Search Results

open access

Tank tests of a 1/8-size dynamic model of the PB2Y-3 airplane with increased power: NACA model 131

Description: Report presenting a study of the installation of 1800-horsepower engines in the PB2Y-3 airplane in place of the current 1200-horsepower engines. Stability and spray tests were made to determine the performance of the model on the water when tested at both the present and projected conditions of gross load and engine power. Results regarding aerodynamic tests and hydrodynamic tests are provided.
Date: June 1943
Creator: Bell, Joe W. & Havens, Robert F.
Partner: UNT Libraries Government Documents Department
open access

Tank Tests of a 1/8-Size Dynamic Model of the PB2Y-3 Airplane with Simulated Jet Motors: NACA Models 131J, 131J-1 and 131J-2

Description: Report presenting an investigation to determine the effect of jet motors on the stability of the PB2Y-3 airplane at a gross load of 76,000 pounds. Results regarding Model 131J, Model 131J-1, and Model 131J-2 are provided.
Date: June 1943
Creator: Bell, Joe W. & Havens, Robert F.
Partner: UNT Libraries Government Documents Department
open access

Test Data on the Shear Strength of Joints Assembled With Round-Head and Brazier-Head Rivets

Description: Report discusses data obtained from testing shear of joints riveted with round-head and brazier-head rivets. The tightness of the rivets is also compared for one value of rivet diameter. The load-displacement curves and comparison of load at various values of permanent displacement are presented for both types of rivets.
Date: June 1943
Creator: Mandel, Merven W. & Schuette, Evan H.
Partner: UNT Libraries Government Documents Department
open access

Tests of 10-Inch 24S-T Aluminum-Alloy Shear Panels With 1-1/2-Inch Holes

Description: Report discusses the results of testing on "10-inch shear panels of 24S-T aluminum alloy with 1.5 inch holes to determine the stress concentration at static rupture and the deformation characteristics" (from Summary). The strength of the perforated specimens is compared to the solid specimens and the critical stresses are computed. The stress at which permanent set occurs was also measured.
Date: June 1943
Creator: Kuhn, Paul & Levin, L. Ross
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Investigation of Control-Surface Characteristics 14: NACA 0009 Airfoil With a 20-Percent-Chord Double Plain Flap

Description: Report discusses the results of force testing of the aerodynamic characteristics of an NACA 0009 airfoil with a double plain flap; it consisted of a plain forward flap with a chord 20 percent of the airfoil chord and a plan rearward flap with a chord 15 percent of the airfoil chord. Comparisons were made to the characteristics of a 0.50c single plain flap. The lift, hinge moments, drag, and pitching moments are described.
Date: June 1943
Creator: Sears, Richard I. & Purser, Paul E.
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Investigation of Effect of Yaw on Lateral-Stability Characteristics 5: Symmetrically Tapered Wing With a Circular Fuselage Having a Horizontal and a Vertical Tail

Description: Report discussing testing to determine the effect of a horizontal tail on the lateral-stability characteristics of a high-wing, a midwing, and a low-wing monoplane. The model was created from a circular fuselage, an NACA 23012 tapered wing, and an NACA 0009 horizontal tail surface. Information about the effective aspect ratio of the tail, restoring moment of yaw, and vertical-tail effectiveness as compared to the wing position is provided.
Date: June 1943
Creator: Wallace, Arthur R. & Turner, Thomas R.
Partner: UNT Libraries Government Documents Department
open access

Wind Tunnel Tests of Ailerons at Various Speeds 1: Ailerons of 0.20 Airfoil Chord and True Contour With 0.35 Aileron-Chord Extreme Blunt Nose Balance on the NACA 66,2-216 Airfoil

Description: "Hinge-moment, lift, and pressure-distribution measurements were made in the two-dimensional test section of the NACA stability tunnel on a blunt-nose balance-type aileron on an NACA 66,2-216 airfoil at speeds up to 360 miles per hour corresponding to a Mach number of 0.475. The tests were made primarily to determine the effect of speed on the action of this type of aileron. The balance-nose radii of the aileron were varied from 0 to 0.02 of the airfoil chord and the gap width was varied from 0… more
Date: June 1943
Creator: Letko, W.; Denaci, H. G. & Freed, C.
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel tests of ailerons at various speeds 2: ailerons of 0.20 airfoil chord and true contour with 0.60 aileron-chord sealed internal balance on the NACA 66,2-216 airfoil

Description: Report presenting hinge-moment, lift, pressure difference across the balance, and pressure-distribution measurements in the two-dimensional test section of the stability tunnel on a 0.60 aileron-chord sealed internal-balance aileron on a specified NACA airfoil. The primary test objective was to determine the effect of speed on the action of the aileron.
Date: June 1943
Creator: Denaci, H. G. & Bird, J. D.
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel vibration tests of a four-blade single rotating pusher propeller

Description: Report presenting vibration tests of a four-blade single-rotating propeller operating in a simulated pusher condition performed because the combination of wake and downwash behind a wing might provide serious excitation for reactionless vibrations of propellers with four or more blades. Measurements of propeller vibratory stress were made for various airspeeds, engine speeds, and engine powers.
Date: June 1943
Creator: Miller, Mason F.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen