National Advisory Committee for Aeronautics (NACA) - 4,160 Matching Results

Search Results

prev Results: 11 - 34 next
open access

Additional Abstracts Pertaining to Seaplanes

Description: "About 500 additional references pertaining to hydrodynamic design of seaplanes have been compiled, and the information is presented in the form of abstracts classified under six main headings:GENERAL INFORMATION, HYDROSTATICS, HYDRODYNAMICS, AERODYNAMICS, OPERATION, and RESEARCH. The compilation is an extension of NACA RM No. L6I13, entitled "Abstracts Pertaining to Seaplanes," by Jerold M. Bidwell and Douglas A. King. An author index and a subject index are included" (p. 1).
Date: March 9, 1948
Creator: Bidwell, Jerold M. & King, Douglas A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional design charts relating to the stalling of tapered wings

Description: From Introduction: "The present report, therefore, may be considered a supplement to reference 1. The combined scope of the stall charts of reference 1, designated A, and of the present work, designated B, is summarized in the following table: For the wing with root thickness ratio to 18 was also investigated.
Date: January 1943
Creator: Harmon, Sidney M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional free-flight tests of the rolling effectiveness of several wing-spoiler arrangements at high subsonic, transonic, and supersonic speeds

Description: From Introduction: "The purpose of the present paper is to present results obtained recently relating to the characteristics of a full-span sharp-edge spoiler with an 0.02-chord projection above the wing surface at several chordwise positions and also to the relative effectiveness of the sharp-edge spoiler and a wedge-type spoiler located at the 80-percent-chord line."
Date: November 24, 1948
Creator: Strass, H. Kurt
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An Additional Investigation of the High-Speed Lateral-Control Characteristics of Spoilers

Description: Report presenting an investigation of the characteristics of partial-span spoilers located at 0.75 of the chord on an NACA 66-series tapered wing, especially at high speeds. The effect of small spoiler projections was found to increase with an increase in speed until the critical Mach number was exceeded.
Date: June 1945
Creator: Laitone, Edmund V. & Summers, James L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The additional-mass effect of plates as determined by experiments

Description: From Introduction: "The apparent increase in the inertia properties of a body moving in a fluid medium has been called the additional-mass effect. This report presents a resume of test procedures and results of experimental determinations of the additional-mass effect of flat plates. In addition to data obtained from various foreign sources and from a NACA investigation in 1933, the results of tests recently conducted by the National Advisory Committee for Aeronautics are included."
Date: 1941
Creator: Gracey, William
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional power-on wind-tunnel tests of the 1/8-scale model of the Brewster F2A airplane with full-span slotted flaps

Description: "Additional tests as recommended in reference 1 were made in the 7- by 10-foot wind tunnel of the 1/8-scale model of the Brewster F2A airplane to determine the angle of attack of horizontal tail and the elevator angles required for trim with flaps down" (p. 1).
Date: October 1941
Creator: Lowry, John G.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Results in a Free-Flight Investigation of Control Effectiveness of Full-Span, 0.2-Chord Plain Ailerons at High Subsonic, Transonic, and Supersonic Speeds to Determine Some Effects of Wing Sweepback, Aspect Ratio, Taper, and Section Thickness Ratio

Description: Report discussing an aerodynamic control effectiveness study using free-flight, rocket-propelled test vehicles. Information about the effects of wing sweepback, aspect ratio, taper ratio, and section thickness ratio on the rolling effectiveness of full-span, sealed ailerons is provided.
Date: April 23, 1948
Creator: Sandahl, Carl A. & Strass, H. Kurt
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Advantages of Uniform Fuel Distribution for Air-Cooled Engines From Considerations of Cooling Requirements and Fuel Economy

Description: "The purpose of this report is to show by analysis of existing data, pending direct experimental determination, the extent to which nonuniform distribution of fuel to cylinders of a multicylinder engine can produce temperature deviation and the benefits to be anticipated from attainment of uniform fuel distribution" (p. 1).
Date: December 1943
Creator: Rubert, K. F.; Corson, Blake W., Jr. & Nielsen, Jack
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and Hydrodynamic Tests of a Family of Models of Flying-Boat Hulls Derived From a Streamline Body: NACA Model 84 Series

Description: Report presenting a series of related flying-boat hull forms with various combinations of aerodynamic and hydrodynamic requirements that were tested in an NACA tank and high-speed tunnel. Effects explored included varying the height of the bow, varying the height of the stern, increasing the angle of dead rise at the bow, decreasing the angle of dead rise on the afterbody, increasing the depth of step, increasing the angle of afterbody keel, adding chine flare, adding a third planing surface, a… more
Date: September 1943
Creator: Parkinson, John B.; Olson, Roland E.; Draley, Eugene C. & Luoma, Arvo A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and hydrodynamic tests of a family of models of flying hulls derived from a streamline body -- NACA model 84 series

Description: Report discussing a series of related forms of flying-boat hulls representing various degrees of compromise between aerodynamic and hydrodynamic requirements was tested in Langley Tank No. 1 and in the Langley 8-foot high-speed tunnel. The purpose of the investigation was to provide information regarding the penalties in water performance resulting from further aerodynamic refinement and, as a corollary, to provide information regarding the penalties in range or payload resulting from the reten… more
Date: 1943
Creator: Parkinson, John B.; Olson, Roland E.; Draley, Eugene C. & Luoma, Arvo A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics and Flap Loads of the Brake-Flap Installation on the 0.40-Scale Model of the F4F-3 Left Wing Panel

Description: "The data are presented in coefficient form and include lift, drag, and pitching-moment coefficients of the airfoil-flap comoinations and the normal-force, chord-force, and hinge-moment coefficients of the upper (perforated split) flap and lower (slotted) flap" (p. 1).
Date: October 1942
Creator: Purser, Paul E. & Liddell, Robert B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at high speeds of a two-blade NACA 10-(3)(062)-045 propeller and of a two-blade NACA 10-(3)(08)-045 propeller

Description: From Introduction: "The aerodynamic characteristics of a series of 10-foot-diameter propellers are being investigated in the Langley 16-foot high-speed tunnel in a comprehensive propeller research program. Using high-critical-speed NACA 16-series airfoil sections (reference 1), these propellers are designed to have Betz minimum induced-energy loss loading (reference 2) for a blade angle of 45^o at the 0.7 radius, when used as a four-blade propeller operating at an advance ratio of approximately… more
Date: October 1, 1948
Creator: Solomon, William
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at high speeds of full-scale propellers having Clark Y blade sections

Description: From Introduction: "The single purpose of this paper is to make available the data obtained from tests of these two Clark Y section propellers as quickly as possible with no attempt being made to analyze the results or to compare them with other high-speed-propeller test results."
Date: October 26, 1948
Creator: Johnson, Peter J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics at High Speeds of Full-Scale Propellers Having Different Shank Designs

Description: "Tests of two 10-foot-diameter two-blade propellers which differed only in shank design have been made in the Langley 16-foot high-speed tunnel. The propellers are designated by their blade design numbers, NACA 10-(5)(08)-03, which had aerodynamically efficient airfoil shank sections, and NACA 10-(5)(08)-03R which had thick cylindrical shank sections typical of conventional blades. The propellers mere tested on a 2000-horsepower dynamometer through a range of blade-angles from 20 degrees to 55 … more
Date: February 13, 1947
Creator: Maynard, Julian D.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at high speeds of related full-scale propellers having different blade-section cambers

Description: From Summary: "Wind-tunnel tests of a full-scale two-blade NACA 10-(10)(08)-03 (high camber) propeller have been made for a range of blade angles from 20 degrees to 55 degrees at airspeeds up to 500 miles per hour. The results of these tests have been compared with results from previous tests of the NACA 10-(3) (08)-03 (low camber) and NACA 10-(5)(08)-03 (medium camber) propellers to evaluate the effects of blade-section camber on propeller aerodynamic characteristics."
Date: May 6, 1948
Creator: Maynard, Julian D. & Salters, Leland B., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at subcritical and supercritical Mach numbers of two airfoil sections having sharp leading edges and extreme rearward positions of maximum thickness

Description: From Introduction: "A 12-percent-chord-thick wedge section and a reversed NACA 0012 section were chosen for these tests as they are representative of sections having no boat tailing and appreciable boat tailing (i.e., blunt and rounded trailing edges, respectively), and the results of this investigation are compared with those obtained from a previous investigation of the NACA 0012 section. Conclusions are drawn regarding the relative merits of the two unconventional sections and the convention… more
Date: November 6, 1947
Creator: Eggers, A. J., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at subsonic and supersonic Mach numbers of a thin triangular wing of aspect ratio 2 1: maximum thickness at 20 percent of the chord

Description: From Summary: "This report presents the results of a wind-tunnel investigation conducted to determine the effects of Mach number on the aerodynamic characteristics of a wing of triangular plan form."
Date: November 19, 1948
Creator: Berggren, Robert E. & Summers, James L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at subsonic and supersonic Mach numbers of a thin triangular wing of aspect ratio 2 2: maximum thickness at midchord

Description: "The lift, drag, and pitching-moment characteristics of a triangular wing, having an aspect ratio of 2 and a symmetrical double-wedge profile of 5-percent-chord maximum thickness at midchord, have been evaluated from wind-tunnel tests at Mach numbers from 0.50 to 0.975 and from 1.09 to 1.49 and at Reynolds numbers ranging from 0.67 to 0.85 million. The lift, drag, and pitching-moment coefficients of the triangular wing with a leading-edge sweepback of approximately 63 degrees did not exhibit th… more
Date: December 3, 1948
Creator: Walker, Harold J. & Berggren, Robert E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at subsonic and transonic speeds of a 42.7 degree sweptback wing model having an aileron with finite trailing-edge thickness

Description: Report presenting an investigation at subsonic and transonic speeds in the high-speed 7- by 10-foot tunnel to determine the aerodynamic characteristics of a 42.7 degree sweptback wing with a 20-percent-chord and 50-percent-span outboard aileron. The investigation was performed in transonic flow over a bump on the tunnel floor and in subsonic flow on one of the tunnel side walls.
Date: January 12, 1949
Creator: Turner, Thomas R.; Lockwood, Vernard E. & Vogler, Raymond D.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics for Internal-Balance and Frise Type Ailerons on an NACA 6 Series Low-Drag Tip Section of the Wing for the XP-63 Airplane

Description: Report presenting testing in the two-dimensional turbulence tunnel of a model of the tip section of the wing of the XP-63 airplane. Several alterations of the skirts and balance on the internal-balance aileron were tested to obtain various aerodynamic characteristics of the aileron.
Date: October 1942
Creator: Underwood, William J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of 15 NACA airfoil sections at seven Reynolds numbers from 0.7 x 10(exp 6) to 9.0 x 10(exp 6)

Description: Report presenting an investigation of the two-dimensional aerodynamic characteristics of 15 NACA airfoils at four Reynolds numbers. The results indicate that the drag coefficient at the design lift coefficient and the maximum lift coefficient are the most important aerodynamic characteristics and are most affected by Reynolds number changes.
Date: October 1949
Creator: Loftin, Laurence K., Jr. & Smith, Hamilton A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen