Search Results

Primary view of Charts for the Analysis of One-Dimensional Steady Compressible Flow
Turner, L. Richard; Addie, Albert N. & Zimmerman, Richard H.
January 1948
Primary view of Comparison of computed performance of composite power plants using 18-cylinder aircraft engines with 62 degrees and 40 degrees valve overlap
Kaufman, Samuel J. & Boman, David S.
January 1948
Primary view of Cylinder-temperature and cooling-air-pressure instrumentation for air-cooled-engine cooling investigations
Valerino, Michael F. & Kaufman, Samuel J.
January 1948
Primary view of Development of cast aluminum alloys for elevated-temperature service
Hodge, Webster; Eastwood, L. W.; Lorig, C. H. & Cross, H. C.
January 1948
Primary view of Dislocation Theory of the Fatigue of Metals
Machlin, E. S.
January 1948
Primary view of Flight measurements of the lateral and directional stability and control characteristics of an airplane having a 35 degree sweptback wing with 40-percent-span slots and a comparison with wind-tunnel data
Sjoberg, S. A. & Reeder, J. P.
January 1948
Primary view of A Graphical Method for Interpolation of Specific Flying Boats From Collapsed Results of General Tests of Flying-Boat-Hull Models
Locke, F. W. S., Jr.
January 1948
Primary view of An Improved Photoelastic Method for Determining Plane Stresses
Norris, C. B. & Voss, A. W.
January 1948
Primary view of A method of cycle analysis for aircraft gas-turbine power plants driving propellers
English, Robert E. & Hauser, Cavour H.
January 1948
Primary view of On Similarity Rules for Transonic Flows
Kaplan, Carl
January 1948
Primary view of On the Interpretation of Combined Torsion and Tension Tests of Thin-Wall Tubes
Prager, W.
January 1948
Primary view of Performance tests of wire strain gages 6: effect of temperature on calibration factor and gage resistance
Campbell, William R.
January 1948
Primary view of Sideslip Angles and Vertical-Tail Loads Developed by Periodic Control Deflections
Lomax, Harvard
January 1948
Primary view of Stresses in and general instability of monocoque cylinders with cutouts 5: calculation of the stresses in cylinders with side cutout
Hoff, N. J. & Klein, Bertram
January 1948
Primary view of The use of source-sink and doublet distributions extended to the solution of boundary value problems in supersonic flow
Heaslet, Max A. & Lomax, Harvard
January 1948
Primary view of Analysis of accuracy of gas-filled bellows for sensing gas density
Otto, Edward W.
February 1948
Primary view of Apparent Effect of Inlet Temperature on Adiabatic Efficiency of Centrifugal Compressors
Anderson, Robert J.; Ritter, William K. & Parsons, Shirley R.
February 1948
Primary view of An application of Falkner's surface-loading method to predictions of hinge-moment parameters for swept-back wings
Jones, Arthur L. & Sluder, Loma
February 1948
Primary view of Calculation of Uncoupled Modes and Frequencies in Bending or Torsion of Nonuniform Beams
Houbolt, John C. & Anderson, Roger A.
February 1948
Primary view of Effect of Rotor-Blade Twist and Plan-Form Taper on Helicopter Hovering Performance
Gessow, Alfred
February 1948
Primary view of The effect of tip modification and thermal de-icing air flow on propeller performance as determined from wind-tunnel tests
Gray, W. H. & Davidson, R. E.
February 1948
Primary view of The Effect of Wind Bending Deflection on the Rolling Moment Due to Sideslip
Lovell, Powell M., Jr.
February 1948
Primary view of Fatigue strength and related characteristics of aircraft joints 2: fatigue characteristics of sheet and riveted joints of 0.040-inch 24S-T, 75S-T, and R303-T275 aluminum alloys
Russell, H. W.; Jackson, L. R.; Grover, H. J. & Beaver, W. W.
February 1948
Primary view of A Generalized Theoretical and Experimental Investigation of the Motions and Hydrodynamic Loads Experienced by V-Bottom Seaplanes During Step-Landing Impacts
Milwitzky, Benjamin
February 1948
Back to Top of Screen