warhead by small projectiles. Calculations were created for both rod and sphere projectiles and experimental testing was performed on a missile model with holes drilled in the heat shield. The possibility that a projectile could have enough energy to cause mechanical damage to the interior of the warhead is also presented.
Date: September 29, 1958
Creator: Strass, H. K. & Goodman, V. M.
Partner: UNT Libraries Government Documents Department
open access

Analysis of pressure data obtained at transonic speeds on a thin low-aspect-ratio cambered delta wing-body combination

Description: From Introduction: "Wind-tunnel and flight tests have shown that conical leading-edge camber on a thin low-aspect-ratio delta wing results in increasing the lift-drag ratio at transonic and low supersonic speeds (refs. 1 and 2). References 3 and 4 present the results of two previous investigations of this general program. A more detailed analysis of the pressure distributions of reference 5 is presented herein in terms of total section loads and overall wing-body characteristics."
Date: September 26, 1958
Creator: Mugler, John P., Jr.
Partner: UNT Libraries Government Documents Department
open access

Large-scale wind-tunnel tests of a jet-transport-type model with leading- and trailing-edge high-lift devices

Description: From Summary: "An investigation was conducted to determine the longitudinal characteristics of an airplane model with a 35 degree swept wing of aspect ratio 7 and four pylon-mounted nacelles. Several leading-edge configurations were studied in conjunction with double-slotted trailing-edge flaps. Three-component longitudinal data are presented. In general, the test Reynolds number was about 4.8 x 10(exp 6), but for selected configurations, data for Reynolds number ranges from 2.8 to 8 x 10(exp 6… more
Date: September 26, 1958
Creator: Hickey, David H. & Aoyagi, Kiyoshi
Partner: UNT Libraries Government Documents Department
open access

Static and dynamic-rotary stability derivatives of an airplane model with an unswept wing and a high horizontal tail at Mach numbers of 2.5, 3.0, and 3.5

Description: Report presenting the static and dynamic-rotary stability derivatives for an airplane with an unswept wing and a high horizontal tail as determined in wind-tunnel tests at 3 Mach numbers. The tail contribution to stability was found to not be predicted by the simplified theoretical methods used in this report. Results regarding the longitudinal derivatives, sideslip derivatives, yawing derivatives, rolling derivatives, and variation of static derivatives with Mach number.
Date: September 26, 1958
Creator: Lampkin, Bedford A. & Tunnell, Phillips J.
Partner: UNT Libraries Government Documents Department
open access

Effect of Spike-Tip and Cowl-Lip Blunting on Inlet Performance of a Mach 3.0 External-Compression Inlet

Description: Report presenting an investigation of the effect of inlet component blunting on performance using an axisymmetric external-compression inlet in the supersonic wind tunnel. The investigation was carried out to determine the performance penalties associated with spike-tip and cowl-lip blunting. Results regarding the effect of rounding the spike tip on inlet performance, overall drag coefficients, flow distortion, and Schileren photographs are provided.
Date: September 23, 1958
Creator: Cubbison, R. W. & Samanich, N. E.
Partner: UNT Libraries Government Documents Department
open access

Effect of Spike-Tip and Cowl-Lip Blunting on Inlet Performance of a Mach 3.0 External-Compression Inlet

Description: Report presenting the effect of inlet component blunting on performance using an axisymmetric external-compression inlet in order to determine the performance penalties associated with spike-tip and cowl-lip blunting. The data can be used as a design guide for blunt inlet components applicable to cooling techniques. Results regarding the effect of tip rounding, drag coefficients, flow distortion, lip blunting, and Schileren photographs are provided.
Date: September 23, 1958
Creator: Cubbison, R. W. & Samanich, N. E.
Partner: UNT Libraries Government Documents Department
open access

Experimental Investigation of Effect of Spike- Tip and Cowl-Lip Blunting on the Internal Performance of a Two-Cone Cylindrical-Cowl Inlet at Mach Number 4.95

Description: Memorandum presenting the effect of blunting on the internal performance of a two-cone inlet with an internally cylindrical cowl investigated experimentally at Mach number 4.95. Total-pressure-recovery and mass-flow data were obtained for a range of spike and cowl bluntness.
Date: September 23, 1958
Creator: Weston, Kenneth C.
Partner: UNT Libraries Government Documents Department
open access

Experimental Study of Ballistic-Missile Base Heating with Operating Rocket

Description: "A rocket of the 1000-pound-thrust class using liquid oxygen and JP-4 fuel as propellant was installed in the Lewis 8- by 6-foot tunnel to permit a controlled study of some of the factors affecting the heating of a rocket-missile base. Temperatures measured in the base region are presented from findings of three motor extension lengths relative to the base. Data are also presented for two combustion efficiency levels in the rocket motor" (p. 1).
Date: September 23, 1958
Creator: Nettles, J. Cary
Partner: UNT Libraries Government Documents Department
open access

Investigation of Inlet Control Parameters for an External-Internal-Compression Inlet From Mach 2.1 to 3.0

Description: "Investigation of the control parameters of an external-internal compression inlet indicates that the cowl-lip shock provides a signal to position the spike and to start the inlet over a Mach number range from 2.1 to 3.0. Use of a single fixed probe position to control the spike over the range of conditions resulted in a 3.7-count loss in total-pressure recovery at Mach 3.0 and 0 deg angle of attack. Three separate shock-sensing-probe positions were required to set the spike for peak recovery f… more
Date: September 23, 1958
Creator: Anderson, Bernhard H. & Bowditch, David N.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Performance and Static Stability and Control of Flat-Top Hypersonic Gliders at Mach Numbers From 0.6 to 18

Description: Memorandum presenting a study of aerodynamic performance and static stability and control at hypersonic speeds. In the first part of the study, the effect of interference lift is investigated by tests of asymmetric models with conical fuselages and arrow plan-form wings. In the second part, the aerodynamic performance and static stability and control characteristics of a hypersonic glider are investigated in somewhat greater detail.
Date: September 17, 1958
Creator: Syvertson, Clarence A.; Gloria, Hermilo R. & Sarabia, Michael F.
Partner: UNT Libraries Government Documents Department
open access

Investigation of Wingless Missile Configurations with Folding Controls and Low-Aspect-Ratio Stabilizing Surfaces

Description: Results regarding a wind-tunnel investigation of wingless missile configurations with cylindrical bodies and conical or hemispherical noses, extensible control surfaces aft of the nose, and tails consisting of eight low-aspect-ratio triangular or rectangular fins. Normal-force, axial-force, and pitching-moment coefficients were obtained for several control deflections for Mach numbers 1.2 and 1.9.
Date: September 17, 1958
Creator: Lazzeroni, Frank A.
Partner: UNT Libraries Government Documents Department
open access

Measurements of the Buffeting Loads on the Wing and Horizontal Tail of a 1/4-Scale Model of the X-1E Airplane

Description: "The buffeting loads acting on the wing and horizontal tail of a 1/4-scale model of the X-1E airplane have been measured in the Langley 16-foot transonic tunnel in the Mach number range from 0.40 to 0.90. When the buffeting loads were reduced to a nondimensional aerodynamic coefficient of buffeting intensity, it was found that the maximum buffeting intensity of the horizontal tail was about twice as large as that of the wing. Comparison of power spectra of buffeting loads acting on the horizont… more
Date: September 17, 1958
Creator: Rainey, A. Gerald & Igoe, William B.
Partner: UNT Libraries Government Documents Department
open access

Stability Investigation of a Blunt Cone and a Blunt Cylinder With a Square Base at Mach Numbers From 0.64 to 2.14

Description: Memorandum presenting a discussion of a fineness-ratio-2.6 bluff shape with an x(exp 1/10) nose and a 5 degree flare extending the entire body length and a fineness-ratio-2.5 bluff shape with an x(exp 1/10) nose and a square base with sides equal to the diameter of the cylindrical forebody tested in free flight over a range of Mach and Reynolds numbers. Time histories, cross plots of force and moment coefficients, and plots of the longitudinal-force coefficient, rolling velocity, aerodynamic ce… more
Date: September 17, 1958
Creator: Coltrane, Lucille C.
Partner: UNT Libraries Government Documents Department
open access

Design and Experimental Investigation of a Single-Stage Turbine With a Rotor Entering Relative Mach Number of 2

Description: Memorandum presenting a design and experimental investigation of a single-stage supersonic turbine. The turbine was designed for a rotor entering relative Mach number of 2. Results regarding the overall turbine performance, outer-wall static-pressure variation, momentum-loss considerations, effect of rotor modifications, and supersonic starting are provided.
Date: September 15, 1958
Creator: Moffitt, Thomas P.
Partner: UNT Libraries Government Documents Department
open access

Performance of an Isentropic, All-Internal-Contraction, Axisymmetric Inlet Designed for Mach 2.50

Description: Memorandum presenting an experimental investigation of an internal-contraction, axially symmetric inlet with isentropic compression surfaces on both the cowl and centerbody conducted over a range of Mach numbers from 2.0 to 2.7 at angles of attack from 0 to 6 degrees. The study was made to determine the optimum bleed system, together with a method of controlling the inlet.
Date: September 15, 1958
Creator: Bowditch, David N. & Anderson, Bernhard H.
Partner: UNT Libraries Government Documents Department
open access

The static and dynamic-rotary stability derivatives at subsonic speeds of a model of the X-15 research airplane

Description: Report presenting measurements in a wind tunnel of the subsonic static and dynamic-rotary stability derivatives of a model of an airplane designed to fly at high supersonic speeds and high altitudes. The effects of flaps and landing gear, speed brakes, and several model components are included in the results as well as the stability characteristics of the model.
Date: September 15, 1958
Creator: Lopez, Armando E. & Tinling, Bruce E.
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel investigation of the low-speed aerodynamic characteristics of a hypersonic glider configuration

Description: Report presenting a wind-tunnel investigation of the low-speed aerodynamic characteristics of an airplane configuration designed to obtain high lift-drag ratios at hypersonic speeds. The power-off landing of this aircraft would be difficult due to the high sinking speeds inherent in the design. Results regarding the longitudinal characteristics, lateral characteristics, and landing considerations are provided.
Date: September 15, 1958
Creator: Kelly, Mark W.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics at Mach Numbers From 2.5 to 3.5 of a Canard Bomber Configuration Designed for Supersonic Cruise Flight

Description: Report presenting an investigation of a canard-type configuration designed for supersonic cruise flight in the Unitary Plan wind tunnel. Tests were conducted over a range of angles of attack and angles of sideslip. Results regarding the effect of forebody configuration, effects of Reynolds number and transition, effect of canard and elevon deflection, and effect of vertical surfaces are provided.
Date: September 10, 1958
Creator: Carmel, Melvin M.; Kelly, Thomas C. & Gregory, Donald T.
Partner: UNT Libraries Government Documents Department
open access

A Flight Study of the Effects of Noise Filtering in the Attack Display on the Pilot's Tracking Performance

Description: Memorandum presenting flight tests conducted with a director-type radar fire-control system, with scope presentation of the steering information, to determine the effects of attack-display smoothing on the pilot's tracking and steering effectiveness in tail-chase and lead-collision beam attacks. Results regarding tail-chase attacks and lead-collision beam attacks are provided.
Date: September 10, 1958
Creator: Turner, Howard L. & Heinle, Donovan R.
Partner: UNT Libraries Government Documents Department
open access

Free-Flight Investigation of Aerodynamic Heat Transfer to a Simulated Glide-Rocket Shape at Mach Numbers up to 10

Description: "Heat-transfer measurements were made on a simulated glide-rocket shape in free flight at Mach numbers up to 10 and free-stream Reynolds numbers of 2 x 10 based on distance along surface from apex and 3 x 10 based on nominal leading-edge diameter. The model simulated the bottom of a 75 deg delta wing at 80 deg angle of attack. The data indicated that for the test conditions a modified three-dimensional stagnation-point theory will predict to reasonable engineering accuracy the heating on a high… more
Date: September 10, 1958
Creator: Swanson, Andrew G.
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Investigation at Mach Numbers From 0.6 to 1.4 of Several Ejected Pilot-Seat Models

Description: "The results are presented of an experimental investigation conducted to determine the static longitudinal and lateral-direction aerodynamic characteristics of basic and modified versions of a conventional upward ejected pilot-seat combination, a sled-type upward ejected pilot-seat combination, and a downward ejected pilot-seat combination" (p. 1). The drag coefficient, lift coefficient, rolling-moment coefficient, pitching-moment coefficient, yawing-moment coefficient, and side-force coefficie… more
Date: September 10, 1958
Creator: Summers, James L.
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel investigation of the aerodynamic and structural deflection characteristics of the Goodyear Inflatoplane

Description: Memorandum presenting an investigation conducted in the full-scale tunnel to determine the aerodynamic and structural deflection characteristics of the Goodyear Inflatoplane over a range of test velocities from minimum stall speed up to speeds giving load factors for wing buckling. The airplane was developed as a potential way to rescue downed pilots in enemy territory. An exploration of the stability, stalling characteristics, buckling, and chosen configuration is provided.
Date: September 10, 1958
Creator: Cocke, Bennie W., Jr.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen