Technical Report Archive & Image Library (TRAIL) - 12 Matching Results

Search Results

Results: 1 - 12
open access

N.A.C.A. Stall-Warning Device

Description: With some airplanes the approach to the stall is accompanied by changes in the behavior, such as tail buffeting or changes in the control characteristics of the airplane so that the pilot obtains a warning of the impending stall. Vith other airplanes it is possible to approach the stall without any perceptible warning other than the reading of the air-speed meter, in which case the danger of inadvertent stalling is considerably greater. Although it is not within the scope of this paper to discu… more
Date: February 1938
Creator: Thompson, F. L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effect of Surface Irregularities on Wing Drag 1 - Rivets and Spot Welds

Description: "Tests have been conducted in the NACA 8-foot high-speed wind tunnel to determine the effect of exposed rivet heads and spot welds on wing drag. Most of the tests were made with an airfoil of 5-foot chord. The air speed was varied from 80 to 500 miles per hour and the lift coefficient from 0 to 0.30" (p. 1).
Date: February 1938
Creator: Hood, Manley J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effect of Surface Irregularities on Wing Drag 2 - Lap Joints

Description: Tests have been made in the NACA 8-foot high-speed wind tunnel of the drag caused by four types of lap joint. The tests were made on an airfoil of NACA 23012 section and 5-foot chord and covered in a range of speeds from 80 to 500 miles per hour and lift coefficients from 0 to 0.30. The increases in profile drag caused by representative arrangements of laps varied from 4 to 9%. When there were protruding rivet heads on the surface, the addition of laps increased the drag only slightly. Laps on … more
Date: February 1938
Creator: Hood, Manley J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effect of Surface Irregularities on Wing Drag 3 - Roughness

Description: "Tests have been made in the N.A.C.A. 8-foot high-speed wind tunnel of the drag caused by roughness on the surface of an airfoil of N.A.C.A. 23012 section and 5-foot chord. The tests were made at speeds from 80 to 500 miles per hour at lift coefficients from 0 to 0.30. For conditions corresponding to high-speed flight, the increase in the drag was 30 percent of the profile drag of the smooth airfoil for the roughness produced by spray painting and 63 percent for the roughness produced. by 0.003… more
Date: February 1938
Creator: Hood, Manley J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effect of Surface Irregularities on Wing Drag 4 - Manufacturing Irregularities

Description: "Tests were made in the NACA 8-foot high speed wind tunnel of a metal-covered, riveted, 'service' wing of average workmanship to determine the aerodynamic effects of the manufacturing irregularities incident to shop fabrication. The wing was of 5-foot chord and of NACA 23012 section and was tested in the low-lift range at speeds from 90 to 450 miles per hour corresponding to Reynolds numbers from 4,000,000 to 18,000,000. At a cruising condition the drag of the service wing was 46% higher than t… more
Date: February 1938
Creator: Robinson, Russell G.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The estimation of the rate of change of yawing moment with sideslip

Description: "Wind-tunnel data are presented on the rate of change of yawing moment with sideslip for tests of 9 complete airplane models, 20 fuselage shapes, and 3 wing models with various combinations of dihedral, sweepback, and twist. The data were collected during a survey of existing information, which was made to find a reliable method of computing the yawing moment due to sideslip. Important errors common to methods of computation used at present appear to be due to large interference effects, the in… more
Date: February 1938
Creator: Imlay, Frederick H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Planing-Surface Tests at Large Froude Numbers - Airfoil Comparison

Description: "The take-off capacity of a flying boat depends upon the design of the hull bottom ahead as well as aft of the step. Systematic tests - largely made by industry itself - had proved the benefit accruing from a well designed hull bottom long before theoretical insight into the flow phenomena involved had been obtained. The theoretical framing of the problem was beset with serious difficulties and, though restricted to the processes within range of the planing bottom ahead of the step, the solutio… more
Date: February 1938
Creator: Sambraus, A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Preliminary Fatigue Studies on Aluminum Alloy Aircraft Engines

Description: "Preliminary information on the complex subject of the fatigue strength of fabricated structural members for aircraft is presented in the test results obtained on several different types of airship girders subjected to axial tension and compression in a resonance fatigue machine. A description of this machine as well as numerous photographs of the fatigue failures are given. There is also presented an extended bibliography on the subject of fatigue strength" (p. 1).
Date: February 1938
Creator: Goodyear-Zeppelin Corporation
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Rate-of-Climb Recorder

Description: The chief advantage of the instrument lies in the degree of accuracy obtainable with suitably flexible capsule (dynamic pressure recorder with small test range) and in its sensitivity for recording static-pressure changes. A description and hook-up of the instrument is provided along with calculations of error.
Date: February 1938
Creator: Danielzig, Helmut
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Tank tests of a model of one hull of the Savoia S-55-X flying boat - N.A.C.A. Model 46

Description: A model of one of the twin hulls of the Italian Savoia S-55-X flying boat (N.A.C.A. Model 46) was tested in the N.A.C.A. tank according to the general method. The data obtained from these tests cover a broad range of speeds, loads, and trims and are given in nondimensional form to facilitate their use in applying this form of hull to any other flying boat or comparing it's performance with the performance of any other hulls. The results show that the resistance characteristics at best trim of t… more
Date: February 1938
Creator: Allison, John M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Two-Dimensional Subsonic Compressible Flow Past Elliptic Cylinders

Description: "The method of Poggi is used to calculate, for perfect fluids, the effect of compressibility upon the flow on the surface of an elliptic cylinder at zero angle of attack and with no circulation. The result is expressed in a closed form and represents a rigorous determination of the velocity of the fluid at the surface of the obstacle insofar as the second approximation is concerned. Comparison is made with Hooker's treatment of the same problem according to the method of Janzen and Rayleight an… more
Date: February 11, 1938
Creator: Kaplan, Carl
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Investigation of an NACA 23012 Airfoil with Various Arrangements of Slotted Flaps

Description: "An investigation was made in the 7 by 10-foot wind tunnel and in the variable-density wind tunnel of the NACA 23012 airfoil with various slotted-flap arrangements. The purpose of the investigation in the 7 by 10-foot wind tunnel was to determine the airfoil section aerodynamic characteristics as affected by flap shape, slot shape, and flap location. The flap position for maximum lift; polars for arrangements favorable for take-off and climb; and complete lift, drag, and pitching-moment charact… more
Date: February 12, 1938
Creator: Wenzinger, Carl J. & Harris, Thomas A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen