You limited your search to:
Decade:
1930-1939
Year:
1931
Month:
June
Collection:
National Advisory Committee for Aeronautics Collection
Basic requirements of fuel-injection nozzles for quiescent combustion chambers
Date: June 1, 1931
Creator: Spanogle, J A
Description: This report presents test results obtained during an investigation of the performance of a single-cylinder, high-speed, compression-ignition test engine when using multiple-orifice fuel-injection valve nozzles in which the number and the direction of the orifices were varied independently.
Contributing Partner: UNT Libraries Government Documents Department
Permallink:digital.library.unt.edu/ark:/67531/metadc54108/
Endurance and other properties at low temperatures of some alloys for aircraft use
Date: June 1, 1931
Creator: Russell, H W
Description: The low temperature endurance properties of materials for aircraft construction are not well known. In order to determine them, apparatus for testing endurance at -40 C has been devised. The endurance properties of monel metal, low-carbon stainless steel, "18 and *, " 3 1/2% Ni steel and chromium-molybdenum steel have been determined at -40 C and at room temperature about +20 C. Tensile, impact and hardness tests of these materials have also been made at various temperatures. The results show an increase in endurance limit, tensile strength, and hardness with decreased temperature. Impact strength is, in general, decreased, but of all the alloys tested, only one, low-carbon stainless steel, gives less than 15 ft. lb. Chrpay impact test at -40 C.
Contributing Partner: UNT Libraries Government Documents Department
Permallink:digital.library.unt.edu/ark:/67531/metadc54099/
Estimated Effect of Ring Cowl on the Climb and Ceiling of an Airplane, Special Report
Date: June 1, 1931
Creator: Louden, F. A.
Description: Although the application of a ring cowl to an airplane with an air-cooled engine increases the maximum L/D and the high speed to an appreciable extent, the performance in climb and ceiling is not increased as much as one would expect without analyzing the conditions. When a ring cowl is installed on an airplane, the propeller is set at a higher pitch to allow the engine to turn its rated r.p.m. at the increased high speed. V/nD is increased and the propeller efficiency at high speed is increased slightly. The ratio of r.p.m. at climbing speed, V(sub c) , to the r.p.m. at maximum speed, V (sub m) is dependent upon the ratio of V(sub c) to V(sub m). The increase in V(sub c) for all airplane with ring cowl i s not as great as the increase in V(sub m), so that the ratio V(sub c)/V(sub m) is less than for the airplane without ring. Consequently the r.p.m. and full throttle thrust power available are less at V(sub c) for the airplane with ring cowl and in spite of the increase in L/D due to the installation of the ring, the excess thrust power available for climbing is not ...
Contributing Partner: UNT Libraries Government Documents Department
Permallink:digital.library.unt.edu/ark:/67531/metadc65147/
A suggested method for measuring turbulence
Date: June 1, 1931
Creator: Taylor, Fayette C
Description: The desirability of a quantitative measure of turbulence is emphasized, and a possible method of attack on the problem is discussed. Data are presented to show that the hot-wire anemometer has possibilities as an instrument for measuring turbulence. An apparatus consisting essentially of two hot wire, one parallel to the air flow and one at right angles to it, is suggested.
Contributing Partner: UNT Libraries Government Documents Department
Permallink:digital.library.unt.edu/ark:/67531/metadc54097/