You limited your search to:

  Partner: UNT Libraries Government Documents Department
 Serial/Series Title: NACA Special Report
 Collection: National Advisory Committee for Aeronautics Collection
Suggestions for Popularizing Civil Aviation

Suggestions for Popularizing Civil Aviation

Date: January 1, 1926
Creator: unknown
Description: The public generally is taking very little interest in the progress of Civil Aviation, and the time has come to educate the public in aeronautics and to make them realize the far-reaching importance of air transport. Briefly, the whole problem resolves itself into discovering and applying means for bringing some of the many aspects and effects of civil aviation into the everyday lives of the public. The report suggests three principal groups of methods: (1) Bring aviation into daily contact with the public. (2) Bring the public into daily contact with aviation. (3) General publicity.
Contributing Partner: UNT Libraries Government Documents Department
Definition of Method of Measurement of Supporting and Control Surface Areas, Special Report

Definition of Method of Measurement of Supporting and Control Surface Areas, Special Report

Date: May 1, 1931
Creator: unknown
Description: Definitions of methods of measurements of supporting and control surface areas are presented. Methods for measuring the supporting surface, i.e., the wing area, and the control surfaces, i.e., the horizontal tail area, the vertical tail area, and the trailing control surface areas are defined. Illustrations of each of the areas are included.
Contributing Partner: UNT Libraries Government Documents Department
Estimated Effect of Ring Cowl on the Climb and Ceiling of an Airplane, Special Report

Estimated Effect of Ring Cowl on the Climb and Ceiling of an Airplane, Special Report

Date: June 1, 1931
Creator: Louden, F. A.
Description: Although the application of a ring cowl to an airplane with an air-cooled engine increases the maximum L/D and the high speed to an appreciable extent, the performance in climb and ceiling is not increased as much as one would expect without analyzing the conditions. When a ring cowl is installed on an airplane, the propeller is set at a higher pitch to allow the engine to turn its rated r.p.m. at the increased high speed. V/nD is increased and the propeller efficiency at high speed is increased slightly. The ratio of r.p.m. at climbing speed, V(sub c) , to the r.p.m. at maximum speed, V (sub m) is dependent upon the ratio of V(sub c) to V(sub m). The increase in V(sub c) for all airplane with ring cowl i s not as great as the increase in V(sub m), so that the ratio V(sub c)/V(sub m) is less than for the airplane without ring. Consequently the r.p.m. and full throttle thrust power available are less at V(sub c) for the airplane with ring cowl and in spite of the increase in L/D due to the installation of the ring, the excess thrust power available for climbing is not ...
Contributing Partner: UNT Libraries Government Documents Department
Method of Determining the Weights of the Most Important Simple Girders

Method of Determining the Weights of the Most Important Simple Girders

Date: December 1, 1931
Creator: Cassens, J.
Description: This paper presents a series of tables for the simple and more common types of girders, similar to the tables given in handbooks under the heading "Strength of Materials," for determining the moments, deflections, etc., of simple beams. Instead of the uniform cross section there assumed, the formulas given here apply only to girders of "uniform strength," i.e., it is assumed that a girder is so dimensioned that a given load subjects it to a uniform stress throughout its whole length. This principle is particularly applicable to very strong structures. Girders of uniform strength are the lightest girders conceivable, because any girder, all of whose members are stressed to the limit, can not be surpassed by a lighter girder, if the two girders have the same form. The weight G of a member of length l, cross section F and specific gravity gamma is: G = Flgamma.
Contributing Partner: UNT Libraries Government Documents Department
Statistics of the Bureau Veritas

Statistics of the Bureau Veritas

Date: March 1, 1932
Creator: Volmerange, Andre
Description: Statistics are indispensable factors for the amelioration of safety. Through the reconciliation of accidents which may appear isolated to interested parties, they permit tracking of typical causes of accidents; conversely, they can prevent, after a serious accident due to some fortuitous cause, the taking of incautious measures under the pressure of public opinion, which always inclines to gauge the gravity of the causes by that of the results. Lastly, they permit appraisal of the efficacy of rules in force. We should add that statistics provide an agency of prevention for future accidents. A careful inspection of all signs of malfunction of material quite often prevents the occurrence of an accident. In this respect, many pilot's report, perfectly normal in every way as far as operation is concerned, can reveal much more interesting technical data than an accident, although it does not diminish the importance of statistics. Therefore, from the inception of its aeronautical service, at the end of 1922, the Bureau Veritas has kept annual statistics of all accidents which occurred in French civil aviation. In order to correctly perform their proper function, the statistics must be exact and sufficiently explicit and complete. To be exact, they must bear on ...
Contributing Partner: UNT Libraries Government Documents Department
Present Status of Lateral-Control Devices for use with Split Flaps, Special Report

Present Status of Lateral-Control Devices for use with Split Flaps, Special Report

Date: August 1, 1933
Creator: Weick, Fred E.
Description: The increased use of split flaps for the dual purpose of reducing the landing speed and shortening the landing glide of airplanes has established as acute the problem of obtaining satisfactory lateral control to be used in conjunction with the flaps with out the sacrifice of any of the effectiveness of the flaps. A large amount of work is being done on this problem by various organizations and individuals. Several of the devices developed seem usable, some of them unquestionably so. The present paper attempts to summarize the most promising results obtained to date. Topics covered include ordinary ailerons, external ailerons, floating ailerons, upper-surface ailerons, and spoilers. Although the external ailerons above the trailing edge of the wing and the spoilers at the rear of the wing appear quite promising, it would seem that probably the most satisfactory immediate solution of the problem, including the obtaining of light and smoothly graduated control forces, would in most cases be obtained by the use of the arrangement in which the flap is retracted ahead of ordinary narrow-chord ailerons and is deflected to the rear as well as downward when in use.
Contributing Partner: UNT Libraries Government Documents Department
Flight Tests on the Lateral Control of an Airplane having a Split Flap which Retracts Ahead of Conventional Ailerons, Special Report

Flight Tests on the Lateral Control of an Airplane having a Split Flap which Retracts Ahead of Conventional Ailerons, Special Report

Date: December 1, 1933
Creator: Weick, Fred E.
Description: Since the recent more or less extensive adoption of high-lift flaps on airplane wings, the problem of providing satisfactory lateral control without sacrificing a part of the span of the flaps has become one of some importance. The difficulties have been largely a matter of obtaining satisfactory rolling moments with a smoothly graduated action, together with sufficiently small control forces throughout the entire speed range. As part of an investigation including several different lateral-control arrangements to be used with split flaps, the tests reported in this paper were made on one arrangement in which conventional ailerons of narrow chord are used, and a split flap is retracted into the under surface of th wing forward of th ailerons. When the flap is retracted, the arrangement is as sketched in figure 1(a). If a simple form of split flap were used, hinged at its forward edge, the appearance when deflected would be as shown in figure 1(b). The flap if deflected with its leading edge remaining in this forward position would give somewhat less than three fourths of the lift increase of the same flap in the usual rear position. (See reference 1.). If, as shown in figure 1(c), the split ...
Contributing Partner: UNT Libraries Government Documents Department
Wing-Nacelle-Propeller Tests - Comparative Tests of Liquid-Cooled and Air-Cooled Engine Nacelles

Wing-Nacelle-Propeller Tests - Comparative Tests of Liquid-Cooled and Air-Cooled Engine Nacelles

Date: January 1, 1934
Creator: Wood, Donald H.
Description: This report gives the results of measurements of the lift, drag, and propeller characteristics of several wing and nacelle combinations with a tractor propeller. The nacelles were so located that the propeller was about 31% of the wing chord directly ahead of the leading edge of the wing, a position which earlier tests (NASA Report No. 415) had shown to be efficient. The nacelles were scale models of an NACA cowled nacelle for a radial air-cooled engine, a circular nacelle with the V-type engine located inside and the radiator for the cooling liquid located inside and the radiator for the type, and a nacelle shape simulating the housing which would be used for an extension shaft if the engine were located entirely within the wing. The propeller used in all cases was a 4-foot model of Navy No. 4412 adjustable metal propeller. The results of the tests indicate that, at the angles of attack corresponding to high speeds of flight, there is no marked advantage of one type of nacelle over the others as far as low drag is concerned, since the drag added by any of the nacelles in the particular location ahead of the wing is very small. ...
Contributing Partner: UNT Libraries Government Documents Department
Resume of Present Data on Load Distribution on Slots and Flaps, Special Report

Resume of Present Data on Load Distribution on Slots and Flaps, Special Report

Date: April 1, 1934
Creator: Wenzinger, Carl J.
Description: This report covers a study of the generally available data on load distribution on slots and flaps. The study was made by the National Advisory Committee for Aeronautics at the request of the Material Division, Army Air Corps to furnish information applicable to design criteria for slots and flaps of various types. The data are presented in three main sections: slots (Handley page type), auxiliary airfoils (fixed), and flaps.
Contributing Partner: UNT Libraries Government Documents Department
Preliminary Wind-Tunnel and Flight Tests of a Balanced Split Flap, Special Report

Preliminary Wind-Tunnel and Flight Tests of a Balanced Split Flap, Special Report

Date: August 1, 1934
Creator: Weick, Fred E.
Description: One disadvantage that has been apparent in the operation of split flaps as used to date is the time and effort required to operate them. In this communication an investigation is being made of possible means for balancing them aerodynamically to make their operation easier. Several arrangements have been tested in the 7 by 210 foot wind tunnel, and the results of the wind-tunnel tests as well as preliminary flight tests on one of the more promising forms are given in this paper.
Contributing Partner: UNT Libraries Government Documents Department
FIRST PREV 1 2 3 4 5 NEXT LAST