Technical Report Archive & Image Library (TRAIL) - 1,410 Matching Results

Search Results

open access

Absorption Characteristics of Long Soil Columns

Description: The purpose of this report is to present the information obtained relative to the characteristic adsorption of radioisotopes in a long (forty feet) laboratory soil column treated with a high salt, process waste of high activity density. The movement of adsorbed cations in a soil column subjected to prolonged leeching by water also was determined.
Date: May 1, 1955
Creator: McHenry, J. R.
Partner: UNT Libraries Government Documents Department
open access

Acceleration Characteristics of a Turbojet Engine With Variable-Position Inlet Guide Vanes

Description: Report presenting a study of the acceleration characteristics of a turbojet engine equipped with variable-position inlet guide vanes in the altitude test chamber. Maximum acceleration values for 3 engines of the same model were also obtained during testing and were found to differ as much as 50 percent. Results regarding the effect of fuel step size and inlet guide vane on acceleration, effect of flight condition, reproducibility of engine acceleration, compressor pressure ratio in relation to … more
Date: July 7, 1955
Creator: Dobson, W. F. & Wallner, Lewis E.
Partner: UNT Libraries Government Documents Department
open access

An accurate and rapid method for the design of supersonic nozzles

Description: From Introduction: "This report presents a computational procedure which provides for the rapid and accurate calculation of any streamline in a series of special flows. Detailed information is given on the boundary conditions and equations used for computing the characteristic nets and stream function."
Date: February 1955
Creator: Beckwith, Ivan E. & Moore, John A.
Partner: UNT Libraries Government Documents Department
open access

Acoustic analysis of ram-jet buzz

Description: From Introduction: "The surging of a system containing a centrifugal- or axial-flow compressor (e.g., refs. 1 to 4) is an example of self-sustained oscillation. Inlets designed for supersonic jet engines also have been observed to induce oscillations (e.g., refs. 5 to 11) which are usually referred to as "buzz." The origin of buzz in ram-jet engines is the subject of the present report."
Date: November 1955
Creator: Mirels, Harold
Partner: UNT Libraries Government Documents Department
open access

Acoustic radiation from two-dimensional rectangular cutouts in aerodynamic surfaces

Description: From Introduction: "The experiments in high-speed flow showed that an intense, high-frequency acoustic radiation is an essential feature of the problem. Consequently, a study of the acoustic field (involving schlieren observations and frequency and intensity measurements) was undertaken. This report presents the salient features of the study, which was mainly exploratory."
Date: August 1955
Creator: Krishnamurty, K.
Partner: UNT Libraries Government Documents Department
open access

Acoustical Treatment for the NACA 8- by 6-Foot Supersonic Propulsion Wind Tunnel

Description: "This report presents results of a research and engineering program performed during the first half of 1950 that resulted in an acoustical treatment for the 8- by 6-foot supersonic wind tunnel at the Lewis Flight Propulsion Laboratory" (p. 1).
Date: June 1955
Creator: Beranek, Leo L.; Labate, Samuel & Ingard, Uno
Partner: UNT Libraries Government Documents Department
open access

The Activation of Low-Reactivity Uranium Dioxide Particles

Description: A detailed study of the activation of low-reactivity UO2 particles toward HF by successive oxidation and reduction was carried out. The effect of repeated successive oxidation and reduction on the reactivity of the UO2 source material toward HF was evaluated by hydrofluorination.
Date: October 1955
Creator: Bard, R. J.; Bunker, D. L.; Greenough, R. C. & Kalmus, E. H.
Partner: UNT Libraries Government Documents Department
open access

Adaptation of Combustion Principles to Aircraft Propulsion, Volume 1, Basic Considerations in the Combustion of Hydrocarbon Fuels with Air

Description: The report summarizes source material on combustion for flight-propulsion engineers. First, several chapters review fundamental processes such as fuel-air mixture preparation, gas flow and mixing, flammability and ignition, flame propagation in both homogenous and heterogenous media, flame stabilization, combustion oscillations, and smoke and carbon formation. The practical significance and the relation of these processes to theory are presented. A second series of chapters describes the observ… more
Date: April 1, 1955
Creator: Barnett, Henry C. & Hibbard, Robert R.
Partner: UNT Libraries Government Documents Department
open access

Additional comparisons between computed and measured transonic drag-rise coefficients at zero lift for wing-body-tail configurations

Description: From Introduction: "This report makes further comparisons of the theoretical computing method with available experimental results, showing effects of wing plan-form changes, and the effect of an airfoil-section change on a wing of given plan form."
Date: August 15, 1955
Creator: Holdaway, George H.
Partner: UNT Libraries Government Documents Department
open access

Additional experimental heat-transfer and durability data on several forced-convection, air-cooled, strut-supported turbine blades of improved design

Description: Report presenting an investigation at the Lewis laboratory to develop air-cooled, strut-supported turbine blades. Six blades were investigated in a full-scale turbojet engine to obtain data on blade durability and blade-cooling effectiveness and strut temperature. Results regarding the heat-transfer investigation and blade-durability investigation are provided.
Date: January 19, 1955
Creator: Schum, Eugene F.
Partner: UNT Libraries Government Documents Department
open access

Additional measurements of the low-speed static stability of a configuration employing three triangular wing panels and a body of equal length

Description: From Introduction: "The results of an investigation of the low-speed static stability of a simplified model of such an arrangement having one of the airfoils placed vertically on top of the body and the other two as wing panels having negative dihedral are presented in reference 1. In order to provide information for predicting the effects of changes in the basic configuration on the low-speed stability characteristics presented in reference 1, additional measurements have been made."
Date: July 25, 1955
Creator: Delany, Noel K.
Partner: UNT Libraries Government Documents Department
open access

Adiabatic Injection

Description: From introduction comments: The present analysis is intended to examine the relations for "adiabatic" injection in general from a different point of view.
Date: September 22, 1955
Creator: Linlor, William I., 1915-
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and hydrodynamic characteristics of models of some aircraft-towed mine-sweeping devices : TED No. NACA AR 8201

Description: This report details a study that was conducted by the U.S. Naval Air Development Center to "determine the feasibility of several airborne magnetic mine-sweeping methods. The advantages of a satisfactory airborne method are greater safety and speed than are possible with existing surface methods." The configurations and results of the double Q-sweep, the modified double-catenary sweep, and the M-sweep are examined.
Date: December 1, 1955
Creator: Shanks, Robert E.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics and pressure distributions of a 6-percent-thick 49 degree sweptback wing with blowing over half-span and full-span flaps

Description: From Introduction: "The investigation reported herein was initiated to define further the effects on the aerodynamic characteristics and load distribution of a thin, sweptback wing of a low-pressure blowing system and also to provide information on which to base a more thorough study of a complete airplane configuration."
Date: September 20, 1955
Creator: Whittle, Edward F., Jr. & McLemore, H. Clyde
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at Mach numbers from 0.7 to 1.75 of a four-engine swept-wing airplane configuration as obtained from a rocket-propelled model test

Description: Report presenting flight testing of a rocket-propelled model of a typical multiengine airplane configuration to obtain data on drag, stability, and nacelle performance. Data were obtained at a variety of Mach numbers, lift coefficients, and subsonic and supersonic speeds. Results regarding airplane performance, nacelle performance, longitudinal characteristics, and lateral characteristics are provided.
Date: September 2, 1955
Creator: Chapman, Rowe, Jr.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a 0.04956-Scale Model of the Convair F-102A Airplane at Mach Numbers of 1.41, 1.61, and 2.01

Description: "Tests have been made in the Langley 4- by 4-foot supersonic pressure tunnel at Mach numbers of 1.41, 1.61, and 2.01 of various arrangements of a 0.04956-scale model of the Convair F-102A airplane with faired inlets. Tests made of the model equipped with a plain wing, a wing with 6.4 percent conical camber, and a wing with 15 percent conical camber. Body modifications including an extended nose, a modified canopy, and extended afterbody fillets were evaluated" (p. 1).
Date: September 30, 1955
Creator: Spearman, M. Leroy & Driver, Cornelius
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a 0.04956-Scale Model of the Convair F-102A Airplane at Transonic Speeds

Description: "Tests have been conducted in the Langley 8-foot transonic tunnel on a 0.04956-scale model of the Convair F-102A airplane which employed an indented and extended fuselage, cambered wing leading edges, and deflected wing tips. Force and moment characteristics were obtained for Mach numbers from 0.60 to 1.135 at angles of attack up to 20 degrees. In addition, tests were made over a limited angle-of-attack range to determine the effects of the cambered leading edges, deflected tips, and a nose sec… more
Date: April 11, 1955
Creator: Tempelmeyer, Kenneth E. & Osborne, Robert S.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a 1/4-Scale Model of the Duct System for the General Electric P-1 Nuclear Powerplant for Aircraft

Description: Report discussing testing on a model of the General Electric P-1 nuclear powerplant to determine its internal aerodynamic characteristics. The main purposes of testing were to measure the mass-flow distribution of air, to measure the total-pressure losses for the duct components and complete model, and to determine modifications necessary to attain the desired performance characteristics.
Date: July 29, 1955
Creator: Wood, Charles C. & Henry, John R.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of a 60 degree delta wing having a half-delta tip control at a Mach number of 4.04

Description: From Introduction: "Numerous tests of tip controls on delta wings at transonic and low supersonic speeds have shown that such configurations provide satisfactory rolling-moment effectiveness, and that the hinge can be controlled by proper location of the hinge line (ref. 1). The purpose of the present tests is to determine the characteristics of such a configuration at Mach number of 4.04 and a Reynolds number of 5.8 X 10^6, based on the wing mean aerodynamic chord."
Date: April 25, 1955
Creator: Ulmann, Edward F. & Smith, Fred M.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a Small-Scale Shrouded Propeller at Angles of Attack From 0 to 90 Degrees

Description: Note presenting an investigation to determine the effects of airspeed and angle of attack on the lift, drag, and pitching moment of a shrouded-propeller model with a shroud length of about two-thirds the propeller diameter over an angle of attack from 0 to 90 degrees. Tests were made of the complete model with the propeller operating and also of the shroud and motor combination with the propeller removed.
Date: November 1955
Creator: Parlett, Lysle P.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of NACA 0012 airfoil section at angles of attack from 0 degrees to 180 degrees

Description: Report presenting the aerodynamic characteristics of the NACA 0012 airfoil section at a range of angles of attack from 0 to 180 degrees. Data were obtained at two different Reynolds numbers depending on whether the airfoil surfaces were smooth or had roughness applied at the leading and trailing edges. After the stall with the rounded edge of the airfoil foremost, a second lift-coefficient peak was obtained at an angle of attack of about 45 degrees.
Date: January 1955
Creator: Critzos, Chris C.; Heyson, Harry H. & Boswinkle, Robert W., Jr.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of several 6-percent-thick airfoils at angles of attack from 0 degrees to 20 degrees at high subsonic speeds

Description: Report presenting two-dimensional tests of eight 6-percent-thick symmetrical airfoils of the supersonic and subsonic types. Static pressures along the surfaces of each airfoil measured over a range of Mach numbers and angles of attack. Results regarding lift coefficient, drag coefficient, quarter-chord pitching-moment coefficient, and schileren photographs of the pressure distributions are provided.
Date: May 1955
Creator: Daley, Bernard N. & Lord, Douglas R.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of two rectangular-plan-form, all moveable controls in combination with a slender body of revolution at Mach numbers from 3.00 to 6.25

Description: Report presenting the results of force and moment tests at a range of Mach numbers on two rectangular-plan-form, all-movable controls in combination with a slender body of revolution are presented and compared with the predictions of theory. The results showed that lift variations with angle of attack were somewhat nonlinear for both control-body combinations tested.
Date: December 28, 1955
Creator: Wong, Thomas J. & Gloria, Hermilo R.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Two Rectangular-plan-form, Allmovable Controls in Combination With a Slender Body of Revolution at Mach Numbers From 3.00 to 6.25

Description: Aerodynamic characteristics of rectangular platform, all-movable controls combined with slender body of revolution at Mach 3 to 6.25. The results showed that lift variations with angle of attack were somewhat nonlinear for both control-body combinations tested.
Date: December 28, 1955
Creator: Wong, Thomas J. & Gloria, Hermilo R.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen