Technical Report Archive & Image Library (TRAIL) - 1,423 Matching Results

Search Results

prev Results: 25 - 48 next
open access

Wind-Tunnel Investigation of an NACA 23012 Airfoil with Various Arrangements of Slotted Flaps

Description: "An investigation was made in the 7 by 10-foot wind tunnel and in the variable-density wind tunnel of the NACA 23012 airfoil with various slotted-flap arrangements. The purpose of the investigation in the 7 by 10-foot wind tunnel was to determine the airfoil section aerodynamic characteristics as affected by flap shape, slot shape, and flap location. The flap position for maximum lift; polars for arrangements favorable for take-off and climb; and complete lift, drag, and pitching-moment charact… more
Date: February 12, 1938
Creator: Wenzinger, Carl J. & Harris, Thomas A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculation of the Aerodynamic Characteristics of Tapered Wings With Partial-Span Flaps

Description: "Factors derived from wing theory are presented. By means of these factors, the angle of zero lift, the lift-curve slope, the pitching moment, the aerodynamic-center position, and the induced drag of tapered wings with partial-span flaps may be calculated. The factors are given for wings of aspect ratios 6 and 10 , of taper ratios from 0.25 to 1.00, and with flaps of various length. An example is presented of the method of application of the factors. Fair agreement with experimental results is … more
Date: January 23, 1939
Creator: Pearson, Henry A. & Anderson, Raymond F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Preignition characteristics of several fuels under simulated engine conditions

Description: "The preignition characteristics of a number of fuels have been studied under conditions similar to those encountered in an engine. These conditions were simulated by suddenly compressing a fuel-air mixture in contact with an electrically heated hot spot in the cylinder head of the NACA combustion apparatus. Schlieren photographs and indicator cards were taken of the burning, and the hot-spot temperatures necessary to cause ignition under various conditions were determined" (p. 121).
Date: September 16, 1940
Creator: Spencer, R. C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Free-spinning wind-tunnel tests of a low-wing monoplane with systematic changes in wings and tails V: effect of airplane relative density

Description: The reported tests are a continuation of an NACA investigation being made in the free-spinning wind tunnel to determine the effects of independent variations in load distribution, wing and tail arrangement, and control disposition on the spin characteristics of airplanes. The standard series of tests was repeated to determine the effect of airplane relative density. Tests were made at values of the relative-density parameter of 6.8, 8.4 (basic), and 12.0; and the results were analyzed. The test… more
Date: January 11, 1940
Creator: Seidman, Oscar & Neihouse, A. I.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Effective Gust Structure at Low Altitudes as Determined From the Reactions of an Airplane

Description: "Measurements of gust structure and gust intensity were made in the lower levels of the atmosphere (0 to 3,500 ft.). An Aeronca C-2 airplane was used as the measuring instrument, the gust structure being derived from the recorded motions of the airplane. Data were also obtained on wind velocities and temperatures as functions of altitude for use in attempting to correlate the gust-structure data with various meteorological quantities" (p. 263).
Date: October 19, 1939
Creator: Donely, Philip
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A theoretical study of lateral stability with an automatic pilot

Description: "The influence of automatic operation of the aileron and rudder controls on the lateral stability of an airplane is discussed. The control deflections are assumed to be proportional to the deviations and to the rates of deviation of the airplane from steady-flight conditions. The effects of changes in the types of deviation governing control application are considered. For one simple method of control in which the aileron deflection is proportional to the angle of bank and the rudder deflection… more
Date: March 4, 1940
Creator: Imlay, Frederick H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Mechanical Properties of Flush-Riveted Joints

Description: "The strength of representative types of flush-riveted joints has been determined by testing 865 single-shearing, double-shearing, and tensile specimens representing 7 types of rivet and 18 types of joint. The results, presented in graphic form, show the stress at failure, type of failure, and d/t ratio. In general, dimpled joints were appreciably stronger than countersunk or protruding-head joints, but their strength was greatly influenced by constructional details" (p. 467).
Date: November 1939
Creator: Brueggeman, W. C. & Roop, Frederick C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Calculated Effect of Various Hydrodynamic and Aerodynamic Factors on the Take-Off of a Large Flying Boat

Description: Report presents the results of an investigation made to determine the influence of various factors on the take-off performance of a hypothetical large flying boat by means of take-off calculations. The factors varied in the calculations were size of hull (load coefficient), wing setting, trim, deflection of flap, wing loading, aspect ratio, and parasite drag. The take-off times and distances were calculated to the stalling speeds and the performance above these speeds was separately studied to … more
Date: April 29, 1940
Creator: Olson, R. E. & Allison, J. M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A high-speed motion-picture study of normal combustion, knock and preignition in a spark-ignition engines

Description: Combustion in a spark-ignition engine was investigated by means of the NACA high-speed motion-picture cameras. This camera is operated at a speed of 40,000 photographs a second and therefore makes possible the study of changes that take place in the intervals as short as 0.000025 second. When the motion pictures are projected at the normal speed of 16 frames a second, any rate of movement shown is slowed down 2500 times. Photographs are presented of normal combustion, of combustion from preigni… more
Date: July 24, 1940
Creator: Rothrock, A. M.; Spencer, R. C. & Miller, Cearcy D.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel investigation of effect of interference on lateral-stability characteristics of four NACA 23012 wings, an elliptical and a circular fuselage and vertical fins

Description: Report presents the results of a wind-tunnel investigation of the effect of wing-fuselage interference on lateral-stability characteristics made in the NACA 7 by 10-foot wind tunnel on four fuselages and two fins, representing high-wing, low-wing, and midwing monoplanes. The fuselages are of circular and elliptical cross section. The wings have rounded tips and, in plan form, one is rectangular and the three are tapered 3:1 with various amounts of sweep. The rate of change in the coefficients o… more
Date: August 8, 1940
Creator: House, Rufus O. & Wallace, Arthur R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Design Charts Relating to the Stalling of Tapered Wings

Description: An aid in airplane design, charts have been prepared to show the effects of wing taper, thickness ratio, and Reynolds number on the spanwise location of the initial stalling point. Means of improving poor stalling characteristics resulting from certain combinations of the variables have also been considered; additional figures illustrate the influence of camber increase to the wing tips, washout, central sharp leading edges, and wing-tip slots on the stalling characteristics. Data are included … more
Date: January 18, 1940
Creator: Soulé, H. A. & Anderson, R. F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Tensile Elastic Properties of Typical Stainless Steels and Nonferrous Metals as Affected by Plastic Deformation and by Heat Treatment

Description: A general discussion is given of the relationships between stress, strain, and permanent set. From stress-set curves are derived proof stresses based on five different percentages of permanent set. The influence of prior plastic extension on these values is illustrated and discussed. A discussion is given of the influence of work-hardening, rest interval, and internal stress on the form of the proof stress-extension curve.
Date: February 23, 1940
Creator: McAdam, D. J., Jr. & Mebs, R. W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Investigations on the Incompletely Developed Plane Diagonal-Tension Field

Description: This report presents the results of an investigation on the incompletely developed diagonal-tension field. Actual diagonal-tension beams work in an intermediate stage between pure shear and pure diagonal tension; the theory developed by Wagner for diagonal tension is not directly applicable.
Date: March 28, 1940
Creator: Kuhn, Paul
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Investigation of Spoiler, Deflector, and Slot Lateral-Control Devices on Wings With Full-Span Split and Slotted Flaps

Description: Report presents the results of an extensive investigation made in the NACA 7 by 10-foot wind tunnel of spoiler, deflector, and slot types of lateral-control device on wings with full-span split and slotted flaps. The static rolling and yawing moments were determined for all the devices tested, and the static hinge moments and the time response were determined for a few devices of each type.
Date: August 13, 1940
Creator: Wenzinger, Carl J. & Rogallo, Francis M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The additional-mass effect of plates as determined by experiments

Description: From Introduction: "The apparent increase in the inertia properties of a body moving in a fluid medium has been called the additional-mass effect. This report presents a resume of test procedures and results of experimental determinations of the additional-mass effect of flat plates. In addition to data obtained from various foreign sources and from a NACA investigation in 1933, the results of tests recently conducted by the National Advisory Committee for Aeronautics are included."
Date: 1941
Creator: Gracey, William
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Tests of the NACA 0025 and 0035 Airfoils in the Full-Scale Wind Tunnel

Description: This report presents the results of an investigation conducted in the NACA full-scale wind tunnel to determine the aerodynamic characteristics of the 6 by 36-foot rectangular NACA 0025 and 0035 airfoils. The aerodynamic characteristics of the plain airfoils with rounded and square tips were determined by force tests through a complete angle-of-attack range; in addition, the profile drag was determined by the momentum method. The transition points on the airfoils were located by boundary-layer d… more
Date: 1941
Creator: Bullivant, W. Kenneth
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Internal-Flow Systems for Aircraft

Description: An investigation has been made to determine efficient arrangements for an internal-flow system of an aircraft when such a system operates by itself or in combination with other flow systems. The investigation included a theoretical treatment of the problem and tests in the NACA 5-foot vertical wind tunnel of inlet and outlet openings in a flat plate and in a wing.
Date: 1941
Creator: Rogallo, F. M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Lateral Control Required for Satisfactory Flying Qualities Based on Flight Tests of Numerous Airplanes

Description: Report presents the results of an analysis made of the aileron control characteristics of numerous airplanes tested in flight by the National Advisory Committee for Aeronautics. By the use of previously developed theory, the observed values of pb/2v for the various wing-aileron arrangements were examined to determine the effective section characteristics of the various aileron types.
Date: April 18, 1941
Creator: Gilruth, R. R. & Turner, W. N.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Column Strength of Two Extruded Aluminum-Alloy H-Sections

Description: "Extruded aluminum-alloy members of various cross sections are used in aircraft as compression members either singly or as stiffeners for aluminum-alloy sheet. In order to design such members, it is necessary to know their column strength or, in the case of stiffeners, the value of the double modulus, which is best obtained for practical purposes from column tests. Column tests made on two extruded h-sections are described, and column formulas and formulas for the ratio of the double modulus to… more
Date: September 30, 1938
Creator: Osgood, William R. & Holt, Marshall
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The influence of directed air flow on combustion in spark-ignition engine

Description: "The air movement within the cylinder of the NACA combustion apparatus was regulated by using shrouded inlet valves and by fairing the inlet passage. Rates of combustion were determined at different inlet-air velocities with the engine speed maintained constant and at different engine speeds with the inlet-air velocity maintained approximately constant. The rate of combustion increased when the engine speed was doubled without changing the inlet-air velocity; the observed increase was about the… more
Date: October 10, 1938
Creator: Rothrock, A. M. & Spencer, R. C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The unsteady lift of a wing of finite aspect ratio

Description: "Unsteady-lift functions for wings of finite aspect ratio have been calculated by correcting the aerodynamic inertia and the angle of attack of the infinite wing. The calculations are based on the operational method. The starting lift of the finite wing is found to be only slightly less than that of the infinite wing; whereas the final lift may be considerably less" (p. 1).
Date: June 15, 1939
Creator: Jones, Robert T.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen