National Advisory Committee for Aeronautics (NACA) - 1,263 Matching Results

Search Results

prev Results: 81 - 104 next
open access

Breaking Aircraft-Engine Oil Foams by Use of Electrically Charged Condenser Plates

Description: Report presenting a determination of the effectiveness of a charged condenser for breaking oil foams and to obtain data on which to base the design of such a device for mounting at the oil-tank inlet of an airplane. Results regarding the condenser-plate area and arrangement, wet-plate design, condenser voltage, oil temperature, water in oil, and some safety considerations are provided.
Date: November 1944
Creator: Pinkel, I. Irving
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculated and measured turning performance of a Navy F2A-3 airplane as affected by the use of flaps

Description: Report presenting results of flight tests to determine the turning performance of a Navy F2A-3 airplane over a range of speeds for three flap deflections at two altitudes. The results are correlated with an analytical study of turning performance in which the effect of thrust on maximum lift coefficient was considered.
Date: September 1943
Creator: Clousing, Lawrence A.; Gadeberg, Burnett L. & Kauffman, William M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculated effects of full-span slotted and Fowler flaps on longitudinal stability and control characteristics for a typical fighter-type airplane with various tail modifications

Description: Report presenting an analytical study of the influence of full-span slotted and Fowler flaps on the requirements for horizontal tail surfaces. The elevator deflection required to land at three-point attitude, elevator deflection required to stall the airplane at altitude, and permissible center-of-gravity range have been calculated for a fighter-type airplane.
Date: July 1942
Creator: Goranson, R. Fabian
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculation of Stick Forces for an Elevator With a Spring Tab

Description: "Formulas for the calculation of hinge-moment characteristics of an elevator with a spring tab have been developed in terms of basic aerodynamic parameters, spring stiffness, and airspeed. The formulas have been used in a study of the stick-force gradients on a pursuit airplane equipped with an elevator with a spring tab. Charts are presented showing the variation of stick-force gradient in accelerated flight over a large range of speed and the complete range of spring stiffness for various cen… more
Date: June 1944
Creator: Greenberg, Harry
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculation of tab characteristics for flight conditions from wind-tunnel data

Description: Report presenting tail-surface characteristics calculated from wind-tunnel data, which have been reported to not correspond with flight-test measurements. The primary problem under consideration is the calculation of the effect of tab deflection on the free-floating angle of the elevator, as in a servocontrol.
Date: April 1942
Creator: Sears, Richard I.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculation of the Aileron and Elevator Stick Forces and Rudder Pedal Forces for the Bell XP-83 Airplane (Project MX-511) in Spins

Description: "Aileron and elevator stick forces and rudder pedal forces for the Bell XP-83 airplane in spins have been calculated. The results indicate that the aileron and elevator stick forces may be excessive unless some suitable booster or more highly balanced control surfaces are used. The pilot will be able to move the surfaces only slightly from their normal floating locations" (p. 1).
Date: September 1945
Creator: Stone, Ralph W., Jr. & Schneiter, Leslie E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculations of Intake-Air Cooling Resulting From Water Injection and of Water Recovery From Exhaust Gas

Description: Report discussing some calculations made for the effects of water in cooling the inlet air of aircraft-engine cylinders. From Summary: "The estimates indicate that the cooling effect of the water on the inlet air can be more extensive than the cooling now obtained with the intercoolers or aftercoolers in the air-induction system. In connection with water recovery from the exhaust gas, the estimates indicate that sufficient water can be recovered from 50 percent of the exhaust gas to provide an … more
Date: August 1944
Creator: Rothrock, Addison M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calculations of the Performance of a Compression-Ignition Engine-Compressor Turbine Combination 1: Performance of a Highly Supercharged Compression-Ignition Engine

Description: From Summary: "Small high-speed single-cylinder compression-ignition engines were tested to determine their performance characteristics under high supercharging. Calculations were made on the energy available in the exhaust gas of the compression-ignition engines. The maximum power at any given maximum cylinder pressure was obtained when the compression pressure was equal to the maximum cylinder pressure. Constant-pressure combustion was found possible at an engine speed of 2200 rpm."
Date: December 1945
Creator: Sanders, J. C. & Mendelson, Alexander
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calibrations of pitot-static tubes at high speeds

Description: Report presenting the calibrations of three types of service pitot-static tubes over an approximate range of speeds of 150 to 600 miles per hour. The calibrations indicated a need for a pitot-static tube with greater accuracy, especially at higher speeds. Results regarding the service tubes, Prandtl tube, Eigh-speed tube, and a comparison of the tubes are provided.
Date: July 1942
Creator: Hensley, Reece V.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Calibrations of Service Pitot Tubes in the Langley 24-Inch High-Speed Tunnel

Description: Report discusses calibration testing performed on a Kollsman type G-1 and an NAF No. 1 pitot tube at several Mach numbers and angles of attack. The effect of drain holes on the flow within the pitot tube was analyzed and the ability to estimate the error in the total pressure was created. The accuracy of the extrapolated and estimated values were found to be within reasonable limits.
Date: February 1946
Creator: Lindsey, W. F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Cascade investigation of buckets for a modern aircraft turbosupercharger

Description: Report presenting a cascade investigation in two-dimensional flow in the 5-inch cascade tunnel and the 1-inch turbine-element testing apparatus to obtain a satisfactory bucket design for use in a modern aircraft turbosupercharger. Results regarding the root sections, pitch sections, and tip sections are provided.
Date: November 1944
Creator: Kantrowitz, Arthur & Erwin, John R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Characteristics of beveled-trailing-edge elevators on a typical pursuit fuselage at altitudes simulating-normal flight and spin conditions

Description: Report presenting lift and elevator hinge-moment characteristics were measured on horizontal tail provided with elevators having three different beveled trailing edges. Results regarding fuselage alone and fuselage interference, lift characteristics of fuselage-tail combination, elevator hinge-moment characteristics, drag, and comparison with data from two-dimensional-flow tests are provided.
Date: December 1942
Creator: Gillis, Clarence L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Characteristics of Naca 4400R Series Rectangular and Tapered Airfoils, Including the Effect of Split Flaps

Description: "At the request of the Bureau of Aeronautics, Navy Department, tests were made in the variable-density wind tunnel of a tapered wing of 3-10-18 plan form and based on the NACA 4400R series sections. The wing was also tested with 0.2 chord split flaps, deflected 60 degrees, in the center of the wing and having flat span to wing span ratios of 0.3, 0.5, 0.7, and 1.0, respectively" (p. 1).
Date: January 1941
Creator: Greenberg, Harry
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Characteristics of plain and balanced elevators on a typical pursuit fuselage at attitudes simulating normal-flight and spin conditions

Description: Report presenting lift and elevator hinge-moment characteristics of a horizontal tail with various plain and balanced elevators and mounted on a typical pursuit fuselage as measured in the 7- by 10-foot wind tunnel at attitudes simulating normal-flight and spin conditions. The lift effectiveness of the elevator was practically independent of the size of the aerodynamic balance. Results regarding the fuselage alone and fuselage interference, lift characteristics of fuselage-tail combinations, li… more
Date: March 1942
Creator: Sears, Richard I. & Hoggard, H. Page, Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Characteristics of Several Single- and Dual-Rotating Propellers in Negative Thrust

Description: Report discusses the thrust and power characteristics of several single- and dual-rotating propellers with differing blade width and number of blades for negative-thrust operation from -45 degrees to 145 degrees blade angle. From Summary: "The tests indicate that it is possible to predict for a given propeller design characteristics in the negative-thrust range from known characteristics at a different activity factor. Adequate negative thrusts were indicated for extremely high positive as well… more
Date: March 1945
Creator: Gray, W. H. & Gilman, Jean, Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Characteristics of the BMW 801D2 Automatic Engine Control as Determined From Bench Tests

Description: Report discusses the results of bench testing on a German BMW 301D2 to determine the relation between the control parameters and any special methods by which the control principles are adapted to the control of the engine. Characteristics are presented for a variety of simulated manifold pressures, charge-air temperatures, engine speeds, and altitudes. Special attention is paid to the pressure characteristics of the servo-oil system and the potential effects of its failure on the operation of t… more
Date: April 1945
Creator: Scharer, M. E. & Addie, A. N.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Characteristics of Two Model Six-Blade Counterrotating Pusher Propellers of Conventional and Improved Aerodynamic Design

Description: Two airfoil plans were used for propeller blades. One is modified Clark Y section designed for structural reliability and the second an NACA 16 airfoil section designed to produce minimum aerodynamic losses. At low air speeds, the propeller designed for aerodynamic effects showed a gain of from 1.5 to 4.0 percent in propulsive efficiency over the conventional type depending on the pitch. Because of the numerous variables involved, the effect of each one on the aerodynamic characteristics of the… more
Date: June 1942
Creator: McHugh, James G. & Pepper, Edward
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for Calculation of the Critical Compressive Stress for Local Instability of Idealized Web- and T-Stiffened Panels

Description: "Charts are presented for the calculation of the critical compressive stress - the stress at which local instability occurs - for idealized web- and T-stiffened panels, and examples of the use of the charts are given" (p. 1).
Date: August 1944
Creator: Boughan, Rolla B. & Baab, George W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for calculation of the critical stress for local instability of columns with I-, Z-, channel and rectangular-tube section

Description: Report presenting charts for the calculation of the critical stress for local instability of columns with I-, Z-, channel-, and rectangular-tube sections. An experimental curve is included for use in taking into account the effect of stresses above the elastic range on 24S-T aluminum alloy elasticity.
Date: November 1943
Creator: Kroll, W. D.; Fisher, Gordon P. & Heimerl, George J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for Critical Combinations of Longitudinal and Transverse Direct Stress for Flat Rectangular Plates

Description: Report presenting the use of the energy method to derive interaction equations that define the critical combinations of longitudinal and transverse direct stress for isotropic flat rectangular plates with four different edge conditions. Charts based on the interaction equations are presented for the four cases.
Date: March 1946
Creator: Libove, Charles & Stein, Manuel
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for Determining Jet-Boundary Corrections for Complete Models in 7- by 10-Foot Closed Rectangular Wind Tunnels

Description: Report presenting calculations of numerical values of the jet-boundary corrections to the angle of attack and the induced-drag, rolling-moment, and yawing-moment coefficients for complete airplane or wing models in 7- by 10-foot closed rectangular wind tunnels. The results showed that the wing area was the most important variable, as has usually been assumed in previous calculations. When the corrections were based on wing area, the effect of most of the other variables was negligible.
Date: September 1945
Creator: Gillis, Clarence L.; Polhamus, Edward C. & Gray, Joseph L., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for Determining Propeller Efficiency

Description: Report presenting a description of a short method of estimating propeller efficiency for a given operating condition. The efficiency is determined for any design condition by evaluating separately from charts the induced losses and the profile-drag losses. The report covers single-rotating propellers of two, three, four, six, and eight blades and includes charts showing the rotational-energy loss for the given operating condition.
Date: September 1944
Creator: Crigler, John L. & Talkin, Herbert W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen